142 research outputs found
Achievable Rate and Modulation for Bandlimited Channels with Oversampling and 1-Bit Quantization at the Receiver
Sustainably realizing applications of the future with high performance demands requires that energy efficiency becomes a central design criterion for the entire system. For example, the power consumption of the analog-to-digital converter (ADC) can become a major factor when transmitting at large bandwidths and carrier frequencies, e.g., for ultra-short range high data rate communication. The consumed energy per conversion step increases with the sampling rate such that high resolution ADCs become unfeasible in the sub-THz regime at the very high sampling rates required. This makes signaling schemes adapted to 1-bit quantizers a promising alternative. We therefore quantify the performance of bandlimited 1-bit quantized wireless communication channels using techniques like oversampling and faster-than-Nyquist (FTN) signaling to compensate for the loss of achievable rate.
As a limiting case, we provide bounds on the mutual information rate of the hard bandlimited 1-bit quantized continuous-time – i.e., infinitely oversampled – additive white Gaussian noise channel in the mid-to-high signal-to-noise ratio (SNR) regime. We derive analytic expressions using runlength encoded input signals. For real signals the maximum value of the lower bound on the spectral efficiency in the high-SNR limit was found to be approximately 1.63 bit/s/Hz.
Since in practical scenarios the oversampling ratio remains finite, we derive bounds on the achievable rate of the bandlimited oversampled discrete-time channel. These bounds match the results of the continuous-time channel remarkably well. We observe spectral efficiencies up to 1.53 bit/s/Hz in the high-SNR limit given hard bandlimitation. When excess bandwidth is tolerable, spectral efficiencies above 2 bit/s/Hz per domain are achievable w.r.t. the 95 %-power containment bandwidth. Applying the obtained bounds to a bandlimited oversampled 1-bit quantized multiple-input multiple-output channel, we show the benefits when using appropriate power allocation schemes.
As a constant envelope modulation scheme, continuous phase modulation is considered in order to relieve linearity requirements on the power amplifier. Noise-free performance limits are investigated for phase shift keying (PSK) and continuous phase frequency shift keying (CPFSK) using higher-order modulation alphabets and intermediate frequencies. Adapted waveforms are designed that can be described as FTN-CPFSK. With the same spectral efficiency in the high-SNR limit as PSK and CPFSK, these waveforms provide a significantly improved bit error rate (BER) performance. The gain in SNR required for achieving a certain BER can be up to 20 dB.Die nachhaltige Realisierung von zukünftigen Übertragungssystemen mit hohen Leistungsanforderungen erfordert, dass die Energieeffizienz zu einem zentralen Designkriterium für das gesamte System wird. Zum Beispiel kann die Leistungsaufnahme des Analog-Digital-Wandlers (ADC) zu einem wichtigen Faktor bei der Übertragung mit großen Bandbreiten und Trägerfrequenzen werden, z. B. für die Kommunikation mit hohen Datenraten über sehr kurze Entfernungen. Die verbrauchte Energie des ADCs steigt mit der Abtastrate, so dass hochauflösende ADCs im Sub-THz-Bereich bei den erforderlichen sehr hohen Abtastraten schwer einsetzbar sind. Dies macht Signalisierungsschemata, die an 1-Bit-Quantisierer angepasst sind, zu einer vielversprechenden Alternative. Wir quantifizieren daher die Leistungsfähigkeit von bandbegrenzten 1-Bit-quantisierten drahtlosen Kommunikationssystemen, wobei Techniken wie Oversampling und Faster-than-Nyquist (FTN) Signalisierung eingesetzt werden, um den durch Quantisierung verursachten Verlust der erreichbaren Rate auszugleichen.
Wir geben Grenzen für die Transinformationsrate des Extremfalls eines strikt bandbegrenzten 1-Bit quantisierten zeitkontinuierlichen – d.h. unendlich überabgetasteten – Kanals mit additivem weißen Gauß’schen Rauschen bei mittlerem bis hohem Signal-Rausch-Verhältnis (SNR) an. Wir leiten analytische Ausdrücke basierend auf lauflängencodierten Eingangssignalen ab. Für reelle Signale ist der maximale Wert der unteren Grenze der spektralen Effizienz im Hoch-SNR-Bereich etwa 1,63 Bit/s/Hz.
Da die Überabtastrate in praktischen Szenarien endlich bleibt, geben wir Grenzen für die erreichbare Rate eines bandbegrenzten, überabgetasteten zeitdiskreten Kanals an. Diese Grenzen stimmen mit den Ergebnissen des zeitkontinuierlichen Kanals bemerkenswert gut überein. Im Hoch-SNR-Bereich sind spektrale Effizienzen bis zu 1,53 Bit/s/Hz bei strikter Bandbegrenzung möglich. Wenn Energieanteile außerhalb des Frequenzbandes tolerierbar sind, können spektrale Effizienzen über 2 Bit/s/Hz pro Domäne – bezogen auf die Bandbreite, die 95 % der Energie enthält – erreichbar sein.
Durch die Anwendung der erhaltenen Grenzen auf einen bandbegrenzten überabgetasteten 1-Bit quantisierten Multiple-Input Multiple-Output-Kanal zeigen wir Vorteile durch die Verwendung geeigneter Leistungsverteilungsschemata.
Als Modulationsverfahren mit konstanter Hüllkurve betrachten wir kontinuierliche Phasenmodulation, um die Anforderungen an die Linearität des Leistungsverstärkers zu verringern. Beschränkungen für die erreichbare Datenrate bei rauschfreier Übertragung auf Zwischenfrequenzen mit Modulationsalphabeten höherer Ordnung werden für Phase-shift keying (PSK) and Continuous-phase frequency-shift keying (CPFSK) untersucht. Weiterhin werden angepasste Signalformen entworfen, die als FTN-CPFSK beschrieben werden können. Mit der gleichen spektralen Effizienz im Hoch-SNR-Bereich wie PSK und CPFSK bieten diese Signalformen eine deutlich verbesserte Bitfehlerrate (BER). Die Verringerung des erforderlichen SNRs zur Erreichung einer bestimmten BER kann bis zu 20 dB betragen
One-Bit Massive MIMO: Channel Estimation and High-Order Modulations
We investigate the information-theoretic throughout achievable on a fading
communication link when the receiver is equipped with one-bit analog-to-digital
converters (ADCs). The analysis is conducted for the setting where neither the
transmitter nor the receiver have a priori information on the realization of
the fading channels. This means that channel-state information needs to be
acquired at the receiver on the basis of the one-bit quantized channel outputs.
We show that least-squares (LS) channel estimation combined with joint pilot
and data processing is capacity achieving in the single-user,
single-receive-antenna case.
We also investigate the achievable uplink throughput in a massive
multiple-input multiple-output system where each element of the antenna array
at the receiver base-station feeds a one-bit ADC. We show that LS channel
estimation and maximum-ratio combining are sufficient to support both multiuser
operation and the use of high-order constellations. This holds in spite of the
severe nonlinearity introduced by the one-bit ADCs
A General Framework for Transmission with Transceiver Distortion and Some Applications
A general theoretical framework is presented for analyzing information
transmission over Gaussian channels with memoryless transceiver distortion,
which encompasses various nonlinear distortion models including transmit-side
clipping, receive-side analog-to-digital conversion, and others. The framework
is based on the so-called generalized mutual information (GMI), and the
analysis in particular benefits from the setup of Gaussian codebook ensemble
and nearest-neighbor decoding, for which it is established that the GMI takes a
general form analogous to the channel capacity of undistorted Gaussian
channels, with a reduced "effective" signal-to-noise ratio (SNR) that depends
on the nominal SNR and the distortion model. When applied to specific
distortion models, an array of results of engineering relevance is obtained.
For channels with transmit-side distortion only, it is shown that a
conventional approach, which treats the distorted signal as the sum of the
original signal part and a uncorrelated distortion part, achieves the GMI. For
channels with output quantization, closed-form expressions are obtained for the
effective SNR and the GMI, and related optimization problems are formulated and
solved for quantizer design. Finally, super-Nyquist sampling is analyzed within
the general framework, and it is shown that sampling beyond the Nyquist rate
increases the GMI for all SNR. For example, with a binary symmetric output
quantization, information rates exceeding one bit per channel use are
achievable by sampling the output at four times the Nyquist rate.Comment: 32 pages (including 4 figures, 5 tables, and auxiliary materials);
submitted to IEEE Transactions on Communication
On distributed coding, quantization of channel measurements and faster-than-Nyquist signaling
This dissertation considers three different aspects of modern digital communication
systems and is therefore divided in three parts.
The first part is distributed coding. This part deals with source and source-
channel code design issues for digital communication systems with many transmitters
and one receiver or with one transmitter and one receiver but with side information at
the receiver, which is not available at the transmitter. Such problems are attracting
attention lately, as they constitute a way of extending the classical point-to-point
communication theory to networks. In this first part of this dissertation, novel source
and source-channel codes are designed by converting each of the considered distributed
coding problems into an equivalent classical channel coding or classical source-channel
coding problem. The proposed schemes come very close to the theoretical limits and
thus, are able to exhibit some of the gains predicted by network information theory.
In the other two parts of this dissertation classical point-to-point digital com-
munication systems are considered. The second part is quantization of coded chan-
nel measurements at the receiver. Quantization is a way to limit the accuracy of
continuous-valued measurements so that they can be processed in the digital domain.
Depending on the desired type of processing of the quantized data, different quantizer
design criteria should be used. In this second part of this dissertation, the quantized
received values from the channel are processed by the receiver, which tries to recover
the transmitted information. An exhaustive comparison of several quantization cri-
teria for this case are studied providing illuminating insight for this quantizer design
problem.
The third part of this dissertation is faster-than-Nyquist signaling. The Nyquist
rate in classical point-to-point bandwidth-limited digital communication systems is
considered as the maximum transmission rate or signaling rate and is equal to twice
the bandwidth of the channel. In this last part of the dissertation, we question this
Nyquist rate limitation by transmitting at higher signaling rates through the same
bandwidth. By mitigating the incurred interference due to the faster-than-Nyquist
rates, gains over Nyquist rate systems are obtained
Error control techniques for satellite and space communications
The results included in the Ph.D. dissertation of Dr. Fu Quan Wang, who was supported by the grant as a Research Assistant from January 1989 through December 1992 are discussed. The sections contain a brief summary of the important aspects of this dissertation, which include: (1) erasurefree sequential decoding of trellis codes; (2) probabilistic construction of trellis codes; (3) construction of robustly good trellis codes; and (4) the separability of shaping and coding
- …