Delta-Sigma Digitization and Optical Coherent Transmission of DOCSIS 3.1 Signals in Hybrid Fiber Coax Networks

We first demonstrate delta-sigma digitization and coherent transmission of data over cable system interface specification (DOCSIS) 3.1 signals in a hybrid fiber coax (HFC) network. Twenty 192-MHz DOCSIS 3.1 channels with modulation up to 16384QAM are digitized by a low-pass cascade resonator feedback (CRFB) delta-sigma analog-to-digital converter (ADC) and transmitted over 80 km fiber using coherent single-λ 128-Gb/s dual-polarization (DP)-QPSK and 256-Gb/s DP-16QAM optical links. Both one-bit and two-bit delta-sigma digitization are implemented and supported by the QPSK and 16QAM coherent transmission systems, respectively. To facilitate its practical application in access networks, the coherent system is built using a low-cost narrowband optical modulator and RF amplifiers. Modulation error ratio (MER) larger than 50 dB is successfully demonstrated for all 20 DOCSIS 3.1 channels, and high order modulation up to 16384QAM is delivered over fiber for the first time in HFC networks. The raw DOCSIS data capacity is 54 Gb/s with net user information ~45 Gb/s. Moreover, the bit error ratio (BER) tolerance is evaluated by measuring the MER performance as BER increases. Negligible MER degradation is observed for BER up to 1.5 × 10−6 and 1.7 × 10−4, for one-bit and two-bit digitization, respectively

Nonlinear impairments and mitigation technologies for the next generation fiber-wireless mobile fronthaul networks

The proliferation of Internet-connected mobile devices and video-intensive services are driving the growth of mobile data traffic in an explosive way. The last mile of access networks, mobile fronthaul (MFH) networks, have become the data rate bottleneck of user experience. The objective of this research are two-fold. For analog MFH, nonlinear interferences among multiple bands of mobile signals in a multi-RAT multi-service radio-over-fiber (RoF)-based MFH system are investigated for the first time. The nonlinear impairments of both single-carrier and multi-carrier signals are investigated, and it is experimentally demonstrated that inter-channel interferences play a more important role in the performance degradation of analog MFH than the nonlinear distortions of each individual signal. A digital predistortion technique was also presented to linearize the analog MFH links. On the other hand, for digital MFH, we experimentally demonstrate a novel digitization interface based on delta-sigma modulation to replace the state-of-the-art common public radio interface (CPRI). Compared with CPRI, it provides improved spectral efficiency and enhanced fronthaul capacity, and can accommodate both 4G-LTE and 5G mobile services.Ph.D

Fiber Optics

Optical fibers in metrology, telecommunications, sensors, manufacturing, and health science have gained massive research interest. The number of applications is increasing at a fast pace. This book aims to present a collection of recent advances in fiber optics, addressing both fundamental and industrial applications. It covers the current progress and latest breakthroughs in emergent applications of fiber optics. The book includes five chapters on recent developments in optical fiber communications and fiber sensors, as well as the design, simulation, and fabrication of novel fiber concepts

Design and analysis of multi-element antenna systems and agile radiofrequency frontends for automotive applications

Vehicular connectivity serves as one of the major enabling technologies for current applications like driver assistance, safety and infotainment as well as upcoming features like highly automated vehicles - all of which having certain quality of service requirements, e. g. datarate or reliability. This work focuses on vehicular integration of multiple-input-multiple-output (MIMO) capable multielement antenna systems and frequency-agile radio frequency (RF) front ends to cover current and upcoming connectivity needs. It is divided in four major parts. For each part, mostly physical layer effects are analyzed (any performance lost on physical layer, cannot be compensated in higher layers), sensitivities are identified and novel concepts are introduced based on the status-quo findings.Fahrzeugvernetzung dient als eine der wesentlichsten Befähigungstechnologien für moderne Fahrerassistenzsysteme und zukünftig auch hochautomatisiertes Fahren. Sowohl die heutigen als auch zukünftige Anwendungen haben besondere Dienstgüteanforderungen, z.B. in Bezug auf die Datenrate oder Verlässlichkeit. Im Rahmen dieser Arbeit wird die Integration von Mehrantennensystemen für MIMO-Funkanwendungen (MIMO: engl. Multiple Input Multiple Output) sowie von frequenzagilen Hochfrequenzfrontends im Fahrzeugumfeld untersucht, um so eine technische Grundlage für zukünftige Anforderungen an die automobile Vernetzung anbieten zu können. Die dabei gewonnenen Erkenntnisse lassen sich in vier Teile gliedern. Grundsätzlich konzentrieren sich die Untersuchungen vorrangig auf die physikalische Ebene. Auf Basis des aktuellen Status Quo werden Sensitivitäten herausgearbeitet, neue Konzepte hergeleitet und entwickelt

Digital Signal Processing Techniques Applied to Radio over Fiber Systems

The dissertation aims to analyze different Radio over Fiber systems for the front-haul applications. Particularly, analog radio over fiber (A-RoF) are simplest and suffer from nonlinearities, therefore, mitigating such nonlinearities through digital predistortion are studied. In particular for the long haul A-RoF links, direct digital predistortion technique (DPDT) is proposed which can be applied to reduce the impairments of A-RoF systems due to the combined effects of frequency chirp of the laser source and chromatic dispersion of the optical channel. Then, indirect learning architecture (ILA) based structures namely memory polynomial (MP), generalized memory polynomial (GMP) and decomposed vector rotation (DVR) models are employed to perform adaptive digital predistortion with low complexities. Distributed feedback (DFB) laser and vertical capacity surface emitting lasers (VCSELs) in combination with single mode/multi-mode fibers have been linearized with different quadrature amplitude modulation (QAM) formats for single and multichannel cases. Finally, a feedback adaptive DPD compensation is proposed. Then, there is still a possibility to exploit the other realizations of RoF namely digital radio over fiber (D-RoF) system where signal is digitized and transmits the digitized bit streams via digital optical communication links. The proposed solution is robust and immune to nonlinearities up-to 70 km of link length. Lastly, in light of disadvantages coming from A-RoF and D-RoF, it is still possible to take only the advantages from both methods and implement a more recent form knows as Sigma Delta Radio over Fiber (S-DRoF) system. Second Order Sigma Delta Modulator and Multi-stAge-noise-SHaping (MASH) based Sigma Delta Modulator are proposed. The workbench has been evaluated for 20 MHz LTE signal with 256 QAM modulation. Finally, The 6x2 GSa/s sigma delta modulators are realized on FPGA to show a real time demonstration of S-DRoF system. The demonstration shows that S-DRoF is a competitive competitor for 5G sub-6GHz band applications

Linear Operation of Switch-Mode Outphasing Power Amplifiers

Radio transceivers are playing an increasingly important role in modern society. The ”connected” lifestyle has been enabled by modern wireless communications. The demand that has been placed on current wireless and cellular infrastructure requires increased spectral efficiency however this has come at the cost of power efficiency. This work investigates methods of improving wireless transceiver efficiency by enabling more efficient power amplifier architectures, specifically examining the role of switch-mode power amplifiers in macro cell scenarios. Our research focuses on the mechanisms within outphasing power amplifiers which prevent linear amplification. From the analysis it was clear that high power non-linear effects are correctable with currently available techniques however non-linear effects around the zero crossing point are not. As a result signal processing techniques for suppressing and avoiding non-linear operation in low power regions are explored. A novel method of digital pre-distortion is presented, and conventional techniques for linearisation are adapted for the particular needs of the outphasing power amplifier. More unconventional signal processing techniques are presented to aid linearisation of the outphasing power amplifier, both zero crossing and bandwidth expansion reduction methods are designed to avoid operation in nonlinear regions of the amplifiers. In combination with digital pre-distortion the techniques will improve linearisation efforts on outphasing systems with dynamic range and bandwidth constraints respectively. Our collaboration with NXP provided access to a digital outphasing power amplifier, enabling empirical analysis of non-linear behaviour and comparative analysis of behavioural modelling and linearisation efforts. The collaboration resulted in a bench mark for linear wideband operation of a digital outphasing power amplifier. The complimentary linearisation techniques, bandwidth expansion reduction and zero crossing reduction have been evaluated in both simulated and practical outphasing test benches. Initial results are promising and indicate that the benefits they provide are not limited to the outphasing amplifier architecture alone. Overall this thesis presents innovative analysis of the distortion mechanisms of the outphasing power amplifier, highlighting the sensitivity of the system to environmental effects. Practical and novel linearisation techniques are presented, with a focus on enabling wide band operation for modern communications standards

Evaluation of Sigma-Delta-over-Fiber for High-Speed Wireless Applications

Future mobile communication networks aim to increase the communication speed,\ua0provide better reliability and improve the coverage. It needs to achieve all of these enhancements, while the number of users are increasing drastically. As a result, new base-station (BS) architectures where the signal processing is centralized and wireless access is provided through multiple, carefully coordinated remote radio heads are needed. Sigma-delta-over-fiber (SDoF) is a communication technique that can address both requirements and enable very low-complexity, phase coherent remote radio transmission, while transmitting wide-band communication signals with high quality. This thesis investigates the potential and limitations of SDoF communication links as an enabler for future mobile networks.In the first part of the thesis, an ultra-high-speed SDoF link is realized by using state-of-the-art vertical-cavity surface-emitting-lasers (VCSEL). The effects of VCSEL characteristics on such links in terms of signal quality, energy efficiency and potential lifespan is investigated. Furthermore, the potential and limitations of UHS-SDoF are evaluated with signals having various parameters. The results show that, low-cost, reliable, energy efficient, high signal quality SDoF links can be formed by using emerging VCSEL technology. Therefore, ultra-high-speed SDoF is a very promising technique for beyond 10~GHz communication systems.In the second part of the thesis, a multiple-input-multiple-output (MIMO) communication testbed with physically separated antenna elements, distributed-MIMO, is formed by multiple SDoF links. It is shown that the digital up-conversion, performed with a shared local-oscillator/clock at the central unit, provides excellent phase coherency between the physically distributed antenna elements. The proposed testbed demonstrates the advantages of SDoF for realizing distributed MIMO systems and is a powerful tool to perform various communication experiments in real environments.In general, SDoF is a solution for the downlink of a communication system, i.e. from central unit to remote radio head, however, the low complexity and low cost requirement of the remote radio heads makes it difficult to realize the uplinks of such systems. The third part of this thesis proposes an all-digital solution for realizing complementary uplinks for SDoF systems. The proposed structure is extensively investigated through simulations and measurements and the results demonstrate that it is possible realize all-digital, duplex, optical communication links between central units and remote radio heads.In summary, the results in this thesis demonstrate the potential of SDoF for wideband, distributed MIMO communication systems and proposes a new architecture for all-digital duplex communication links. Overall, the thesis shows that SDoF technique is powerful technique for emerging and future mobile communication networks, since it enables a centralized structure with low complexity remote radio heads and provides high signal quality

Multiple-input multiple-output visible light communication receivers for high data-rate mobile applications

Visible light communication (VLC) is an emerging form of optical wireless communication that transmits data by modulating light in the visible spectrum. To meet the growing demand for wireless communication capacity from mobile devices, we investigate multiple-input multiple-output (MIMO) VLC to achieve multiplexing capacity gains and to allow multiple users to simultaneously transmit without disrupting each other. Previous approaches to receive VLC signals have either been unable to simultaneously receive multiple independent signals from multiple transmitters, unable to adapt to moving transmitters and receivers, or unable to sample the received signals fast enough for high-speed VLC. In this dissertation, we develop and evaluate two novel approaches to receive high-speed MIMO VLC signals from mobile transmitters that can be practically scaled to support additional transmitters. The first approach, Token-Based Pixel Selection (TBPS) exploits the redundancy and sparsity of high-resolution transmitter images in imaging VLC receivers to greatly increase the rate at which complementary metal-oxide semiconductor (CMOS) active pixel sensor (APS) image sensors can sample VLC signals though improved signal routing to enable such high-resolution image sensors to capture high-speed VLC signals. We further model the CMOS APS pixel as a linear shift-invariant system, investigate how it scales to support additional transmitters and higher resolutions, and investigate how noise can affect its performance. The second approach, a spatial light modulator (SLM)-based VLC receiver, uses an SLM to dynamically control the resulting wireless channel matrix to enable relatively few photodetectors to reliably receive from multiple transmitters despite their movements. As part of our analysis, we develop a MIMO VLC channel capacity model that accounts for the non-negativity and peak-power constraints of VLC systems to evaluate the performance of the SLM VLC receiver and to facilitate the optimization of the channel matrix through the SLM

New d-piso architecture for dynamic symbol size digital baseband modulation implementation in FPGA

Dynamic symbol size modulation is a type modulation which could provide a fast transmission speed by removing the redundant symbol as compare to fixed symbol size modulation. The dynamic nature of the symbol created an additional problem in hardware design as the size of symbol needed to be defined clearly and it cannot be change and altered once the design has been generated. Thus, to address the issue, this research investigated the best implementation method and performance study of fixed and dynamic symbol size digital baseband modulation for optical communication system in FPGA hardware design. KCU105 FPGA development board and Vivado software were chosen as the main platform to implement the design. A new architecture to implement dynamic symbol size baseband modulation in FPGA is presented in this thesis. Clock control (CC) is used as the research’s based design to create two new architectures which use multiple parallel in serial out (M-PISO) and dynamic parallel in serial out (D-PISO). Next, by using D-PISO architecture, dynamic symbol size modulation namely 8-reverse dual header pulse interval modulation (8-RDHPIM), 8-digital pulse interval modulation (8-DPIM) and fixed symbol size modulation 8-pulse position modulation (8-PPM) were fully implemented in the FPGA which has a transmitter and receiver module. An experimental comparative study was then carried out for each modulation technique. The main parameters investigated were data timing analysis, hardware utilization, power utilization as well as bit error rate performance. From the results, it can be concluded that for power limited system, 8-PPM could be selected as it can maintain a small number of symbol error rate (SER) even during low power transmission which is around -6 dBm. On the other hand, the 8-DPIM and 8-RDHPIM that achieved the transmission speed of 33.3 Mbps and 27.27 Mbps are suitable for systems that require high data speed and minimal clock synchronization