Model-based Cross-correlation Search for Gravitational Waves from the Low-mass X-Ray Binary Scorpius X-1 in LIGO O3 Data

We present the results of a model-based search for continuous gravitational waves from the low-mass X-ray binary Scorpius X-1 using LIGO detector data from the third observing run of Advanced LIGO and Advanced Virgo. This is a semicoherent search that uses details of the signal model to coherently combine data separated by less than a specified coherence time, which can be adjusted to balance sensitivity with computing cost. The search covered a range of gravitational-wave frequencies from 25 to 1600 Hz, as well as ranges in orbital speed, frequency, and phase determined from observational constraints. No significant detection candidates were found, and upper limits were set as a function of frequency. The most stringent limits, between 100 and 200 Hz, correspond to an amplitude h0 of about 10−25 when marginalized isotropically over the unknown inclination angle of the neutron star's rotation axis, or less than 4 × 10−26 assuming the optimal orientation. The sensitivity of this search is now probing amplitudes predicted by models of torque balance equilibrium. For the usual conservative model assuming accretion at the surface of the neutron star, our isotropically marginalized upper limits are close to the predicted amplitude from about 70 to 100 Hz; the limits assuming that the neutron star spin is aligned with the most likely orbital angular momentum are below the conservative torque balance predictions from 40 to 200 Hz. Assuming a broader range of accretion models, our direct limits on gravitational-wave amplitude delve into the relevant parameter space over a wide range of frequencies, to 500 Hz or more

Benefits of joint LIGO -- Virgo coincidence searches for burst and inspiral signals

We examine the benefits of performing a joint LIGO--Virgo search for transient signals. We do this by adding burst and inspiral signals to 24 hours of simulated detector data. We find significant advantages to performing a joint coincidence analysis, above either a LIGO only or Virgo only search. These include an increased detection efficiency, at a fixed false alarm rate, to both burst and inspiral events and an ability to reconstruct the sky location of a signal.Comment: 11 pages 8 figures, Amaldi 6 proceeding

Feasibility of measuring the Shapiro time delay over meter-scale distances

The time delay of light as it passes by a massive object, first calculated by Shapiro in 1964, is a hallmark of the curvature of space-time. To date, all measurements of the Shapiro time delay have been made over solar-system distance scales. We show that the new generation of kilometer-scale laser interferometers being constructed as gravitational wave detectors, in particular Advanced LIGO, will in principle be sensitive enough to measure variations in the Shapiro time delay produced by a suitably designed rotating object placed near the laser beam. We show that such an apparatus is feasible (though not easy) to construct, present an example design, and calculate the signal that would be detectable by Advanced LIGO. This offers the first opportunity to measure space-time curvature effects on a laboratory distance scale.Comment: 13 pages, 6 figures; v3 has updated instrumental noise curves plus a few text edits; resubmitted to Classical and Quantum Gravit

Searches for gravitational waves associated with pulsar glitches using a coherent network algorithm

Pulsar glitches are a potential source of gravitational waves for current and future interferometric gravitational wave detectors. Some pulsar glitch events were observed by radio and X-ray telescopes during the fifth LIGO science run. It is expected that glitches from these same pulsars should also be seen in the future. We carried out Monte Carlo simulations to estimate the sensitivity of possible gravitational wave signals associated with a pulsar glitch using a coherent network analysis method. We show the detection efficiency and evaluate the reconstruction accuracy of gravitational waveforms using a matched filter analysis on the estimated gravitational waveforms from the coherent analysis algorithm.Comment: submitted to CQ

DC-readout of a signal-recycled gravitational wave detector

All first-generation large-scale gravitational wave detectors are operated at the dark fringe and use a heterodyne readout employing radio frequency (RF) modulation-demodulation techniques. However, the experience in the currently running interferometers reveals several problems connected with a heterodyne readout, of which phase noise of the RF modulation is the most serious one. A homodyne detection scheme (DC-readout), using the highly stabilized and filtered carrier light as local oscillator for the readout, is considered to be a favourable alternative. Recently a DC-readout scheme was implemented on the GEO 600 detector. We describe the results of first measurements and give a comparison of the performance achieved with homodyne and heterodyne readout. The implications of the combined use of DC-readout and signal-recycling are considered.Comment: 11 page

LOOC UP: Locating and observing optical counterparts to gravitational wave bursts

Gravitational wave (GW) bursts (short duration signals) are expected to be associated with highly energetic astrophysical processes. With such high energies present, it is likely these astrophysical events will have signatures in the EM spectrum as well as in gravitational radiation. We have initiated a program, "Locating and Observing Optical Counterparts to Unmodeled Pulses in Gravitational Waves" (LOOC UP) to promptly search for counterparts to GW burst candidates. The proposed method analyzes near real-time data from the LIGO-Virgo network, and then uses a telescope network to seek optical-transient counterparts to candidate GW signals. We carried out a pilot study using S5/VSR1 data from the LIGO-Virgo network to develop methods and software tools for such a search. We will present the method, with an emphasis on the potential for such a search to be carried out during the next science run of LIGO and Virgo, expected to begin in 2009.Comment: 11 pages, 2 figures; v2) added acknowledgments, additional references, and minor text changes v3) added 1 figure, additional references, and minor text changes. v4) Updated references and acknowledgments. To be published in the GWDAW 12 Conf. Proc. by Classical and Quantum Gravit

Astronomy and astrophysics with gravitational waves in the Advanced Detector Era

With the advanced gravitational wave detectors coming on line in the next 5 years, we expect to make the first detections of gravitational waves from astrophysical sources, and study the properties of the waves themselves as tests of General Relativity. In addition, these gravitational waves will be powerful tools for the study of their astrophysical sources and source populations. They carry information that is quite complementary to what can be learned from electromagnetic or neutrino observations, probing the central gravitational engines that power the electromagnetic emissions. Preparations are being made to enable near-simultaneous observations of both gravitational wave and electromagnetic observations of transient sources, using low-latency search pipelines and rapid sky localization. We will review the many opportunities for multi-messenger astronomy and astrophysics with gravitational waves enabled by the advanced detectors, and the preparations that are being made to quickly and fully exploit them.Comment: 10 pages, no figures. Submitted to the proceedings of the 9th Edoardo Amaldi Conference on Gravitational Waves, and the 2011 Numerical Relativity - Data Analysis (NRDA) meeting, held 10-15 July 2011 in Cardiff, Wales, UK, July 10-15 2011 (Special issue of CQG). Updated in response to CQG referees and CQG proofs. Accepted by CQ

Virgo calibration and reconstruction of the gravitational wave strain during VSR1

Virgo is a kilometer-length interferometer for gravitational waves detection located near Pisa. Its first science run, VSR1, occured from May to October 2007. The aims of the calibration are to measure the detector sensitivity and to reconstruct the time series of the gravitational wave strain h(t). The absolute length calibration is based on an original non-linear reconstruction of the differential arm length variations in free swinging Michelson configurations. It uses the laser wavelength as length standard. This method is used to calibrate the frequency dependent response of the Virgo mirror actuators and derive the detector in-loop response and sensitivity within ~5%. The principle of the strain reconstruction is highlighted and the h(t) systematic errors are estimated. A photon calibrator is used to check the sign of h(t). The reconstructed h(t) during VSR1 is valid from 10 Hz up to 10 kHz with systematic errors estimated to 6% in amplitude. The phase error is estimated to be 70 mrad below 1.9 kHz and 6 micro-seconds above.Comment: 8 pages, 8 figures, proceedings of Amaldi 8 conference, to be published in Journal of Physics Conference Series (JPCS). Second release: correct typo