Glass-specific behavior in the damping of acoustic-like vibrations

High frequency sound is observed in lithium diborate glass, Li$_2$O--2B$_2$O$_3$, using Brillouin scattering of light and x-rays. The sound attenuation exhibits a non-trivial dependence on the wavevector, with a remarkably rapid increase towards a Ioffe-Regel crossover as the frequency approaches the boson peak from below. An analysis of literature results reveals the near coincidence of the boson-peak frequency with a Ioffe-Regel limit for sound in {\em all} sufficiently strong glasses. We conjecture that this behavior, specific to glassy materials, must be quite universal among them.Comment: 4 pages, 4 figures, revised versio

Acoustic damping in Li2_2O-2B2_2O3_3 glass observed by inelastic x-ray and optical Brillouin scattering

The dynamic structure factor of lithium-diborate glass has been measured at several values of the momentum transfer $Q$ using high resolution inelastic x-ray scattering. Much attention has been devoted to the low $Q$-range, below the observed Ioffe-Regel crossover \qco{}$\simeq$ 2.1 nm$^{-1}$. We find that below \qco{}, the linewidth of longitudinal acoustic waves increases with a high power of either $Q$, or of the frequency $\Omega$, up to the crossover frequency \OMco{} $\simeq$ 9 meV that nearly coincides with the center of the boson peak. This new finding strongly supports the view that resonance and hybridization of acoustic waves with a distribution of rather local low frequency modes forming the boson peak is responsible for the end of acoustic branches in strong glasses. Further, we present high resolution Brillouin light-scattering data obtained at much lower frequencies on the same sample. These clearly rule out a simple $\Omega^2$-dependence of the acoustic damping over the entire frequency range.Comment: 5 pages, 5 figures, submitted to the proceedings of IDMRCS 2005, Lille, Franc

Observation of the onset of strong scattering on high frequency acoustic phonons in densified silica glass

The linewidth of longitudinal acoustic waves in densified silica glass is obtained by inelastic x-ray scattering. It increases with a high power alpha of the frequency up to a crossover where the waves experience strong scattering. We find that \alpha is at least 4, and probably larger. Resonance and hybridization of acoustic waves with the boson-peak modes seems to be a more likely explanation for these findings than Rayleigh scattering from disorder.Comment: 4 pages, 4 figures, to appear in Phys. Rev. Letter

Hyper-Raman scattering from vitreous boron oxide: coherent enhancement of the boson peak

Hyper-Raman scattering spectra of vitreous B$_2$O$_3$ are reported and compared to Raman scattering results. The main features are indexed in terms of vibrations of structural units. Particular attention is given to the low frequency boson peak which is shown to relate to out-of-plane librations of B$_3$O$_3$ boroxol rings and BO$_3$ triangles. Its hyper-Raman strength is comparable to that of cooperative polar modes. It points to a sizeable coherent enhancement of the hyper-Raman signal compared to the Raman one. This is explained by the symmetry of the structural units.Comment: 4 pages, 3 figure

Small Angle Scattering by Fractal Aggregates: A Numerical Investigation of the Crossover Between the Fractal Regime and the Porod Regime

Fractal aggregates are built on a computer using off-lattice cluster-cluster aggregation models. The aggregates are made of spherical particles of different sizes distributed according to a Gaussian-like distribution characterised by a mean $a_0$ and a standard deviation $\sigma$. The wave vector dependent scattered intensity $I(q)$ is computed in order to study the influence of the particle polydispersity on the crossover between the fractal regime and the Porod regime. It is shown that, given $a_0$, the location $q_c$ of the crossover decreases as $\sigma$ increases. The dependence of $q_c$ on $\sigma$ can be understood from the evolution of the shape of the center-to-center interparticle-distance distribution function.Comment: RevTex, 4 pages + 6 postscript figures, compressed using "uufiles", published in Phys. Rev. B 50, 1305 (1994

Scaling the Temperature-dependent Boson Peak of Vitreous Silica with the high-frequency Bulk Modulus derived from Brillouin Scattering Data

The position and strength of the boson peak in silica glass vary considerably with temperature $T$. Such variations cannot be explained solely with changes in the Debye energy. New Brillouin scattering measurements are presented which allow determining the $T$-dependence of unrelaxed acoustic velocities. Using a velocity based on the bulk modulus, scaling exponents are found which agree with the soft-potential model. The unrelaxed bulk modulus thus appears to be a good measure for the structural evolution of silica with $T$ and to set the energy scale for the soft potentials.Comment: Accepted for publication in Physical Review Letter

The Boson Peak and its Relation with Acoustic Attenuation in Glasses

Experimental results on the density of states and on the acoustic modes of glasses in the THz region are compared to the predictions of two categories of models. A recent one, solely based on an elastic instability, does not account for most observations. Good agreement without adjustable parameters is obtained with models including the existence of non-acoustic vibrational modes at THz frequency, providing in many cases a comprehensive picture for a range of glass anomalies.Comment: 4 pages, 3 figures, Physical Review Letters in pres

Band Formation during Gaseous Diffusion in Aerogels

We study experimentally how gaseous HCl and NH_3 diffuse from opposite sides of and react in silica aerogel rods with porosity of 92 % and average pore size of about 50 nm. The reaction leads to solid NH_4Cl, which is deposited in thin sheet-like structures. We present a numerical study of the phenomenon. Due to the difference in boundary conditions between this system and those usually studied, we find the sheet-like structures in the aerogel to differ significantly from older studies. The influence of random nucleation centers and inhomogeneities in the aerogel is studied numerically.Comment: 7 pages RevTex and 8 figures. Figs. 4-8 in Postscript, Figs. 1-3 on request from author

Hyper-Raman scattering analysis of the vibrations in vitreous boron oxide

Hyper-Raman scattering has been measured on vitreous boron oxide, $v-$B$_2$O$_3$. This spectroscopy, complemented with Raman scattering and infrared absorption, reveals the full set of vibrations that can be observed with light. A mode analysis is performed based on the local D$_{3h}$ symmetry of BO$_3$ triangles and B$_3$O$_3$ boroxol rings. The results show that in $v-$B$_2$O$_3$ the main spectral components can be succesfully assigned using this relatively simple model. In particular, it can be shown that the hyper-Raman boson peak arises from external modes that correspond mainly to librational motions of rigid boroxol rings.Comment: 13 pages, 11 figures, 2 table

Assessment of digital image correlation measurement errors: methodology and results

Optical full-field measurement methods such as Digital Image Correlation (DIC) are increasingly used in the field of experimental mechanics, but they still suffer from a lack of information about their metrological performances. To assess the performance of DIC techniques and give some practical rules for users, a collaborative work has been carried out by the Workgroup “Metrology” of the French CNRS research network 2519 “MCIMS (Mesures de Champs et Identification en Mécanique des Solides / Full-field measurement and identification in solid mechanics, http://www.ifma.fr/lami/gdr2519)”. A methodology is proposed to assess the metrological performances of the image processing algorithms that constitute their main component, the knowledge of which being required for a global assessment of the whole measurement system. The study is based on displacement error assessment from synthetic speckle images. Series of synthetic reference and deformed images with random patterns have been generated, assuming a sinusoidal displacement field with various frequencies and amplitudes. Displacements are evaluated by several DIC packages based on various formulations and used in the French community. Evaluated displacements are compared with the exact imposed values and errors are statistically analyzed. Results show general trends rather independent of the implementations but strongly correlated with the assumptions of the underlying algorithms. Various error regimes are identified, for which the dependence of the uncertainty with the parameters of the algorithms, such as subset size, gray level interpolation or shape functions, is discussed