Application of boundary integral equations to elastoplastic problems

The application of boundary integral equations to elastoplastic problems is reviewed. Details of the analysis as applied to torsion problems and to plane problems is discussed. Results are presented for the elastoplastic torsion of a square cross section bar and for the plane problem of notched beams. A comparison of different formulations as well as comparisons with experimental results are presented

Spatial bias correction for sporadic meteors photographed in New Mexico

Spatial bias correction for sporadic meteors photographed in New Mexic

Sound radiation from a high speed axial flow fan due to the inlet turbulence quadrupole interaction

A formula is obtained for the total acoustic power spectra radiated out the front of the fan as a function of frequency. The formula involves the design parameters of the fan as well as the statistical properties of the incident turbulence. Numerical results are calculated for values of the parameters in the range of interest for quiet fans tested at the Lewis Research Center. As in the dipole analysis, when the turbulence correlation lengths become equal to the interblade spacing, the predicted spectra exhibit peaks around the blade passing frequency and its harmonics. There has recently been considerable conjecture about whether the stretching of turbulent eddies as they enter a stationary fan could result in the inlet turbulence being the dominant source of pure tones from nontranslating fans. The results of the current analysis show that, unless the turbulent eddies become quite elongated, this noise source contributes predominantly to the broadband spectrum

Leaf-wise intersections and Rabinowitz Floer homology

In this article we explain how critical points of a particular perturbation of the Rabinowitz action functional give rise to leaf-wise intersection points in hypersurfaces of restricted contact type. This is used to derive existence and multiplicity results for leaf-wise intersection points in hypersurfaces of restricted contact type in general exact symplectic manifolds. The notion of leaf-wise intersection points was introduced by Moser.Comment: 18 pages, 1 figure; v3: completely rewritten, improved result

Application of boundary integral method to elastoplastic analysis of V-notched beams

The boundary integral equation method was applied in the solution of the plane elastoplastic problem. The use of this method was illustrated by obtaining stress and strain distributions for a number of specimens with a single-edge notch and subjected to pure bending. The boundary integral equation method reduced the inhomogeneous biharmonic equation to two coupled Fredholm-type integral equations. These integral equations were replaced by a system of simultaneous algebraic equations and solved numerically in conjunction with a method of successive elastic solutions

Coulomb correlation in presence of spin-orbit coupling: application to plutonium

Attempts to go beyond the local density approximation (LDA) of Density Functional Theory (DFT) have been increasingly based on the incorporation of more realistic Coulomb interactions. In their earliest implementations, methods like LDA+$U$, LDA + DMFT (Dynamical Mean Field Theory), and LDA+Gutzwiller used a simple model interaction $U$. In this article we generalize the solution of the full Coulomb matrix involving $F^{(0)}$ to $F^{(6)}$ parameters, which is usually presented in terms of an $\ell m_\ell$ basis, into a $jm_{j}$ basis of the total angular momentum, where we also include spin-orbit coupling; this type of theory is needed for a reliable description of $f$-state elements like plutonium, which we use as an example of our theory. Close attention will be paid to spin-flip terms, which are important in multiplet theory but that have been usually neglected in these kinds of studies. We find that, in a density-density approximation, the $jm_j$ basis results provide a very good approximation to the full Coulomb matrix result, in contrast to the much less accurate results for the more conventional $\ell m_\ell$ basis

Patterns of motorcycle helmet use – a naturalistic observation study in Myanmar

Developing countries are subject to increased motorization, particularly in the number of motorcycles. As helmet use is critical to the safety of motorcycle riders, the goal of this study was to identify observable patterns of helmet use, which allow a more accurate assessment of helmet use in developing countries. In a video based observation study, 124,784 motorcycle riders were observed at seven observation sites throughout Myanmar. Recorded videos were coded for helmet use, number of riders on the motorcycle, rider position, gender, and time of day. Generally, motorcycle helmet use in Myanmar was found to be low with only 51.5% percent of riders wearing a helmet. Helmet use was highest for drivers (68.1%) and decreased for every additional passenger. It was lowest for children standing on the floorboard of the motorcycle (11.3%). During the day, helmet use followed a unimodal distribution, with the highest use observed during the late morning and lowest use observed in the early morning and late afternoon. Helmet use varied significantly between observation sites, ranging from 74.8% in Mandalay to 26.9% in Pakokku. In Mandalay, female riders had a higher helmet use than male riders, and helmet use decreased drastically on a national holiday in the city. Helmet use of motorcycle riders in Myanmar follows distinct patterns. Knowledge of these patterns can be used to design more precise helmet use evaluations and guide traffic law policy and police enforcement measures. Video based observation proved to be an efficient tool to collect helmet use data

Online Makespan Minimization with Parallel Schedules

In online makespan minimization a sequence of jobs $\sigma = J_1,..., J_n$ has to be scheduled on $m$ identical parallel machines so as to minimize the maximum completion time of any job. We investigate the problem with an essentially new model of resource augmentation. Here, an online algorithm is allowed to build several schedules in parallel while processing $\sigma$. At the end of the scheduling process the best schedule is selected. This model can be viewed as providing an online algorithm with extra space, which is invested to maintain multiple solutions. The setting is of particular interest in parallel processing environments where each processor can maintain a single or a small set of solutions. We develop a (4/3+\eps)-competitive algorithm, for any 0<\eps\leq 1, that uses a number of 1/\eps^{O(\log (1/\eps))} schedules. We also give a (1+\eps)-competitive algorithm, for any 0<\eps\leq 1, that builds a polynomial number of (m/\eps)^{O(\log (1/\eps) / \eps)} schedules. This value depends on $m$ but is independent of the input $\sigma$. The performance guarantees are nearly best possible. We show that any algorithm that achieves a competitiveness smaller than 4/3 must construct $\Omega(m)$ schedules. Our algorithms make use of novel guessing schemes that (1) predict the optimum makespan of a job sequence $\sigma$ to within a factor of 1+\eps and (2) guess the job processing times and their frequencies in $\sigma$. In (2) we have to sparsify the universe of all guesses so as to reduce the number of schedules to a constant. The competitive ratios achieved using parallel schedules are considerably smaller than those in the standard problem without resource augmentation

The Role of Nonlinear Dynamics in Quantitative Atomic Force Microscopy

Various methods of force measurement with the Atomic Force Microscope (AFM) are compared for their ability to accurately determine the tip-surface force from analysis of the nonlinear cantilever motion. It is explained how intermodulation, or the frequency mixing of multiple drive tones by the nonlinear tip-surface force, can be used to concentrate the nonlinear motion in a narrow band of frequency near the cantilevers fundamental resonance, where accuracy and sensitivity of force measurement are greatest. Two different methods for reconstructing tip-surface forces from intermodulation spectra are explained. The reconstruction of both conservative and dissipative tip-surface interactions from intermodulation spectra are demonstrated on simulated data.Comment: 25 pages (preprint, double space) 7 figure