The Effect Of Hot Spots On The Performance Of Mesh--Based Networks

Direct network performance is affected by different design parameters which include number of virtual channels, number of ports, routing algorithm, switching technique, deadlock handling technique, packet size, and buffer size. Another factor that affects network performance is the traffic pattern. In this thesis, we study the effect of hotspot traffic on system performance. Specifically, we study the effect of hotspot factor, hotspot number, and hot spot location on the performance of mesh-based networks. Simulations are run on two network topologies, both the mesh and torus. We pay more attention to meshes because they are widely used in commercial machines. Comparisons between oblivious wormhole switching and chaotic packet switching are reported. Overall packet switching proved to be more efficient in terms of throughput when compared to wormhole switching. In the case of uniform random traffic, it is shown that the differences between chaotic and oblivious routing are indistinguishable. Networks with low number of hotspots show better performance. As the number of hotspots increases network latency tends to increase. It is shown that when the hotspot factor increases, performance of packet switching is better than that of wormhole switching. It is also shown that the location of hotspots affects network performance particularly with the oblivious routers since their achieved latencies proved to be more vulnerable to changes in the hotspot location. It is also shown that the smaller the size of the network the earlier network saturation occurs. Further, it is shown that the chaos router’s adaptivity is useful in this case. Finally, for tori, performance is not greatly affected by hotspot presence. This is mostly due to the symmetric nature of tori

New Fault Tolerant Multicast Routing Techniques to Enhance Distributed-Memory Systems Performance

Distributed-memory systems are a key to achieve high performance computing and the most favorable architectures used in advanced research problems. Mesh connected multicomputer are one of the most popular architectures that have been implemented in many distributed-memory systems. These systems must support communication operations efficiently to achieve good performance. The wormhole switching technique has been widely used in design of distributed-memory systems in which the packet is divided into small flits. Also, the multicast communication has been widely used in distributed-memory systems which is one source node sends the same message to several destination nodes. Fault tolerance refers to the ability of the system to operate correctly in the presence of faults. Development of fault tolerant multicast routing algorithms in 2D mesh networks is an important issue. This dissertation presents, new fault tolerant multicast routing algorithms for distributed-memory systems performance using wormhole routed 2D mesh. These algorithms are described for fault tolerant routing in 2D mesh networks, but it can also be extended to other topologies. These algorithms are a combination of a unicast-based multicast algorithm and tree-based multicast algorithms. These algorithms works effectively for the most commonly encountered faults in mesh networks, f-rings, f-chains and concave fault regions. It is shown that the proposed routing algorithms are effective even in the presence of a large number of fault regions and large size of fault region. These algorithms are proved to be deadlock-free. Also, the problem of fault regions overlap is solved. Four essential performance metrics in mesh networks will be considered and calculated; also these algorithms are a limited-global-information-based multicasting which is a compromise of local-information-based approach and global-information-based approach. Data mining is used to validate the results and to enlarge the sample. The proposed new multicast routing techniques are used to enhance the performance of distributed-memory systems. Simulation results are presented to demonstrate the efficiency of the proposed algorithms

Adaptive turn-prohibition routing algorithm for the networks of workstations

Deadlock occurrence is a critical problem for any computer network. Various solutions have been proposed over last two decades to solve problem of deadlocks in networks using different routing schemes, like up/down routing algorithm used in Myrinet switches. However, most of existing approaches for deadlock-free routing either try to eliminate any possibility of deadlock occurrence, which can result in putting extra restrictions on the routing in the networks or put no restrictions on routing, which leads to other approach namely deadlock recovery. In this thesis emphasis is on developing hybrid approach for routing in wormhole networks, wherein some prohibition is imposed on routing along with some kind of deadlock recovery. This adaptive approach allows changing the amount of routing restrictions depending on network traffic, thus providing a flexible method to achieve better network performance compared to the existing techniques. The main idea of the proposed method consists in the sequential selections of some turns, which are prohibited to be selected during routing. After each additional turn is added, the probability of deadlock occurrence decreases gradually. Cost formula is proposed to estimate cost of implementing both strategies in a network which is basis of proposed adaptive model

Embedded dynamic programming networks for networks-on-chip

PhD ThesisRelentless technology downscaling and recent technological advancements in three dimensional integrated circuit (3D-IC) provide a promising prospect to realize heterogeneous system-on-chip (SoC) and homogeneous chip multiprocessor (CMP) based on the networks-onchip (NoCs) paradigm with augmented scalability, modularity and performance. In many cases in such systems, scheduling and managing communication resources are the major design and implementation challenges instead of the computing resources. Past research efforts were mainly focused on complex design-time or simple heuristic run-time approaches to deal with the on-chip network resource management with only local or partial information about the network. This could yield poor communication resource utilizations and amortize the benefits of the emerging technologies and design methods. Thus, the provision for efficient run-time resource management in large-scale on-chip systems becomes critical. This thesis proposes a design methodology for a novel run-time resource management infrastructure that can be realized efficiently using a distributed architecture, which closely couples with the distributed NoC infrastructure. The proposed infrastructure exploits the global information and status of the network to optimize and manage the on-chip communication resources at run-time. There are four major contributions in this thesis. First, it presents a novel deadlock detection method that utilizes run-time transitive closure (TC) computation to discover the existence of deadlock-equivalence sets, which imply loops of requests in NoCs. This detection scheme, TC-network, guarantees the discovery of all true-deadlocks without false alarms in contrast to state-of-the-art approximation and heuristic approaches. Second, it investigates the advantages of implementing future on-chip systems using three dimensional (3D) integration and presents the design, fabrication and testing results of a TC-network implemented in a fully stacked three-layer 3D architecture using a through-silicon via (TSV) complementary metal-oxide semiconductor (CMOS) technology. Testing results demonstrate the effectiveness of such a TC-network for deadlock detection with minimal computational delay in a large-scale network. Third, it introduces an adaptive strategy to effectively diffuse heat throughout the three dimensional network-on-chip (3D-NoC) geometry. This strategy employs a dynamic programming technique to select and optimize the direction of data manoeuvre in NoC. It leads to a tool, which is based on the accurate HotSpot thermal model and SystemC cycle accurate model, to simulate the thermal system and evaluate the proposed approach. Fourth, it presents a new dynamic programming-based run-time thermal management (DPRTM) system, including reactive and proactive schemes, to effectively diffuse heat throughout NoC-based CMPs by routing packets through the coolest paths, when the temperature does not exceed chip’s thermal limit. When the thermal limit is exceeded, throttling is employed to mitigate heat in the chip and DPRTM changes its course to avoid throttled paths and to minimize the impact of throttling on chip performance. This thesis enables a new avenue to explore a novel run-time resource management infrastructure for NoCs, in which new methodologies and concepts are proposed to enhance the on-chip networks for future large-scale 3D integration.Iraqi Ministry of Higher Education and Scientific Research (MOHESR)

Tree-structured small-world connected wireless network-on-chip with adaptive routing

Traditional Network-on-Chip (NoC) systems comprised of many cores suffer from debilitating bottlenecks of latency and significant power dissipation due to the overhead inherent in multi-hop communication. In addition, these systems remain vulnerable to malicious circuitry incorporated into the design by untrustworthy vendors in a world where complex multi-stage design and manufacturing processes require the collective specialized services of a variety of contractors. This thesis proposes a novel small-world tree-based network-on-chip (SWTNoC) structure designed for high throughput, acceptable energy consumption, and resiliency to attacks and node failures resulting from the insertion of hardware Trojans. This tree-based implementation was devised as a means of reducing average network hop count, providing a large degree of local connectivity, and effective long-range connectivity by means of a novel wireless link approach based on carbon nanotube (CNT) antenna design. Network resiliency is achieved by means of a devised adaptive routing algorithm implemented to work with TRAIN (Tree-based Routing Architecture for Irregular Networks). Comparisons are drawn with benchmark architectures with optimized wireless link placement by means of the simulated annealing (SA) metaheuristic. Experimental results demonstrate a 21% throughput improvement and a 23% reduction in dissipated energy per packet over the closest competing architecture. Similar trends are observed at increasing system sizes. In addition, the SWTNoC maintains this throughput and energy advantage in the presence of a fault introduced into the system. By designing a hierarchical topology and designating a higher level of importance on a subset of the nodes, much higher network throughput can be attained while simultaneously guaranteeing deadlock freedom as well as a high degree of resiliency and fault-tolerance

Analysis of wormhole routings in cayley graphs of permutation groups.

Over a decade, a new class of switching technology, called wormhole routing, has been investigated in the multicomputer interconnection network field. Several classes of wormhole routing algorithms have been proposed. Most of the algorithms have been centered on the traditional binary hypercube, k-ary n-cube mesh, and torus networks. In the design of a wormhole routing algorithm, deadlock avoidance scheme is the main concern. Recently, new classes of networks called Cayley graphs of permutation groups are considered very promising alternatives. Although proposed Cayley networks have superior topological properties over the traditional network topologies, the design of the deadlock-free wormhole routing algorithm in these networks is not simple. In this dissertation, we investigate deadlock free wormhole routing algorithms in the several classes of Cayley networks, such as complete-transposition and star networks. We evaluate several classes of routing algorithms on these networks, and compare the performance of each algorithm to the simulation study. Also, the performances of these networks are compared to the traditional networks. Through extensive simulation we found that adaptive algorithm outperformed deterministic algorithm in general with more virtual channels. On the network performance comparison, the complete transposition network showed the best performance among the similar sized networks, and the binary hypercube performed better compared to the star graph

Achieving Functional Correctness in Large Interconnect Systems.

In today's semi-conductor industry, large chip-multiprocessors and systems-on-chip are being developed, integrating a large number of components on a single chip. The sheer size of these designs and the intricacy of the communication patterns they exhibit have propelled the development of network-on-chip (NoC) interconnects as the basis for the communication infrastructure in these systems. Faced with the interconnect's growing size and complexity, several challenges hinder its effective validation. During the interconnect's development, the functional verification process relies heavily on the use of emulation and post-silicon validation platforms. However, detecting and debugging errors on these platforms is a difficult endeavour due to the limited observability, and in turn the low verification capabilities, they provide. Additionally, with the inherent incompleteness of design-time validation efforts, the potential of design bugs escaping into the interconnect of a released product is also a concern, as these bugs can threaten the viability of the entire system. This dissertation provides solutions to enable the development of functionally correct interconnect designs. We first address the challenges encountered during design-time verification efforts, by providing two complementary mechanisms that allow emulation and post-silicon verification frameworks to capture a detailed overview of the functional behaviour of the interconnect. Our first solution re-purposes the contents of in-flight traffic to log debug data from the interconnect's execution. This approach enables the validation of the interconnect using synthetic traffic workloads, while attaining over 80% observability of the routes followed by packets and capturing valuable debugging information. We also develop an alternative mechanism that boosts observability by taking periodic snapshots of execution, thus extending the verification capabilities to run both synthetic traffic and real-application workloads. The collected snapshots enhance detection and debugging support, and they provide observability of over 50% of packets and reconstructs at least half of each of their routes. Moreover, we also develop error detection and recovery solutions to address the threat of design bugs escaping into the interconnect's runtime operation. Our runtime techniques can overcome communication errors without needing to store replicate copies of all in-flight packets, thereby achieving correctness at minimal area costsPhDComputer Science and EngineeringUniversity of Michigan, Horace H. Rackham School of Graduate Studieshttp://deepblue.lib.umich.edu/bitstream/2027.42/116741/1/rawanak_1.pd