52 research outputs found
Power Control for D2D Underlay in Multi-cell Massive MIMO Networks
This paper proposes a new power control and pilot allocation scheme for
device-to-device (D2D) communication underlaying a multi-cell massive MIMO
system. In this scheme, the cellular users in each cell get orthogonal pilots
which are reused with reuse factor one across cells, while the D2D pairs share
another set of orthogonal pilots. We derive a closed-form capacity lower bound
for the cellular users with different receive processing schemes. In addition,
we derive a capacity lower bound for the D2D receivers and a closed-form
approximation of it. Then we provide a power control algorithm that maximizes
the minimum spectral efficiency (SE) of the users in the network. Finally, we
provide a numerical evaluation where we compare our proposed power control
algorithm with the maximum transmit power case and the case of conventional
multi-cell massive MIMO without D2D communication. Based on the provided
results, we conclude that our proposed scheme increases the sum spectral
efficiency of multi-cell massive MIMO networks.Comment: 6 Pages, 3 Figures, WSA 201
Power allocation in a QoS-aware cellular-based vehicular communication system.
Masters Degree. University of KwaZulu- Natal, Durban.The task of a driver assistance system is to monitor the surrounding environment of a vehicle and provide an appropriate response in the case of detecting any hazardous condition. Such operation requires real-time processing of a large amount of information, which is gathered by a variety of sensors. Vehicular communication in future vehicles can pave the way for designing highly efficient and cost-effective driver assistance systems based on collaborative and remote processing solutions. The main transmission links of vehicular communication systems are vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2I). In this research, a cellular-based vehicular communication system is proposed where Device-to-device (D2D) communication links are considered for establishing V2V links, and cellular communication links are employed for V2I links.
D2D communication is one of the enablers of the next generation of cellular networks for improving spectrum and power utilization. D2D communication allows direct communication between user equipments within a cellular system. Nevertheless, implementing D2D communication should not defect nearby ongoing communication services. As a result, interference management is a significant aspect of designing D2D communication systems. Communication links in a cellular network are supposed to support a required level of data rates. The capacity of a communication channel is directly proportional to the energy of a transmitted signal, and in fact, achieving the desired level of Quality of Service (QoS) requires careful control of transmission power for all the radio sources within a system. Among different methods that are recommended for D2D communications, in-band D2D can offer better control over power transmission sources.
In an underlay in-band D2D communication system, D2D user equipments (DUEs) usually reuse the cellular uplink (UL) spectrum. In such a system, the level of interference can effectively be managed by controlling the level of power that is transmitted by user equipments. To effectively perform the interference management, knowledge of the channel state information is required. However, as a result of the distributed nature of DUEs, such information is not fully attainable in a practical D2D system. Therefore, statistical methods are employed to find boundaries on the allocated transmission powers for achieving sufficient spectral efficiencies in V2I and V2V links without considering any prior knowledge on vehicles’ locations or the channel state information. Furthermore, the concepts of massive multiple-input multiple-output and underlay D2D communication sharing the uplink spectrum of a cellular system are used to minimize the interference effect
Recommended from our members
Integrated cellular and device-to-device networks
textDevice-to-device (D2D) networking enables direct discovery and communication between cellular subscribers that are in proximity, thus bypassing the base stations (BSs). In principle, exploiting direct communication between nearby mobile devices will improve spectrum utilization, overall throughput, and energy consumption, while enabling new peer-to-peer and location-based applications and services. D2D-enabled broadband communication technology is also required by public safety networks that must function when cellular networks are not available. Integrating D2D into cellular networks, however, poses many challenges and risks to the long-standing cellular architecture, which is centered around the BSs. This dissertation identifies outstanding technical challenges in D2D-enabled cellular networks and addresses them with novel models and fundamental analysis. First, this dissertation develops a baseline hybrid network model consisting of both ad hoc nodes and cellular infrastructure. This model uses Poisson point processes to model the random and unpredictable locations of mobile users. It also captures key features of multicast D2D including multicast receiver heterogeneity and retransmissions while being tractable for analytical purpose. Several important multicast D2D metrics including coverage probability, mean number of covered receivers per multicast session, and multicast throughput are analytically characterized under the proposed model. Second, D2D mode selection which means that a potential D2D pair can switch between direct and cellular modes is incorporated into the hybrid network model. The extended model is applied to study spectrum sharing between cellular and D2D communications. Two spectrum sharing models, overlay and underlay, are investigated under a unified analytical framework. Analytical rate expressions are derived and applied to optimize the design of spectrum sharing. It is found that, from an overall mean-rate perspective, both overlay and underlay bring performance improvements (vs. pure cellular). Third, the single-antenna hybrid network model is extended to multi-antenna transmission to study the interplay between massive MIMO (multi-input multiple-output) and underlaid D2D networking. The spectral efficiency of such multi-antenna hybrid networks is investigated under both perfect and imperfect channel state information (CSI) assumptions. Compared to the case without D2D, there is a loss in cellular spectral efficiency due to D2D underlay. With perfect CSI, the loss can be completely overcome if the number of canceled D2D interfering signals is scaled appropriately. With imperfect CSI, in addition to pilot contamination, a new asymptotic underlay contamination effect arises. Finally, motivated by the fact that transmissions in D2D discovery are usually not or imperfectly synchronized, this dissertation studies the effect of asynchronous multicarrier transmission and proposes a tractable signal-to-interference-plus-noise ratio (SINR) model. The proposed model is used to analytically characterize system-level performance of asynchronous wireless networks. The loss from lack of synchronization is quantified, and several solutions are proposed and compared to mitigate the loss.Electrical and Computer Engineerin
Robust transmission design for multicell D2D underlaid cellular networks
This paper investigates the robust transmission design (RTD) of a multicell device-to-device (D2D) underlaid cellular network with imperfect channel state information (CSI). The bounded model is adopted to characterize the CSI impairment and the aim is to maximize the worst-case sum rate of the system. To protect cellular communications, it is assumed that the interference from all D2D transmitters to each base station (BS) is power-limited. It is first shown that the worst-case signal-to-interference-plus-noise ratio (SINR) of each D2D link can be obtained directly, while that of cellular links cannot be similarly found since the channel estimation error vectors of cellular links are coupled in the SINR expressions. To solve the nonconvex problem, the objective function of the original problem is replaced with its lower bound, and the resulted problem is decomposed into multiple semidefinite programming (SDP) subproblems, which are convex and have computationally efficient solutions. An iterative RTD algorithm is then proposed to obtain a suboptimal solution. Simulation results show that D2D communication can significantly increase the performance of the conventional cellular systems while causing tolerable interference to cellular users. In addition, the proposed RTD algorithm outperforms the conventional nonrobust transmission design greatly in terms of network spectral efficiency
Performance Evaluation and Enhancement in 5G Networks : A Stochastic Geometry Approach
PhDThe deployment of heterogeneous networks (HetNets), in which low power nodes (LPNs)
and high power nodes (HPNs) coexist, has become a promising solution for extending
coverage and increasing capacity in wireless networks. Meanwhile, several advanced technologies
such as massive multi-input multi-output (MIMO), cloud radio access networks
(C-RAN) and device-to-device (D2D) communications have been proposed as competent
candidates for supporting the next generation (5G) network. Since single technology
cannot solely achieve the envisioned 5G requirements, the e ect of integrating multiple
technologies in one system is worth to be investigated. In this thesis, a thoroughly theoretical
analysis is conducted to evaluate the network performance in di erent scenarios,
where two or more 5G techniques are employed.
First, the downlink performance of massive MIMO enabled HetNets is fully evaluated.
The exact and asymptotic expressions for the probability of a user being associated
with a macro cell or a small cell are presented. The analytical expressions for the
spectrum e ciency (SE) and energy e ciency (EE) in the K-tier network are also derived.
The analysis reveals that the implementation of massive MIMO in the macro cell can
considerably improve the network performance and decrease the demands for small cells
in HetNets, which simpli es the network deployment.
Then, the downlink performance of a massive MIMO enabled heterogeneous C-RAN is
investigated. The exact expressions for the SE and EE of the remote radio heads (RRHs)
tier and a tractable approximation approach for evaluating the SE and EE of the macrocell
tier are obtained. Numerical results collaborate the analysis and prove that massive
MIMO with dense deployment of RRHs can signi cantly enhance the performance of
heterogeneous C-RAN theoretically. Next, the uplink performance of massive MIMO enabled HetNets is exploited with interference
management via derived SE and EE expressions. The numerical results show that
the uplink performance in the massive MIMO macrocells can be signi cantly improved
through uplink power control in the small cells, while more uplink transmissions in the
macrocells have mild adverse e ect on the uplink performance of the small cells. In addition,
the SE and EE of the massive MIMO macrocells with heavier load can be improved
by expanding the small cell range.
Lastly, the uplink performance of the D2D underlaid massive MIMO network is investigated
and a novel D2D power control scheme is proposed. The average uplink achievable
SE and EE expressions for the cellular and D2D are derived and results demonstrate
that the proposed power control can e ciently mitigate the interference from the D2D.
Moreover, the D2D scale properties are obtained, which provide the su cient conditions
for achieving the anticipated SE. The results demonstrate that there exists the optimal
D2D density for maximizing the area SE of D2D tier. In addition, the achievable EE of
a cellular user can be comparable to that of a D2D user.
Stochastic geometry is applied to model all of the systems mentioned above. Monte
Carlo simulations are also developed and conducted to validate the derived expressions
and the theoretical analysis
- …