13,287 research outputs found
A Green's function approach to the natural vibration of thin spherical shell segments - A numerical method Final report
Green function approach to natural vibration of thin spherical shell segment
Development of processing procedures for advanced silicon solar cells
Ten ohm-cm silicon solar cells, 0.2 mm thick, were produced with short circuit current efficiencies up to thirteen percent and using a combination of recent technical advances. The cells were fabricated in conventional and wraparound contact configurations. Improvement in cell collection efficiency from both the short and long wavelengths region of the solar spectrum was obtained by coupling a shallow junction and an optically transparent antireflection coating with back surface field technology. Both boron diffusion and aluminum alloying techniques were evaluated for forming back surface field cells. The latter method is less complicated and is compatible with wraparound cell processing
Design and fabrication of wraparound contact silicon solar cells
Both dielectric insulation and etched junction contact techniques were evaluated for use in wraparound contact cell fabrication. Since a suitable process for depositing the dielectrics was not achieved, the latter approach was taken. The relationship between loss of back contact and power degradation due to increased series resistance was established and used to design a simple contact configuration for 10 ohm-cm etched wraparound junction contact N/P cells. A slightly deeper junction significantly improved cell curve shape and the associated loss of current was regained by using thinner contact grid fingers. One thousand cells with efficiencies greater than 10.5% were fabricated to demonstrate the process
The effects of electron and proton radiation on GaSb infrared solar cells
Gallium antimonide (GaSb) infrared solar cells were exposed to 1 MeV electrons and protons up to fluences of 1 times 10(exp 15) cm (-2) and 1 times 10(exp 12) cm (-2) respectively. In between exposures, current voltage and spectral response curves were taken. The GaSb cells were found to degrade slightly less than typical GaAs cells under electron irradiation, and calculations from spectral response curves showed that the damage coefficient for the minority carrier diffusion length was 3.5 times 10(exp 8). The cells degraded faster than GaAs cells under proton irradiation. However, researchers expect the top cell and coverglass to protect the GaSb cell from most damaging protons. Some annealing of proton damage was observed at low temperatures (80 to 160 C)
Tandem concentrator solar cells with 30 percent (AMO) power conversion efficiency
Very high efficiency concentrator solar panels are envisioned as economical and reliable electrical power subsystems for space based platforms of the future. GaAs concentrator cells with very high efficiencies and good sub-bandgap transmissions can be fabricated on standard wafers. GaSb booster cell development is progressing very well; performance characteristics are still improving dramatically. Consistent GaAs/GaSb stacked cell AMO efficiencies greater than 30 percent are expected
Virtual Data in CMS Analysis
The use of virtual data for enhancing the collaboration between large groups
of scientists is explored in several ways:
- by defining ``virtual'' parameter spaces which can be searched and shared
in an organized way by a collaboration of scientists in the course of their
analysis;
- by providing a mechanism to log the provenance of results and the ability
to trace them back to the various stages in the analysis of real or simulated
data;
- by creating ``check points'' in the course of an analysis to permit
collaborators to explore their own analysis branches by refining selections,
improving the signal to background ratio, varying the estimation of parameters,
etc.;
- by facilitating the audit of an analysis and the reproduction of its
results by a different group, or in a peer review context.
We describe a prototype for the analysis of data from the CMS experiment
based on the virtual data system Chimera and the object-oriented data analysis
framework ROOT. The Chimera system is used to chain together several steps in
the analysis process including the Monte Carlo generation of data, the
simulation of detector response, the reconstruction of physics objects and
their subsequent analysis, histogramming and visualization using the ROOT
framework.Comment: Talk from the 2003 Computing in High Energy and Nuclear Physics
(CHEP03), La Jolla, Ca, USA, March 2003, 9 pages, LaTeX, 7 eps figures. PSN
TUAT010. V2 - references adde
Global Measurements of Optically Thin Ice Clouds Using CALIOP
Optically thin ice clouds have been shown to have a net warming effect on the globe but, because passive instruments are not sensitive to optically thin clouds, the occurrence frequency of this class of clouds is greatly underestimated in historical passive sensor cloud climatology. One major strength of CALIOP (Cloud-Aerosol Lidar with Orthogonal Polarization), onboard the CALIPSO (Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observations) spacecraft, is its ability to detect these thin clouds, thus filling an important missing piece in the historical data record. This poster examines the full mission of CALIPSO Level 2 data, focusing on those CALIOP retrievals identified as thin ice clouds according to the definition shown to the right. Using this definition, thin ice clouds are identified and counted globally and vertically for each season. By examining the spatial and seasonal distributions of these thin clouds we hope to gain a better understanding these thin ice clouds and how their global distribution has changed over the mission. This poster showcases when and where CALIOP detects thin ice clouds and examines a case study of the eastern pacific and the effects seen from the El Nino-Southern Oscillation (ENSO)
Hyperspherical Description of the Degenerate Fermi Gas: S-wave Interactions
We present a unique theoretical description of the physics of the spherically
trapped -atom degenerate Fermi gas (DFG) at zero temperature based on an
ordinary Schr\"{o}dinger equation with a microscopic, two body interaction
potential. With a careful choice of coordinates and a variational wavefunction,
the many body Schr\"{o}dinger equation can be accurately described by a
\emph{linear}, one dimensional effective Schr\"{o}dinger equation in a single
collective coordinate, the rms radius of the gas. Comparisons of the energy,
rms radius and peak density of ground state energy are made to those predicted
by Hartree-Fock (HF). Also the lowest radial excitation frequency (the
breathing mode frequency) agrees with a sum rule calculation, but deviates from
a HF prediction
Shape sensing of variable stiffness soft robots using electrical impedance tomography
Soft robotic systems offer benefits over traditional rigid systems through reduced contact trauma with soft tissues and by enabling access through tortuous paths in minimally invasive surgery. However, the inherent deformability of soft robots places both a greater onus on accurate modelling of their shape, and greater challenges in realising intraoperative shape sensing. Herein we present a proprioceptive (self-sensing) soft actuator, with an electrically conductive working fluid. Electrical impedance measurements from up to six electrodes enabled tomographic reconstructions using Electrical Impedance Tomography (EIT). A new Frequency Division Multiplexed (FDM) EIT system was developed capable of measurements of 66 dB SNR with 20 ms temporal resolution. The concept was examined in two two-degree-of-freedom designs: a hydraulic hinged actuator and a pneumatic finger actuator with hydraulic beams. Both cases demonstrated that impedance measurements could be used to infer shape changes, and EIT images reconstructed during actuation showed distinct patterns with respect to each degree of freedom (DOF). Whilst there was some mechanical hysteresis observed, the repeatability of the measurements and resultant images was high. The results show the potential of FDM-EIT as a low-cost, low profile shape sensor in soft robots
- …