1,285 research outputs found
Modeling of "groove" rolling defect on internal surface of pipes at lengthwise rolling
The research has been conducted in pipe forming at rolling off by lengthwise rolling mill with stub mandrel; the patterns of change in dimensionless parameters were determined, which characterize deformation in side angle depending on http://www.multitran.ru/c/m.exe?t=424995_2_1elongation ratio. The model of formation of lengthwise groove on internal surface of pipes has been proposed
Beam test results of 3D fine-grained scintillator detector prototype for a T2K ND280 neutrino active target
An upgrade of the long baseline neutrino experiment T2K near detector ND280
is currently being developed with the goal to reduce systematic uncertainties
in the prediction of number of events at the far detector Super-Kamiokande. The
upgrade program includes the design and construction of a new highly granular
fully active scintillator detector with 3D WLS fiber readout as a neutrino
target. The detector of about in size and a mass
of 2.2~tons will be assembled from about plastic
scintillator cubes of . Each cube is read out by three
orthogonal Kuraray Y11 Wave Length Shifting (WLS) fibers threaded through the
detector. A detector prototype made of 125 cubes was assembled and tested in a
charged particle test beam at CERN in the fall of 2017. This paper presents the
results obtained on the light yield and timing as well as on the optical
cross-talk between the cubes.Comment: 5 pages, 8 figure
PMU-based informational support of power system control tasks
Up-to-date wide area measurement systems (WAMS) based on phasor measurement units (PMU) appeared at the very end of the 20th century. Under present-day conditions, WAMS serve as the basis for information-measuring systems, which significantly improve power system control and operation. In practice, WAMS are mostly used for power system stability control and transient monitoring and visualization. This paper discusses the new opportunities for power system control quality improvement, resulting from PMU application for power system steady-state parameters' assessment. Firstly, better control is provided by online equivalent circuit parameters' identification using PMU measurement data and taking into account FACTS and other shunt and series compensation equipment. Secondly, the paper addresses the problems of "nodal" identification, which have taken on great importance recently due to the intensive development of small-scaled distributed generation. Based on PMU measurements of nodal voltages and incident transmission lines' electric currents, one can obtain online steady-state load characteristics, which can be used for dispatch control applications. Moreover, PMUs provide superaccelerated power flow calculations, which are of crucial importance for emergency automation, adjusted for prior operation. Such principles of emergency automation consist of the quick determination of control actions, aimed at power system stability maintenance in cases of any programmed faults' occurrence. It is known that such control is carried out by means of power flow calculations based on remote metering data. The proposed application and allocation of PMUs in the power system by means of combinatorial matrix transformation to triangle form give the possibility to perform accelerated node-voltage analysis without equivalent circuit simplification. All the calculations are verified using IEEE test networks. © 2014 WIT Press.International Journal of Safety and Security Engineering;International Journal of Sustainable Development and Planning;WIT Transactions on Ecology and the Environmen
Preparation and properties of silicon- and titanium-containing hybrid nanocomposite films based on ethyl cellulose
Nanocomposite hybrid films containing silicon and titanium compounds in the polymer matrix are prepared through the sol-gel method via the hydrolytic polycondensation of Si and Ti alkoxides (tetraethoxysilane and titanium tetrabutoxide) in the THF solution of a hydrophobic polymer, ethyl cellulose. Their structure and properties are studied with the use of a complex of physicochemical methods. During the hydrolysis of tetraethoxysilane and the subsequent polycondensation of the reaction products, silicon atoms are incorporated into the polymer and form -O-Si-O-bonds involving hydroxyl groups of ethyl cellulose. In the sol-gel method, titanium alkoxide yields nanosized particles of titanium dioxide that play the role of fillers in the polymer matrix. Titanium-containing films show solubility in THF and, after prolonged contact with the solvent, precipitate titanium dioxide from the solution. Hybrid films containing silicon are insoluble owing to the formation of a chemical network between polymer molecules and Si-OH groups of the products of hydrolysis of silicon alkoxide, as confirmed by the IR data. It is shown that the amounts and types of alkoxides and the diameters of the structures formed in the polymer matrix via the sol-gel procedure affect the hydrophilicity levels of ethyl cellulose hybrid films and their abilities to swell in water and aqueous solutions of organic dyes (brilliant blue and methylene blue). Ethyl cellulose hybrid films are hydrophilic, and they facilitate the removal of dye molecules from aqueous solutions. The best properties are featured by the films containing nanosized particles of titanium dioxide in the polymer matrix. © 2013 Pleiades Publishing, Ltd
Development Of Software–Hardware System for Real Time Simulation of Electric Power System with Smart Grids
The design and research of electric power system (EPS) with smart grids (SG), which are the current world trend of modern electric power industry, requires solving a large number of non-trivial tasks. The developed technical solutions and used equipment are novel for the world practice. Therefore, their implementation requires carefulanalysis and an individual approach to research that provides an assessment of the impact of new network elements on the power system. All of this puts requirements on the tools and methods of research used to solve such problems. At present, digital systems for modelling EPS with SG based on the application of numerical methods are used as such tools. However, despite the high level of these developments, it has drawbacks. The use of incomplete and invalid information obtained by digital tools can lead to the wrong design and operational decision in real power system, which can cause blackouts. The alternative approach for solving the problem of detailed simulation of EPS with SG is the creation of hybrid system based on the principle of combining different modelling methods. Hybrid Real-Time Power System Simulator (HRTSim) is developed based on this approach and presented in the paper
Crystal growth, characterization and electronic band structure of TiSeS
Layered semimetallic van der Waals materials TiSe2 has attracted a lot of
attention because of interplay of a charge density wave (CDW) state and
superconductivity. Its sister compound TiS2, being isovalent to TiSe2 and
having the same crystal structure, shows a semiconducting behavior. The natural
rises what happens at the transition point in TiSe2-xSx, which is expected for
x close to 1. Here we report the growth and characterization of TiSeS single
crystals and the study of the electronic structure using density functional
theory (DFT) and angle-resolved photoemission (ARPES). We show that TiSeS
single crystals have the same morphology as TiSe2. Transport measurements
reveal a metallic state, no evidence of CDW was found. DFT calculations suggest
that the electronic band structure in TiSeS is similar to that of TiSe2, but
the electron and hole pockets in TiSeS are much smaller. The ARPES results are
in good agreement with the calculations.Comment: 22 pages, 9 figure
Solar neutrino detection in a large volume double-phase liquid argon experiment
Precision measurements of solar neutrinos emitted by specific nuclear
reaction chains in the Sun are of great interest for developing an improved
understanding of star formation and evolution. Given the expected neutrino
fluxes and known detection reactions, such measurements require detectors
capable of collecting neutrino-electron scattering data in exposures on the
order of 1 ktonne yr, with good energy resolution and extremely low background.
Two-phase liquid argon time projection chambers (LAr TPCs) are under
development for direct Dark Matter WIMP searches, which possess very large
sensitive mass, high scintillation light yield, good energy resolution, and
good spatial resolution in all three cartesian directions. While enabling Dark
Matter searches with sensitivity extending to the "neutrino floor" (given by
the rate of nuclear recoil events from solar neutrino coherent scattering),
such detectors could also enable precision measurements of solar neutrino
fluxes using the neutrino-electron elastic scattering events. Modeling results
are presented for the cosmogenic and radiogenic backgrounds affecting solar
neutrino detection in a 300 tonne (100 tonne fiducial) LAr TPC operating at
LNGS depth (3,800 meters of water equivalent). The results show that such a
detector could measure the CNO neutrino rate with ~15% precision, and
significantly improve the precision of the 7Be and pep neutrino rates compared
to the currently available results from the Borexino organic liquid
scintillator detector.Comment: 21 pages, 7 figures, 6 table
Experimental characterization of anomalous strong scattering of mm-waves in TEXTOR plasmas with rotating islands
Anomalous scattering of high power millimetre waves from gyrotrons at 140 and 110 GHz is investigated for plasma with rotating islands at TEXTOR. The magnetic field and plasma density influence the spectral content of the scattered waves and their power levels significantly. Anomalous strong scattering occurs in two density regimes, one at low densities and one at high densities, that also depend on the magnetic field. The two regimes are separated by a quiescent regime without anomalous scattering. Investigations suggest that scattering in the high-density regime is generated at the low-field side intersection of the gyrotron beam and the island position. The transition from the quiescent regime to the high-density regime occurs when the gyrotron frequency is twice the upper hybrid frequency at this position. There is some evidence that the scattering in the low-density regime is generated near the plasma centre. Under this assumption all the observed scattering is generated when the gyrotron frequency is near or below twice the upper hybrid frequency
Baby MIND: A magnetised spectrometer for the WAGASCI experiment
The WAGASCI experiment being built at the J-PARC neutrino beam line will
measure the difference in cross sections from neutrinos interacting with a
water and scintillator targets, in order to constrain neutrino cross sections,
essential for the T2K neutrino oscillation measurements. A prototype Magnetised
Iron Neutrino Detector (MIND), called Baby MIND, is being constructed at CERN
to act as a magnetic spectrometer behind the main WAGASCI target to be able to
measure the charge and momentum of the outgoing muon from neutrino charged
current interactions.Comment: Poster presented at NuPhys2016 (London, 12-14 December 2016). Title +
4 pages, LaTeX, 6 figure
Synchronization of the Distributed Readout Frontend Electronics of the Baby MIND Detector
Baby MIND is a new downstream muon range detector for the WGASCI experiment. This article discusses the distributed readout system and its timing requirements. The paper presents the design of the synchronization subsystem and the results of its test
- …