Argon I lines produced in a hollow cathode source, 332 nm to 5865 nm

We report precision measurements by Fourier transform spectroscopy of the vacuum wavenumber, line width, and relative signal strength of 928 lines in the Ar I spectrum. Wavelength in air and classification of the transition are supplied for each line. A comparison of our results with other precision measurements illustrates the sensitivity of Ar I wavelengths to conditions in the light source

Strong normal-incidence infrared absorption in self-organized InAs/InAlAs quantum dots grown on InP(001)

International audienceInAs self-assembled quantum dots in InAlAs matrix grown on InP001 substrates have been fabricated using Stranski-Krastanov growth mode. A strong in-plane polarized intraband absorption in the 10.6-20 m wavelength region has been observed and ascribed to a transition from the ground electron state to an excited state confined in the layer plane along the 110 direction. The absorption at normal-incidence reaches 7.8% for ten layers of n-doped quantum dots. The oscillator strength of the intraband transition is comparable to that achieved in quantum wells for a conduction band intersubband transition. The dependence of the intraband absorption on carrier concentration and temperature suggests a quantum-wire type confinement potential

Membrane patterned by pulsed laser micromachining for proton exchange membrane fuel cell with sputtered ultra-low catalyst loadings

International audienceProton exchange membranes were nano-and micro-patterned on their cathode side by pressing them against stainless steel molds previously irradiated by a Ti:Sapphire femtosecond laser. The membranes were associated to ultra-low loaded thin catalytic layers (25 µgPt cm-2) prepared by plasma magnetron sputtering. The Pt catalyst was sputtered either on the membrane or on the porous electrode. The fuel cell performance in dry conditions were found to be highly dependent on the morphology of the membrane surface. When nanometric ripples covered by a Pt catalyst were introduced on the surface of the membrane, the fuel cell outperformed the conventional one with a flat membrane. By combining nano-and micro-patterns (nanometric ripples and 11-24 µm deep craters), the performance of the cells was clearly enhanced. The maximum power density achieved by the fuel cell was multiplied by a factor of 3.6 (at 50 °C and 3 bars): 438 mW cm-2 vs 122 mW cm-2. This improvement is due to high catalyst utilization with a high membrane conductivity. When Pt is sputtered on the porous electrode (and not on the membrane), the contribution of the patterned membrane to the fuel cell efficiency was less significant, except in the presence of nanometric ripples. This result suggests that the patterning of the membrane must be consistent with the way the catalyst is synthesized, on the membrane or on the porous electrode

A Laser Frequency Comb System for Absolute Calibration of the VTT Echelle Spectrograph

A wavelength calibration system based on a laser frequency comb (LFC) was developed in a co-operation between the Kiepenheuer-Institut f\"ur Sonnenphysik, Freiburg, Germany and the Max-Planck-Institut f\"ur Quantenoptik, Garching, Germany for permanent installation at the German Vacuum Tower Telescope (VTT) on Tenerife, Canary Islands. The system was installed successfully in October 2011. By simultaneously recording the spectra from the Sun and the LFC, for each exposure a calibration curve can be derived from the known frequencies of the comb modes that is suitable for absolute calibration at the meters per second level. We briefly summarize some topics in solar physics that benefit from absolute spectroscopy and point out the advantages of LFC compared to traditional calibration techniques. We also sketch the basic setup of the VTT calibration system and its integration with the existing echelle spectrograph.Comment: 9 pages, 2 figures; Solar Physics 277 (2012

Reaction of C_2(a^3Pi_u) with methanol: Temperature dependence and deuterium isotope effect

We present a first temperature dependence and kinetic isotope effect study on the reaction of C_2(a^3Pi_u) with methanol. The bimolecular rate constants for a series of methanol isotopomers have been measured as a function of temperature between 293 and 673 K. The observed positive temperature dependences as well as deuterium kinetic isotope effects permit determination of the reaction mechanism as a site-specific hydrogen abstraction from the methyl site rather than from the hydroxyl site.Comment: 27 pages, 6 figures, 3 tables, 54 references; accepted to JC

PGC - 1α Overexpression Improves Angiogenic Signaling Potential of Skeletal Muscle - derived Extracellular Vesicles

poste

Hydrocephalus caused by conditional ablation of the Pten or beta-catenin gene

To investigate the roles of Pten and β-Catenin in the midbrain, either the Pten gene or the β-catenin gene was conditionally ablated, using Dmbx1 (diencephalon/mesencephalon-expressed brain homeobox gene 1)-Cre mice. Homozygous disruption of the Pten or β-catenin gene in Dmbx1-expressing cells caused severe hydrocephalus and mortality during the postnatal period. Conditional deletion of Pten resulted in enlargement of midbrain structures. β-catenin conditional mutant mice showed malformation of the superior and inferior colliculi and stenosis of the midbrain aqueduct. These results demonstrate that both Pten and β-Catenin are essential for proper midbrain development, and provide the direct evidence that mutations of both Pten and β-catenin lead to hydrocephalus

Argon I lines produced in a hollow cathode source, 332 nm to 5865 nm

We report precision measurements by Fourier transform spectroscopy of the vacuum wavenumber, line width, and relative signal strength of 928 lines in the Ar I spectrum. Wavelength in air and classification of the transition are supplied for each line. A comparison of our results with other precision measurements illustrates the sensitivity of Ar I wavelengths to conditions in the light source

The Imaging Magnetograph eXperiment (IMaX) for the Sunrise balloon-borne solar observatory

The Imaging Magnetograph eXperiment (IMaX) is a spectropolarimeter built by four institutions in Spain that flew on board the Sunrise balloon-borne telesocope in June 2009 for almost six days over the Arctic Circle. As a polarimeter IMaX uses fast polarization modulation (based on the use of two liquid crystal retarders), real-time image accumulation, and dual beam polarimetry to reach polarization sensitivities of 0.1%. As a spectrograph, the instrument uses a LiNbO3 etalon in double pass and a narrow band pre-filter to achieve a spectral resolution of 85 mAA. IMaX uses the high Zeeman sensitive line of Fe I at 5250.2 AA and observes all four Stokes parameters at various points inside the spectral line. This allows vector magnetograms, Dopplergrams, and intensity frames to be produced that, after reconstruction, reach spatial resolutions in the 0.15-0.18 arcsec range over a 50x50 arcsec FOV. Time cadences vary between ten and 33 seconds, although the shortest one only includes longitudinal polarimetry. The spectral line is sampled in various ways depending on the applied observing mode, from just two points inside the line to 11 of them. All observing modes include one extra wavelength point in the nearby continuum. Gauss equivalent sensitivities are four Gauss for longitudinal fields and 80 Gauss for transverse fields per wavelength sample. The LOS velocities are estimated with statistical errors of the order of 5-40 m/s. The design, calibration and integration phases of the instrument, together with the implemented data reduction scheme are described in some detail.Comment: 17 figure

The PROMIZING trial enrollment algorithm for early identification of patients ready for unassisted breathing

Background: Liberating patients from mechanical ventilation (MV) requires a systematic approach. In the context of a clinical trial, we developed a simple algorithm to identify patients who tolerate assisted ventilation but still require ongoing MV to be randomized. We report on the use of this algorithm to screen potential trial participants for enrollment and subsequent randomization in the Proportional Assist Ventilation for Minimizing the Duration of MV (PROMIZING) study. Methods: The algorithm included five steps: enrollment criteria, pressure support ventilation (PSV) tolerance trial, weaning criteria, continuous positive airway pressure (CPAP) tolerance trial (0 cmHO during 2 min) and spontaneous breathing trial (SBT): on fraction of inspired oxygen (FO) 40% for 30-120 min. Patients who failed the weaning criteria, CPAP Zero trial, or SBT were randomized. We describe the characteristics of patients who were initially enrolled, but passed all steps in the algorithm and consequently were not randomized. Results: Among the 374 enrolled patients, 93 (25%) patients passed all five steps. At time of enrollment, most patients were on PSV (87%) with a mean (± standard deviation) FO of 34 (± 6) %, PSV of 8.7 (± 2.9) cmHO, and positive end-expiratory pressure of 6.1 (± 1.6) cmHO. Minute ventilation was 9.0 (± 3.1) L/min with a respiratory rate of 17.4 (± 4.4) breaths/min. Patients were liberated from MV with a median [interquartile range] delay between initial screening and extubation of 5 [1-49] hours. Only 7 (8%) patients required reintubation. Conclusion: The trial algorithm permitted identification of 93 (25%) patients who were ready to extubate, while their clinicians predicted a duration of ventilation higher than 24 h