Durability of Mortar Incorporating Ferronickel Slag Aggregate and Supplementary Cementitious Materials Subjected to Wet–Dry Cycles

This paper presents the strength and durability of cement mortars using 0–100% ferronickel slag (FNS) as replacement of natural sand and 30% fly ash or ground granulated blast furnace slag (GGBFS) as cement replacement. The maximum mortar compressive strength was achieved with 50% sand replacement by FNS. Durability was evaluated by the changes in compressive strength and mass of mortar specimens after 28 cycles of alternate wetting at 23 °C and drying at 110 °C. Strength loss increased by the increase of FNS content with marginal increases in the mass loss. Though a maximum strength loss of up to 26% was observed, the values were only 3–9% for 25–100% FNS contents in the mixtures containing 30% fly ash. The XRD data showed that the pozzolanic reaction of fly ash helped to reduce the strength loss caused by wet–dry cycles. Overall, the volume of permeable voids (VPV) and performance in wet–dry cycles for 50% FNS and 30% fly ash were better than those for 100% OPC and natural sand

Celiac disease: how complicated can it get?

In the small intestine of celiac disease patients, dietary wheat gluten and similar proteins in barley and rye trigger an inflammatory response. While strict adherence to a gluten-free diet induces full recovery in most patients, a small percentage of patients fail to recover. In a subset of these refractory celiac disease patients, an (aberrant) oligoclonal intraepithelial lymphocyte population develops into overt lymphoma. Celiac disease is strongly associated with HLA-DQ2 and/or HLA-DQ8, as both genotypes predispose for disease development. This association can be explained by the fact that gluten peptides can be presented in HLA-DQ2 and HLA-DQ8 molecules on antigen presenting cells. Gluten-specific CD4+ T cells in the lamina propria respond to these peptides, and this likely enhances cytotoxicity of intraepithelial lymphocytes against the intestinal epithelium. We propose a threshold model for the development of celiac disease, in which the efficiency of gluten presentation to CD4+ T cells determines the likelihood of developing celiac disease and its complications. Key factors that influence the efficiency of gluten presentation include: (1) the level of gluten intake, (2) the enzyme tissue transglutaminase 2 which modifies gluten into high affinity binding peptides for HLA-DQ2 and HLA-DQ8, (3) the HLA-DQ type, as HLA-DQ2 binds a wider range of gluten peptides than HLA-DQ8, (4) the gene dose of HLA-DQ2 and HLA-DQ8, and finally,(5) additional genetic polymorphisms that may influence T cell reactivity. This threshold model might also help to understand the development of refractory celiac disease and lymphoma

The satisfactory growth and development at 2 years of age of the INTERGROWTH-21st Fetal Growth Standards cohort support its appropriateness for constructing international standards.

BACKGROUND: The World Health Organization recommends that human growth should be monitored with the use of international standards. However, in obstetric practice, we continue to monitor fetal growth using numerous local charts or equations that are based on different populations for each body structure. Consistent with World Health Organization recommendations, the INTERGROWTH-21st Project has produced the first set of international standards to date pregnancies; to monitor fetal growth, estimated fetal weight, Doppler measures, and brain structures; to measure uterine growth, maternal nutrition, newborn infant size, and body composition; and to assess the postnatal growth of preterm babies. All these standards are based on the same healthy pregnancy cohort. Recognizing the importance of demonstrating that, postnatally, this cohort still adhered to the World Health Organization prescriptive approach, we followed their growth and development to the key milestone of 2 years of age. OBJECTIVE: The purpose of this study was to determine whether the babies in the INTERGROWTH-21st Project maintained optimal growth and development in childhood. STUDY DESIGN: In the Infant Follow-up Study of the INTERGROWTH-21st Project, we evaluated postnatal growth, nutrition, morbidity, and motor development up to 2 years of age in the children who contributed data to the construction of the international fetal growth, newborn infant size and body composition at birth, and preterm postnatal growth standards. Clinical care, feeding practices, anthropometric measures, and assessment of morbidity were standardized across study sites and documented at 1 and 2 years of age. Weight, length, and head circumference age- and sex-specific z-scores and percentiles and motor development milestones were estimated with the use of the World Health Organization Child Growth Standards and World Health Organization milestone distributions, respectively. For the preterm infants, corrected age was used. Variance components analysis was used to estimate the percentage variability among individuals within a study site compared with that among study sites. RESULTS: There were 3711 eligible singleton live births; 3042 children (82%) were evaluated at 2 years of age. There were no substantive differences between the included group and the lost-to-follow up group. Infant mortality rate was 3 per 1000; neonatal mortality rate was 1.6 per 1000. At the 2-year visit, the children included in the INTERGROWTH-21st Fetal Growth Standards were at the 49th percentile for length, 50th percentile for head circumference, and 58th percentile for weight of the World Health Organization Child Growth Standards. Similar results were seen for the preterm subgroup that was included in the INTERGROWTH-21st Preterm Postnatal Growth Standards. The cohort overlapped between the 3rd and 97th percentiles of the World Health Organization motor development milestones. We estimated that the variance among study sites explains only 5.5% of the total variability in the length of the children between birth and 2 years of age, although the variance among individuals within a study site explains 42.9% (ie, 8 times the amount explained by the variation among sites). An increase of 8.9 cm in adult height over mean parental height is estimated to occur in the cohort from low-middle income countries, provided that children continue to have adequate health, environmental, and nutritional conditions. CONCLUSION: The cohort enrolled in the INTERGROWTH-21st standards remained healthy with adequate growth and motor development up to 2 years of age, which supports its appropriateness for the construction of international fetal and preterm postnatal growth standards

FLEXURAL BEHAVIOR OF TWO-LAYER BEAM MADE WITH LIGHT WEIGHT STEEL FIBRE CONCRETE AND RECYCLED AGGREGATE CONCRETE

<h2>Abstract</h2><p>In structural design, it is extremely desirable to use as low-material as possible while keeping integrity and usefulness. Reducing the structure's weight is one strategy for achieving this objective. Steel fibres have recently been added to reinforced concrete beams to increase flexural and shear strength. Fibre reinforcement in structural elements has drawn considerable interest from the building sector. Steel fibre has received the greatest attention and utilization among all fibre types. When compared to plain concrete, incorporating fibres into concrete may result in better crack management and greater strength. This study examines how two-layer beams made of lightweight steel fibre concrete and recycled aggregate concrete flex under bending loads. Twelve distinct beams with cross sections measuring 100 mm, 150 mm, and 1500 mm (width, depth, and length) are prepared and tested as part of the study. These beams are evaluated under four-point bending. In the tension zone of the lightweight concrete layer, different percentages of steel fibre ranging from 0% to 1.5% by volume were introduced. In the concrete compression layer, recycled block aggregate was substituted for natural coarse aggregate in varying percentages (0%, 25%, and 50%). According to the findings, the flexural strength of beams with a higher steel fibre percentage is higher than that of beams with a higher recycled aggregate component. The study also shows that two-layer beams with higher steel fibre content have superior crack management and deflection behavior than those with lower steel content. The results of the flexural reinforced concrete beam test were contrasted with the calculated design strength determined using British Standards.</p&gt

High Levels of IgA Antibodies to Helicobacter Pylori among Omani Women during Pregnancy and after Delivery

Background: Helicobacter pylori (H. pylori), is a common infection in pregnant women accompanied by variations in the levels of the IgM, IgA and IgG antibody isotypes. The variations of anti-H. pylori antibodies during and after pregnancy, and the extent of protection they provide to the mother and the fetus are not completely understood. Objectives: To investigate the changes of the anti-H. pylori IgM, IgA and IgG levels in healthy Omani pregnant women during pregnancy and 3 months after delivery. Methods: Serum samples obtained from 70 Omani healthy pregnant women, with no history of autoimmune diseases, were tested for anti-H. pylori IgM, IgA and IgG in the first trimester of pregnancy and 3 months after delivery. In parallel and as a control group, sera obtained from a group of 70 healthy non-pregnant Omani women were tested. The levels of anti-H. pylori IgM, IgA and IgG were measured using standard Enzyme Linked Immunosorbent Assays (ELISAs). Results: Anti-H. pylori IgA levels were found to be significantly higher during pregnancy (p=0.046) and after delivery (p=0.02) when compared to the control group. Moreover, a significant increase in the levels of anti-H. pylori IgM, IgA and IgG was detected after delivery (p=0.002) when compared to the levels during pregnancy. Conclusion: Pregnancy is associated with an increase in the levels of anti-H. pylori IgA antibodies. In addition, anti-H. pylori IgM, IgG and IgA antibody levels increase after delivery

Differential Production of Midkine and Pleiotrophin by Innate APCs upon Stimulation through Nucleic Acid-Sensing TLRs.

Midkine (MK) and pleiotrophin (PTN) belong to the same family of cytokines. They have similar sequences and functions. Both have important roles in cellular proliferation, tumors, and diseases. They regulate and are expressed by some immune cells. We have recently demonstrated MK production by some human innate antigen-presenting cells (iAPCs), i.e., monocyte-derived dendritic cells (MDDCs) and macrophages stimulated through Toll-like receptor (TLR)-4, and plasmacytoid dendritic cells (pDCs) stimulated through TLR 7. While PTN production was only documented in tissue macrophages. TLRs 3, 7, 8, and 9 are nucleic acid sensing (NAS) TLRs that detect nucleic acids from cell damage and infection and induce iAPC responses. We investigated whether NAS TLRs can induce MK and PTN production by human iAPCs, namely monocytes, macrophages, MDDCs, myeloid dendritic cells (mDCs), and pDCs. Our results demonstrated for the first time that PTN is produced by all iAPCs upon TLR triggering (p < 0.01). IAPCs produced more PTN than MK (p < 0.01). NAS TLRs and iAPCs had differential abilities to induce the production of MK, which was induced in monocytes and pDCs by all NAS TLRs (p < 0.05) and in MDDCs by TLRs 7/8 (p < 0.05). TLR4 induced a stronger MK production than NAS TLRs (p ≤ 0.05). Monocytes produced higher levels of PTN after differentiation to macrophages and MDDCs (p < 0.05). The production of MK and PTN differs among iAPCs, with a higher production of PTN and a selective induction of MK production by NAS TLR. This highlights the potentially important role of iAPCs in angiogenesis, tumors, infections, and autoimmunity through the differential production of MK and PTN upon TLR triggering