Physical-layer Network Coding for Cooperative Wireless Networks

As a newly-emerged paradigm in the networking techniques, physical-layer network coding (PNC) [1, 5] takes advantage of the superimposition of the electromagnetic waves, and embraces the interference which was typically deemed as harmful, by performing exclusive-or mapping. Therefore, the spectral efficiency is utilized, which in turn boosts the network throughput. In the classical 2-way relay channel (2-WRC), PNC only spends two channel uses for the bi-directional data exchange. However, one challenge for such a paradigm is that the singular fading states in the uplink of 2-WRC, might result in ambiguity for decoding the network coded symbol. One major focus of this thesis is to address the fading issue for PNC in the 2-WRC. Another fundamental challenge for PNC is to extend the PNC from the 2-WRC to a multi-user network such as the multi-way relay channel (M-WRC) or the hierarchical wireless network (HWN). To tackle these two fundamental challenges of PNC, several solutions are proposed in this thesis, which are summarized as follows: First, we introduce two efficient fading correction strategies, i.e., the rotationally-invariant coded modulation and the soft-bit correction. Second, a novel multilevel coded linear PNC scheme with extended mapping for the Rayleigh fading 2-WRC is proposed. Third, we design a new type of linear PNC for the Rayleigh fading 2-WRC, based on rings. We refer to such design as linear PNC over the hybrid finite ring. Fourth, we redesign PNC for the HWN, which facilitates the multi-user data exchange. To combat the co-channel interference introduced by multi-user data exchange, two efficient interference exploitation strategies based on network coding are proposed: 1) PNC with joint decoding; and 2) analogue network coding with interference-aware maximum likelihood detection. Finally, we propose a multilevel coded LPNC for the data exchange in the M-WRC

Physical-Layer Cooperation in Coded OFDM Relaying Systems

Mobile communication systems nowadays require ever-increasing data rate and coverage of wide areas. One promising approach to achieve this goal is the application of cooperative communications enabled by introducing intermediate nodes known as relays to support the transmission between terminals. By processing and forwarding the receive message at the relays, the path-loss effect between the source and the destination is mitigated. One major limit factor for relay assisted communications is that a relay cannot transmit and receive using the same physical resources. Therefore, a half-duplex constraint is commonly assumed resulting in halved spectral efficiency. To combat this drawback, two-way relaying is introduced, where two sources exchange information with each. On the other hand, due to the physical limitation of the relays, e.g., wireless sensor nodes, it's not possible to implement multiple antennas at one relay, which prohibits the application of multiple-input multiple-output (MIMO) techniques. However, when treating multiple relays as a cluster, a virtual antenna array is formed to perform MIMO techniques in a distributed manner. %This thesis aims at designing efficient one-way and two-way relaying schemes. Specifically, existing schemes from the literature are improved and new schemes are developed with the emphasis on coded orthogonal frequency division multiplexing (OFDM) transmissions. Of special interest is the application of physical-layer network coding (PLNC) for two-phase two-way relaying. In this case, a network coded message is estimated from the superimposed receive signal at the relay using PLNC schemes. The schemes are investigated based on a mutual information analysis and their performance are improved by a newly proposed phase control strategy. Furthermore, performance degradation due to system asynchrony is mitigated depending on different PLNC schemes. When multiple relays are available, novel cooperation schemes allowing information exchange within the relay cluster are proposed that facilitate distributed MIMO reception and transmission. Additionally, smart signaling approaches are presented to enable the cooperation at different levels with the cooperation overhead taken into account adequately in system performance evaluation

Two–Way Relaying Communications with OFDM and BICM/BICM-ID

Relay-aided communication methods have gained strong interests in academic community and been applied in various wireless communication scenarios. Among different techniques in relay-aided communication system, two-way relaying communication (TWRC) achieves the highest spectral efficiency due to its bi-directional transmission capability. Nevertheless, different from the conventional point-to-point communication system, TWRC suffers from detection quality degradation caused by the multiple-access interference (MAI). In addition, because of the propagation characteristics of wireless channels, fading and multipath dispersion also contribute strongly to detection errors. Therefore, this thesis is mainly concerned with designing transmission and detection schemes to provide good detection quality of TWRC while taking into account the negative impacts of fading, multipath dispersion and multiple-access interference. First, a TWRC system operating over multipath fading channels is considered and orthogonal frequency-division multiplexing (OFDM) is adopted to handle the inter-symbol interference (ISI) caused by the multipath dispersion. In particular, adaptive physical-layer network coding (PNC) is employed to address the MAI issue. By analyzing the detection error probability, various adaptive PNC schemes are discussed for using with OFDM and the scheme achieving the best trade-off among performance, overhead and complexity is suggested. In the second part of the thesis, the design of distributed precoding in TWRC using OFDM under multipath fading channels is studied. The objective is to design a distributed precoding scheme which can alleviate MAI and achieve multipath diversity to combat fading. Specifically, three types of errors are introduced when analyzing the error probability in the multiple access (MA) phase. Through analysis and simulation, the scheme that performs precoding in both time and frequency domains is demonstrated to achieve the maximum diversity gains under all types of errors. Finally, the last part of the thesis examines a communication system incorporating forward error correction (FEC) codes. Specifically, bit-interleaved code modulation (BICM) without and with iterative decoding (BICM-ID) are investigated in a TWRC system. Distributed linear constellation precoding (DLCP) is applied to handle MAI and the design of DLCP in a TWRC system using BICM/BICM-ID is discussed. Taking into account the multiple access channel from the terminal nodes to the relay node, decoding based on the quaternary code representation is introduced. Several error probability bounds are derived to aid in the design of DLCP. Based on these bounds, optimal parameters of DLCP are obtained through analysis and computer search. It is also found that, by combining XORbased network coding with successful iterative decoding, the MAI is eliminated and thus DLCP is not required in a BICM-ID system

Multiantenna analog network coding for multihop wireless networks

This paper proposes a two-phase minimum mean-square-error bidirectional amplify-and forward (MMSE-BAF) relaying protocol to allow two sources exchange independent messages via a relay node equipped with multiple antennas. MMSE-BAF performs a joint linear MMSE filtering of the received signal after the multiple access phase before amplifying and forwarding the filtered signal using a single transmit antenna, possibly through a specific antenna selection procedure, during the broadcast phase. The proposed protocol extends upon the so-called analog network coding schemes in the literature in that it inherently exploits the multiple antennas at the relay station to reduce the noise enhancement typical of an AF protocol, and can also compensate for link imbalances between the relay and the sources and is agnostic to sources' modulation and coding schemes. We derive the instantaneous signal-to-noise ratio expressions for the received signal by the sources in the downlink and provide extensive linklevel simulations for the MMSE-BAF protocol subject to both frequency flat and selective fading. Furthermore, we pinpoint the modifications to be incorporated into the IEEE 802.16e orthogonal-frequency-division multiple access (OFDMA) cellular standard (mobile WiMax) to enable support of multiantenna bidirectional communications and show that MMSE-BAF is a viable solution within that framework

Performance Analysis of Modern Communication System in Realistic Environment

Multiple Input Multiple Output (MIMO) technique is one of the effective techniques to combat against fading in wireless communication system. In this thesis, based upon that, performance is evaluated for MIMO system while considering some prac­ tical scenario which was ignored for simplicity in previous works. Apart from that it is well known now a days that co-operative communication has created a new class of communication technique in wireless communication arena. It is also investigated in this thesis work how the system performs while implementing co-operative commu­nication system in an industrial application where the environment is much different from the traditional environment due to the presence of Impulse Noise. Later co­ operative communication system and the diversity technique are blended together and the performance of such system is analyzed theoretically as well as in simulation. Results acquired in this thesis will be used to bring forth publication

Physical-layer network coding for two-way relay channels

Le codage réseau est apparu comme une technique alternative au routage au niveau de la couche réseau permettant d'améliorer le débit et d'optimiser l'utilisation de la capacité du réseau. Récemment, le codage réseau a été appliqué au niveau de la couche physique des réseaux sans-fil pour profiter de la superposition naturelle des signaux effectuée par le lien radio. Le codage réseau peut être vue comme un traitement interne du réseau pour lequel différentes techniques de relayage peuvent être utilisées. Cette thèse étudie un ensemble de traitements ayant des compromis variés en terme de performance et complexité. Nous considérons le canal bidirectionnel à relais, un modèle de canal de communication typique dans les réseaux coopératifs, où deux terminaux s'échangent mutuellement des messages par l'intermédiaire d'un relais. La communication se déroule en deux phases, une phase à accès multiple et une phase de broadcast. Pour ce scénario, nous analysons, dans une première partie, une stratégie de "decode-and-forward". Nous considérons, pour cette étude, des alphabets de taille finie et nous calculons les probabilités moyennes d'erreur de bout-en-bout en se basant sur la métrique d'exposant d'erreur du codage aléatoire. Puis, nous dérivons les régions des débits atteignables par rapport à une probabilité d'erreur maximale tolérable au niveau de chaque nœud. Dans une deuxième partie de la thèse, nous proposons deux schémas de codage réseau pratiques, avec complexité réduite, qui se basent sur la stratégie de relayage "compress-and-forward" (CF). Le premier schéma utilise un codage en réseau de points imbriqués (nested lattices). Le deuxième schéma est une version améliorée qui permet d'atteindre des débits de données supérieurs pour l'utilisateur qui a les meilleures conditions canal. Nous construisons les régions des débits atteignables par les deux schémas proposés tout en optimisant la répartition du temps alloué à chacune des deux phases de transmission. Après l'étude du régime asymptotique, nous analysons le schéma de codage CF avec des réseaux de points de dimension finie. Nous nous concentrons sur le problème de la transmission analogique où la distorsion est optimisée. Enfin, nous étudions l'application d'un schéma de codage, basé sur la stratégie CF avec des réseaux de points imbriqués, pour le canal bidirectionnel à canaux parallèles. Ainsi, nous présentons deux régions de débits atteignables selon la technique de traitement, conjoint ou séparé, des sous-canaux par le relais.Network coding has emerged as an alternative technique to routing that enhances the throughput at the network layer. Recently, network coding has been applied at the physical layer to take advantage of the natural signal superposition that occurs in the radio link. In this context, the physical-layer network coding can be seen as an in-network processing strategy for which multiple forwarding schemes can be proposed. This thesis investigates a set of processing schemes tailored to the network coding at the physical layer with various compromises between performance and complexity. We consider a two-way relay channel, a typical communication system in cooperative networks, where two terminals communicate with each other via a relay node. This communication occurs during two transmission phases, namely a multiple-access phase and a broadcast phase. For TWRC scenario, we first analyze a decode-and-forward strategy with finite size alphabets. We calculate the end-to-end average error probabilities based on random coding error exponents. Then, we derive the achievable rate regions with respect to a maximal probability of error allowed at each terminal. Next, we propose two low-complexity and practical schemes based on compress-and-forward relaying strategy. The first scheme employs nested lattice coding. The second is an improved version which enables higher data rates for the user experiencing the best channel conditions. We present an information-theoretic framework to reconstruct the achievable rate regions of both schemes by considering optimal time division between both transmission phases. After the asymptotic regime analysis, we study single-layer lattice coding scheme with finite dimension lattices. We focus on the analog transmission problem where the distortion is optimized. Finally, we investigate single-layer lattice coding scheme for parallel Gaussian two-way relay channel. We present two achievable rate regions based on whether the relay processes all the sub-channels jointly or separately.PARIS11-SCD-Bib. électronique (914719901) / SudocSudocFranceF