10 research outputs found
Comparative Investigation of Structural and Optical Properties of Si-Rich Oxide Films Fabricated by Magnetron Sputtering
International audienceRF magnetron sputtering of two separate silicon and oxide (SiO2 or Al2O3) targets in pureargon plasma was used for deposition of Six(SiO2)1-x and Six(Al2O3)1-x films with x=0.15-0.7 onlong fused quarts substrate. The effect of post-fabrication treatments on structural and light emittingproperties of the films with different x values was investigated by means of Raman scattering,electron paramagnetic resonance and X-ray diffraction as well as by photoluminescence (PL)methods. The formation of amorphous Si clusters upon deposition process was found for the bothtypes of films. The annealing treatment at 1150°C during 30 min results in formation of Sinanocrystallites (Si-ncs). The latter were found to be larger in Six(Al2O3)1-x films than that inSix(SiO2)1-x counterparts with the same x values and are under tensile stresses. The investigation ofphotoluminescence properties of annealed films of both types revealed the appearance of visiblenearinfrared light emission. The Six(SiO2)1-x films demonstrated one broad PL band which peakposition shifts gradually to from 1.4 eV to 1.8 eV with the x decrease. Contrary to this, for theSix(Al2O3)1-x films two overlapped PL bands were observed in the 1.4-2.4 eV spectral range withpeak positions at ~2.1 eV and ~1.7 eV accompanied by near-infrared tail. Comparative analysis ofPL spectra of both types’ samples showed that the main contribution to PL spectra of Six(SiO2)1-xfilms is given by exciton recombination in the Si-ncs whereas PL emission of Six(Al2O3)1-x films iscaused mainly by carrier recombination either via defects in matrix or via electron states at the Sincs/matrix interface
Electron Accumulation Tuning by Surface-to-Volume Scaling of Nanostructured InN Grown on GaN(001) for Narrow-Bandgap Optoelectronics
The existence of an uncontrolled electron accumulation
layer near
the surface of InN thin films is an obstacle for the development of
reliable InN-based devices for use in narrow-bandgap optoelectronics.
In this article, we show that this can be regulated by modulating
the surface of the InN grown on GaN(001). By increasing the surface-to-volume
ratio, we can demonstrate a reduction in the surface carrier concentration
from ∼1018 to ∼1017 cm–3. These controlled changes are despite the idea that donor-type surface
states, which contribute to conduction band electrons are reported
to be the main origin of the surface charge density. Additionally,
by evaluating the surface carrier concentration through modeling of
photoluminescence (PL) spectroscopy, we have found a failure of the
Burstein–Moss theory. Conversely, modeling of the longitudinal
optical phonon–plasmon coupled modes measured using Raman spectroscopy,
simulations of InN structures using the k·p method, and Hall effect measurements, where possible,
showed an excellent correlation of the surface electron concentrations.
The large inhomogeneous broadening in the PL, which overwhelms any
broadening due to the Burstein–Moss effect, is understood to
be the result of varying Stark shifts due to varying strain throughout
high surface-to-volume nanostructures, which dramatically affects
the spatially indirect nature of the electron–hole recombination.
Finally, our findings demonstrate how the electron population of 2D
and 3D InN nanostructures can be tuned by structural features, such
as porosity and/or the surface-to-volume ratio
Electron Accumulation Tuning by Surface-to-Volume Scaling of Nanostructured InN Grown on GaN(001) for Narrow-Bandgap Optoelectronics
The existence of an uncontrolled electron accumulation
layer near
the surface of InN thin films is an obstacle for the development of
reliable InN-based devices for use in narrow-bandgap optoelectronics.
In this article, we show that this can be regulated by modulating
the surface of the InN grown on GaN(001). By increasing the surface-to-volume
ratio, we can demonstrate a reduction in the surface carrier concentration
from ∼1018 to ∼1017 cm–3. These controlled changes are despite the idea that donor-type surface
states, which contribute to conduction band electrons are reported
to be the main origin of the surface charge density. Additionally,
by evaluating the surface carrier concentration through modeling of
photoluminescence (PL) spectroscopy, we have found a failure of the
Burstein–Moss theory. Conversely, modeling of the longitudinal
optical phonon–plasmon coupled modes measured using Raman spectroscopy,
simulations of InN structures using the k·p method, and Hall effect measurements, where possible,
showed an excellent correlation of the surface electron concentrations.
The large inhomogeneous broadening in the PL, which overwhelms any
broadening due to the Burstein–Moss effect, is understood to
be the result of varying Stark shifts due to varying strain throughout
high surface-to-volume nanostructures, which dramatically affects
the spatially indirect nature of the electron–hole recombination.
Finally, our findings demonstrate how the electron population of 2D
and 3D InN nanostructures can be tuned by structural features, such
as porosity and/or the surface-to-volume ratio