High consistency enzymatic pretreatment of eucalyptus and softwood kraft fibres for regenerated fibre products

Sustainability of regenerated cellulosic fibres could be improved by using paper grade pulp instead of dissolving pulp as a raw material in the fibre spinning process. However, the use of paper grade pulp calls for adjustment of the molar mass distribution (MMD) prior to dissolution to obtain good solubility and spinnability. The objective of this work was to adjust MMD of softwood and eucalyptus kraft pulps by enzymatic treatments at high pulp consistency. The reduction of the MMD of eucalyptus kraft pulp was found to require a nearly 30-fold higher dose of endoglucanase compared to the treatment of softwood pulp. Interestingly, when xylanase was used in combination with endoglucanase to treat eucalyptus kraft pulp, 27% of the xylan was dissolved and the required endoglucanase dose could be decreased from 0.57 to 0.06 mg/g. The endoglucanase dose could be further decreased to 0.028 mg/g when 67% of xylan was removed chemically before the enzymatic treatment. This suggests that xylan hinders endoglucanase action on eucalyptus kraft pulp. For softwood pulp, the addition of xylanase and mannanase had only a minor impact on the treatment efficiency. The different processabilities of softwood and eucalyptus kraft pulps are suggested to originate from the deviating cellulose accessibility which is affected by the fibre structures as well as their hemicellulose composition and localisation. The effect of the treatment consistency was further studied with softwood kraft pulp. Treatment at high consistency clearly enhanced the endoglucanase action whereas the effect of solid content on the hemicellulase action was modest.</p

A cautionary note on thermal runaway reactions in mixtures of 1-alkyl-3-methylimidazolium ionic liquids and N-methylmorpholine-N-oxide

Nicht verfügbarN-Methylmorpholine-N-oxide (NMMO) cannot be completely separated by extraction from mixtures with common 1,3-dialkylimidazolium ionic liquids (ILs) due to strong ionic interactions between the two components. At elevated temperatures, above approx. 90 C, especially under dry conditions and in the presence of acid, alkylating or acylating agents, remaining NMMO in ILs tends to undergo autocatalytic degradation. This is a highly exothermic, unstoppable process that results in explosions, flames, and complete charring of the reaction mixtures. Thus, caution must be exercised when drying or heating ILs that were in previous contact with NMMO, and the absence of amine oxide must be confirmed to avoid potential danger.(VLID)192930

Exploring Alkyl-O-Alkyl Ether Structures in Softwood Milled Wood Lignins

Recent studies have suggested that there are significant amounts of various alkyl ether (Alk-O-Alk; Alk = alkyl) moieties in a spruce native lignin preparation, milled wood lignin (SMWL). However, the comprehensive NMR assignment to these moieties has not been addressed yet. This study focused on investigating different types of Alk-O-Alk structures at the alpha-and gamma-positions of the lignin side chain in an heteronuclear single-quantum coherence (HSQC) spectrum of SMWL using experimental NMR data of lignin and synthesized model compounds. Ambiguous structural features were predicted by computer simulation of 1H and 13C NMR spectra to complement the experimental NMR data. As a result, specific regions in the HSQC spectrum were attributed to different Alk-O-Alk moieties of Alk-O-Alk/beta-O-4 and Alk-O-Alk/beta-beta ' structures. However, the differences between the specific regions were rather subtle; they were not well separated from each other and some major lignin moieties. Furthermore, SMWL contained a large variety of Alk-O-Alk moieties but in minute individual amounts, resulting in rather broad, superimposing resonances. Thus, evaluation did not allow assigning individual types of Alk-O-Alk moieties from the HSQC spectra; instead, they were quantified as total (alpha-and gamma-linked) Alk-O-Alk based on the balance of structural units in the 13C NMR spectra. At last, potential formation mechanisms of various Alk-O-Alk ether structures in lignin biosynthesis, lignin aging, and during ball milling of wood were and discussed.Peer reviewe

Reaction pathways during oxidation of cereal β-glucans

Oxidation of cereal beta-glucans may affect their stability in food products. Generally, polysaccharides oxidise via different pathways leading to chain cleavage or formation of oxidised groups within the polymer chain. In this study, oxidation pathways of oat and barley beta-glucans were assessed with different concentrations of hydrogen peroxide (H2O2) or ascorbic acid (Asc) with ferrous iron (Fe2+) as a catalyst. Degradation of beta-glucans was evaluated using high performance size exclusion chromatography and formation of carbonyl groups using carbazole-9-carbonyloxyamine labelling. Furthermore, oxidative degradation of glucosyl residues was studied. Based on the results, the oxidation with Asc mainly resulted in glycosidic bond cleavage. With H2O2, both glycosidic bond cleavage and formation of carbonyl groups within the beta-glucan chain was found. Moreover, H2O2 oxidation led to production of formic acid, which was proposed to result from Ruff degradation where oxidised glucose (gluconic acid) is decarboxylated to form arabinose. (C) 2016 Elsevier Ltd. All rights reserved.Peer reviewe

Unique reactivity of nanoporous cellulosic materials mediated by surface-confined water

The remarkable efficiency of chemical reactions is the result of biological evolution, often involving confined water. Meanwhile, developments of bio-inspired systems, which exploit the potential of such water, have been so far rather complex and cumbersome. Here we show that surface-confined water, inherently present in widely abundant and renewable cellulosic fibres can be utilised as nanomedium to endow a singular chemical reactivity. Compared to surface acetylation in the dry state, confined water increases the reaction rate and efficiency by 8 times and 30%, respectively. Moreover, confined water enables control over chemical accessibility of selected hydroxyl groups through the extent of hydration, allowing regioselective reactions, a major challenge in cellulose modification. The reactions mediated by surface-confined water are sustainable and largely outperform those occurring in organic solvents in terms of efficiency and environmental compatibility. Our results demonstrate the unexploited potential of water bound to cellulosic nanostructures in surface esterifications, which can be extended to a wide range of other nanoporous polymeric structures and reactions. The efficiency of chemical reactions in biological systems is often connected to the properties of confined water, but the developments and applications of artificial mimicking systems are impeded by the complexity of the biological systems. Here, the authors show how surface bound water in nanoporous cellulosic fibers can increase the reaction rate of surface acetylation reactions and enable regioselectivity of the reactionPeer reviewe

Colloidal features of softwood galactoglucomannans-rich extract

Development of a sustainable bioeconomy requires valorization of renewable resources, such as wood hemicelluloses. The intra- and inter-molecular associations of hemicelluloses within themselves or with other wood components can result in complex macromolecular features. These features exhibit functionality as hydrocolloids, however macromolecular characterization of these heterogeneous materials are challenging using conventional techniques such as size-exclusion chromatography. We studied galactoglucomannans (GGM) -rich softwood extracts at two grades of purity—as crude extract and after ethanol-precipitation. Asymmetrical flow field-flow fractionation (AF4) was optimized and utilized to fractionate size classes in GGM extracts, and subsequent characterization was performed with light scattering and microscopy techniques. Both GGM extracts contained polysaccharides of around 10,000 g/mol molar mass, and colloidal assemblies and/or particles in sub-micron size range. The optimized AF4 method facilitates the characterization of complex biomass-derived carbohydrates without pre-fractionation, and provides valuable understanding of their unique macromolecular features for their future application in food, pharmaceuticals, and cosmetics.Peer reviewe

Infrared and Raman spectra of lignin substructures : Dibenzodioxocin

Vibrational spectroscopy is a very suitable tool for investigating the plant cell wall in situ with almost no sample preparation. The structural information of all different constituents is contained in a single spectrum. Interpretation therefore heavily relies on reference spectra and understanding of the vibrational behavior of the components under study. For the first time, we show infrared (IR) and Raman spectra of dibenzodioxocin (DBDO), an important lignin substructure. A detailed vibrational assignment of the molecule, based on quantum chemical computations, is given in the Supporting Information; the main results are found in the paper. Furthermore, we show IR and Raman spectra of synthetic guaiacyl lignin (dehydrogenation polymer-G-DHP). Raman spectra of DBDO and G-DHP both differ with respect to the excitation wavelength and therefore reveal different features of the substructure/polymer. This study confirms the idea previously put forward that Raman at 532 nm selectively probes end groups of lignin, whereas Raman at 785 nm and IR seem to represent the majority of lignin substructures.Peer reviewe

Precipitation of Hemicelluloses from DMSO/Water Mixtures Using Carbon Dioxide as an Antisolvent

Supercritical antisolvent precipitation is a relatively recent technology which can be used for controlled preparation of polymer particles from solutions. This is done by the addition of an antisolvent to a polymer solution causing supersaturation of the polymer, especially under supercritical conditions. The particle size of the precipitates can be adjusted mainly by the rate of supersaturation. Spherical xylan or mannan particles having a narrow particle size distribution were precipitated from hemicellulose solutions in dimethyl-sulfoxide (DMSO) or DMSO/water mixtures by carbon dioxide as an antisolvent. By depending on the type of hemicellulose, the DMSO/H2O ratio, and the precipitation conditions such as pressure and temperature, the resulting particle size can be adjusted within a wide range from less than 0.1 to more than 5 m. Nano- and microstructured native xylans and mannans as obtained can be used in many applications such as encapsulation of active compounds, slow release agents, or chromatographic separation materials