6,025 research outputs found
Apparatus for applying simulator g-forces to an arm of an aircraft simulator pilot
A device to be used with an aircraft simulator to apply positive and negative g forces to the pilot's arm is described. An arm harness fits around the arm which the pilot uses to operate the throttle. The device allows the harness to track intentional arm movements without exerting any restraining forces, and at the same time, applies g forces to to the pilots arm which are recorded by the aircraft simulator computer
GAELS Project Final Report: Information environment for engineering
The GAELS project was a collaboration commenced in 1999 between Glasgow University Library and Strathclyde University Library with two main aims:· to develop collaborative information services in support of engineering research at the Universities of Glasgow and Strathclyde· to develop a CAL (computer-aided learning package) package in advanced information skills for engineering research students and staff The project was funded by the Scottish Higher Education Funding Council (SHEFC) from their Strategic Change Initiative funding stream, and funding was awarded initially for one year, with an extension of the grant for a further year. The project ended in June 2001.The funding from SHEFC paid for two research assistants, one based at Glasgow University Library working on collaborative information services and one based at Strathclyde University Library developing courseware. Latterly, after these two research assistants left to take up other posts, there has been a single researcher based at Glasgow University Library.The project was funded to investigate the feasibility of new services to the Engineering Faculties at both Universities, with a view to making recommendations for service provision that can be developed for other subject areas
Stabilization and precise calibration of a continuous-wave difference frequency spectrometer by use of a simple transfer cavity
A novel, simple, and inexpensive calibration scheme for a continuous-wave difference frequency spectrometer is presented, based on the stabilization of an open transfer cavity by locking onto the output of a polarization stabilized HeNe laser. High frequency, acoustic fluctuations of the transfer cavity length are compensated with a piezoelectric transducer mounted mirror, while long term drift in cavity length is controlled by thermal feedback. A single mode Ar+ laser, used with a single mode ring dye laser in the difference frequency generation of 2–4 µm light, is then locked onto a suitable fringe of this stable cavity, achieving a very small long term drift and furthermore reducing the free running Ar+ linewidth to about 1 MHz. The dye laser scan provides tunability in the difference frequency mixing process, and is calibrated by marker fringes with the same stable cavity. Due to the absolute stability of the marker cavity, precise frequency determination of near infrared molecular transitions is achieved via interpolation between these marker fringes. It is shown theoretically that the residual error of this scheme due to the dispersion of air in the transfer cavity is quite small, and experimentally that a frequency precision on the order of 1 MHz per hour is routinely obtained with respect to molecular transitions. Review of Scientific Instruments is copyrighted by The American Institute of Physics
Hemispheric processing of memory is affected by sleep
The file attached to this record is the author's final peer reviewed version. The Publisher's final version can be found by following the DOI link.Sleep is known to affect learning and memory, but the extent to which it influences behavioural processing in the left and right hemispheres of the brain is as yet unknown. We tested two hypotheses about lateralised effects of sleep on recognition memory for words: whether sleep reactivated recent experiences of words promoting access to the long-term store in the left hemisphere (LH), and whether sleep enhanced spreading activation differentially in semantic networks in the hemispheres. In Experiment 1, participants viewed lists of semantically related words, then slept or stayed awake for 12 h before being tested on seen, unseen but related, or unrelated words presented to the left or the right hemisphere. Sleep was found to promote word recognition in the LH, and to spread activation equally within semantic networks in both hemispheres. Experiment 2 ensured that the results were not due to time of day effects influencing cognitive performance
A PARTIAL EQUILIBRIUM MODEL OF THE LINKAGES BETWEEN ANIMAL WELFARE, TRADE AND THE ENVIRONMENT IN SCOTLAND
This research analyses the impacts of a scientific advance that improves animal welfare, upon the environment and trade in Scotland using partial equilibrium (PE) modelling. The science improves pig neonatal survival through improved (high fibre) sow diets used before mating. Our model simulates the effects of animal welfare changes on the pig production systems (pig meat) and further on trade flows (trade in pig meat) and environment (water and air pollution). We consider two animal welfare simulation scenarios, namely the status quo – no animal welfare change as regards pig neonatal mortality (baseline scenario) and the case of improving pig neonatal survival (alternative scenario) and compare the impacts on trade and environment between the two scenarios during the simulation horizon 2008-2015. The results show that the increase in animal welfare has a lower impact on the environment in the alternative scenario compared to the baseline scenario (by about 6% at the end of the simulation horizon) and a positive impact on net trade in the alternative scenario compared to the baseline scenario (by about 13% at the end of the simulation horizon).Pig Welfare, Trade, Environment, Scotland, Partial Equilibrium Model., Agricultural and Food Policy, Environmental Economics and Policy, Research Methods/ Statistical Methods, Q18, Q50,
Recommended from our members
A complex situation in data recovery
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The research considers an unusual situation in data recovery. Data recovery is the process of recovering data from recording media that is not accessible by normal means. Providing that the data has not been overwritten or the recording medium physically damaged, this is usually a
relatively simple process of either repairing the file system so that the file(s) may be accessed as usual or finding the data on the medium and copying it directly from the medium into normal file(s). The data in this recovery situation is recorded by specialist call centre recording equipment and is stored on the recording medium in a proprietary format whereby simultaneous conversations are multiplexed together and can only be accessed by using associated metadata records. The value of the recorded data may be very high especially in the financial sector where
it may be considered a legal audit of business transactions. When a failure occurs and data needs to be recovered, both the data and metadata information must be recreated before a single call can be replayed. A key component to accessing this information is the location metadata that
identifies the location of the required components on the medium. If the metadata is corrupted, incomplete or wrong then a repair cannot proceed until it is corrected. This research focuses on the problem of verifying this location metadata. Initially it was believed that only a small set of errors would exist and work centred on detecting these errors by presenting the information to engineers in an at-a-glance image. When the extent of the possible errors was realised, an attempt was made to deduce location metadata by exploring the content
of the recorded medium. Although successful in one instance, the process was not able to
distinguish between current and previous uses. Eventually insights gained from exploration of the recording application's source code, permitted an intelligent trial and error process which deduced the underlying medium apportioning formula. It was then possible to incorporate this
formula into the heuristics, generating the at-a-glance image, to create an artefact that could verify the location metadata for any given repair. After discovering the formula, the research returned to the media exploration and the produced disk fingerprinting technique. The disk fingerprinting technique gave valuable insights into error states in call centre recording and provided a new way of seeing the contents of a hard drive. This research provided the following contributions:
1. It has provided a means by which the recording systems' location metadata can be
verified and repaired.
2. As a result of this verification, greater automation of the recovery process is now possible before the need for human verification is required.
3. The disk fingerprinting process. This has already given insights into the recording
system's problems and is able to provide a new way of seeing the contents of recording
media
Swords into Ploughshares: Defence Heritage Tourism as the Peaceful Uses of the Artefacts of War
Historic heritage has proved to be one of international tourism\u27s most important primary resources. Such heritage contains an inevitable ideological component. The artefacts and place associations of war are one set of such resources which exercise a growing fascination and attraction for tourist visits. This defence heritage tourism may in practice be a vehicle for a variety of ideological ideas, including, despite the seeming contradiction, international peace and understanding. The distinctive characteristics of the resource, the variety of visitor motives, and the dominant ideologies in presentation will be examined, using North-West European examples. This in turn may lead to the design of policies to use tourism as an instrument for the harnessing of the long history of human conflict as a force for international understanding
- …