38,579 research outputs found
The sensitivity of a very long baseline interferometer
The theoretical sensitivity of various methods of acquiring and processing interferometer data are compared. It is shown that for a fixed digital recording capacity one bit quantization of single sideband data filtered with a rectangular bandpass and sampled at the Nyquist rate yields the optimum signal to noise ratio. The losses which result from imperfect bandpass, poor image rejection, approximate methods of fringe rotation, fractional bit correction, and loss of quadrature are discussed. Also discussed is the use of the complex delay function as a maximum likelihood fringe estimator
Microwaves to megabits
Receiver and terminal characteristics of the Mark 3 very long baseline interferometry system are described in some detail. The Mark 3 system has 14 IF to video converters, each with built in synthesized local oscillators which have a range of 100 to 500 MHz covered in 10 kHz steps. In the normal wideband continuum mode, all 14 upper and all 14 lower sideband video outputs (each with 2 MHz bandwidth) are recorded with a total data rate of 112 Mbits/sec. In geodetic observations, two IF bands are simultaneously recorded from a dual band (5/X) receiver
Phase and group delay calibration of a very long baseline interferometer by East Coast VLBI Group
Precisely timed pulses injected into the input of each receiver are used to calibrate the phase and group delay through each interferometer terminal. The short duration pulses are generated at a 1 MHz rate directly from the output of the frequency standard. The pulses are injected into the receiver at a level low enough to produce less than one percent increase in system temperature, yet can be extracted during processing with a high enough signal to noise ratio to determine the phase of the calibration rails within 1 degree in 1 second of integration. The calibration system also includes precise cable measurement electronics and a pulse echo for clock synchronization
Leishmania manipulation of sand fly feeding behavior results in enhanced transmission.
In nature the prevalence of Leishmania infection in whole sand fly populations can be very low (<0.1%), even in areas of endemicity and high transmission. It has long since been assumed that the protozoan parasite Leishmania can manipulate the feeding behavior of its sand fly vector, thus enhancing transmission efficiency, but neither the way in which it does so nor the mechanisms behind such manipulation have been described. A key feature of parasite development in the sand fly gut is the secretion of a gel-like plug composed of filamentous proteophosphoglycan. Using both experimental and natural parasite-sand fly combinations we show that secretion of this gel is accompanied by differentiation of mammal-infective transmission stages. Further, Leishmania infection specifically causes an increase in vector biting persistence on mice (re-feeding after interruption) and also promotes feeding on multiple hosts. Both of these aspects of vector behavior were found to be finely tuned to the differentiation of parasite transmission stages in the sand fly gut. By experimentally accelerating the development rate of the parasites, we showed that Leishmania can optimize its transmission by inducing increased biting persistence only when infective stages are present. This crucial adaptive manipulation resulted in enhanced infection of experimental hosts. Thus, we demonstrate that behavioral manipulation of the infected vector provides a selective advantage to the parasite by significantly increasing transmission
Radiation environment for rendezvous and docking with nuclear rockets
Radiation environment data for the NERVA engine are provided which may be utilized in estimating radiation exposures associated with various space maneuvers. Spatial distributions of neutron and gamma tissue kerma rates produced during full thrust operation of the engine are presented. Final rendezvous with an orbiting space station would be achieved subsequent to full thrust operation during a period of 10 or more hours duration in which impulse is delivered by the propellant used for removal of decay heat. Consequently, post operation radiation levels are of prime importance in estimating space station exposures. Maps of gamma kerma rates around the engine are provided for decay times of 4 and 24 hours after a representative firing. Typical decay curves illustrating the dependence of post operation kerma rates on decay time and operating history are included. Examples of the kerma distributions around the engine which result from integration over specific exposure periods are shown
Recommended from our members
Research Factsheet: Woodfuel experiment - North Thurlbar, Newton Rigg
An experiment has been set up to assess the economic viability and environmental impacts of woodfuel harvesting in North Thurlbar, a small wood land on the University of Cumbria Newton Rigg campus estate. This factsheet describes the aim of the study and the experiment design
Water-management models in Florida from ERTS-1 data
The author has identified the following significant results. The usefullness of ERTS 1 to improving the overall effectiveness of collecting and disseminating data was evaluated. ERTS MSS imagery and in situ monitoring by DCS were used to evaluate their separate and combined capabilities. Twenty data collection platforms were established in southern Florida. Water level and rainfall measurements were collected and disseminated to users in less than 2 hours, a significant improvement over conventional techniques requiring 2 months. ERTS imagery was found to significantly enhance the utility of ground measurements. Water stage was correlated with water surface areas from imagery in order to obtain water stage-volume relations. Imagery provided an economical basis for extrapolating water parameters from the point samples to unsampled data and provided a synoptic view of water mass boundaries that no amount of ground sampling or monitoring could provide
- ā¦