329 research outputs found
IEEE 802.11n Physical Layer Implementation on Field Programmable Gate Array
Register transfer level (RTL) development is a time cost step that requires high diligence and fidelity to get the valid interpretation of abstraction function of digital circuit. In this research, we introduce and prove that Model-Based Design Process (MBDP) is an effective and efficient way to develop a RTL complex system such as wireless communication. Using MBDP flow, we interpret, develop, and verify the physical layer RTL of a new standard that ratified on the end 2009, i.e. IEEE 802.11n wireless local area network (WLAN). The result of this research is a prototyping FPGA StratixII EP2S180 that has properly worked as a 2x2 MIMO WLAN with maximum throughput 144 Mbps.
AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing
The enormous success of advanced wireless devices is pushing the demand for
higher wireless data rates. Denser spectrum reuse through the deployment of
more access points per square mile has the potential to successfully meet the
increasing demand for more bandwidth. In theory, the best approach to density
increase is via distributed multiuser MIMO, where several access points are
connected to a central server and operate as a large distributed multi-antenna
access point, ensuring that all transmitted signal power serves the purpose of
data transmission, rather than creating "interference." In practice, while
enterprise networks offer a natural setup in which distributed MIMO might be
possible, there are serious implementation difficulties, the primary one being
the need to eliminate phase and timing offsets between the jointly coordinated
access points.
In this paper we propose AirSync, a novel scheme which provides not only time
but also phase synchronization, thus enabling distributed MIMO with full
spatial multiplexing gains. AirSync locks the phase of all access points using
a common reference broadcasted over the air in conjunction with a Kalman filter
which closely tracks the phase drift. We have implemented AirSync as a digital
circuit in the FPGA of the WARP radio platform. Our experimental testbed,
comprised of two access points and two clients, shows that AirSync is able to
achieve phase synchronization within a few degrees, and allows the system to
nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC
and higher layer aspects of a practical deployment. To the best of our
knowledge, AirSync offers the first ever realization of the full multiuser MIMO
gain, namely the ability to increase the number of wireless clients linearly
with the number of jointly coordinated access points, without reducing the per
client rate.Comment: Submitted to Transactions on Networkin
Analog MIMO Radio-over-Copper: Prototype and Preliminary Experimental Results
Analog Multiple-Input Multiple-Output Radio-over-Copper (A-MIMO-RoC) is an
effective all-analog FrontHaul (FH) architecture that exploits any pre-existing
Local Area Network (LAN) cabling infrastructure of buildings to distribute
Radio-Frequency (RF) signals indoors. A-MIMO-RoC, by leveraging a fully analog
implementation, completely avoids any dedicated digital interface by using a
transparent end-to-end system, with consequent latency, bandwidth and cost
benefits. Usually, LAN cables are exploited mainly in the low-frequency
spectrum portion, mostly due to the moderate cable attenuation and crosstalk
among twisted-pairs. Unlike current systems based on LAN cables, the key
feature of the proposed platform is to exploit more efficiently the huge
bandwidth capability offered by LAN cables, that contain 4 twisted-pairs
reaching up to 500 MHz bandwidth/pair when the length is below 100 m. Several
works proposed numerical simulations that assert the feasibility of employing
LAN cables for indoor FH applications up to several hundreds of MHz, but an
A-MIMO-RoC experimental evaluation is still missing. Here, we present some
preliminary results obtained with an A-MIMO-RoC prototype made by low-cost
all-analog/all-passive devices along the signal path. This setup demonstrates
experimentally the feasibility of the proposed analog relaying of MIMO RF
signals over LAN cables up to 400 MHz, thus enabling an efficient exploitation
of the LAN cables transport capabilities for 5G indoor applications.Comment: Part of this work has been accepted as a conference publication to
ISWCS 201
A low-complexity linear and iterative receiver architecture for multi-antenna communication systems
Thesis (M. Eng.)--Massachusetts Institute of Technology, Dept. of Electrical Engineering and Computer Science, 2004.Vita.Includes bibliographical references (leaves 60-62).Multi-antenna systems have been shown to significantly improve channel capacity in wireless environments. The focus of this thesis is on the design of low-complexity multi-antenna receiver architectures for communication networks and their demonstration in a real-time wireless environment. Our practical realization of an orthogonal frequency-division multi-antenna receiver is capable of several forms of linear and iterative detection. Our implementation is based on a division-free reformulation of standard minimum mean-squared-error detection algorithms and uses complex dot-products as the basic building blocks of a folded-pipelined architecture. This folded-pipelined architecture provides significant area savings over non-folded approaches. The demonstration of our receiver architecture is carried out on a rapid-prototyping FPGA communication system. This prototype is used to validate our design and complement theoretical and simulated results with real-time laboratory measurements in a typical office environment.by David Louis Milliner.M.Eng
Convergence of millimeter-wave and photonic interconnect systems for very-high-throughput digital communication applications
In the past, radio-frequency signals were commonly used for low-speed wireless electronic systems, and optical signals were used for multi-gigabit wired communication systems. However, as the emergence of new millimeter-wave technology introduces multi-gigabit transmission over a wireless radio-frequency channel, the borderline between radio-frequency and optical systems becomes blurred. As a result, there come ample opportunities to design and develop next-generation broadband systems to combine the advantages of these two technologies to overcome inherent limitations of various broadband end-to-end interconnect systems in signal generation, recovery, synchronization, and so on. For the transmission distances of a few centimeters to thousands of kilometers, the convergence of radio-frequency electronics and optics to build radio-over-fiber systems ushers in a new era of research for the upcoming very-high-throughput broadband services.
Radio-over-fiber systems are believed to be the most promising solution to the backhaul transmission of the millimeter-wave wireless access networks, especially for the license-free, very-high-throughput 60-GHz band. Adopting radio-over-fiber systems in access or in-building networks can greatly extend the 60-GHz signal reach by using ultra-low loss optical fibers. However, such high frequency is difficult to generate in a straightforward way. In this dissertation, the novel techniques of homodyne and heterodyne optical-carrier suppressions for radio-over-fiber systems are investigated and various system architectures are designed to overcome these limitations of 60-GHz wireless access networks, bringing the popularization of multi-gigabit wireless networks to become closer to the reality.
In addition to the advantages for the access networks, extremely high spectral efficiency, which is the most important parameter for long-haul networks, can be achieved by radio-over-fiber signal generation. As a result, the transmission performance of spectrally efficient radio-over-fiber signaling, including orthogonal frequency division multiplexing and orthogonal wavelength division multiplexing, is broadly and deeply investigated. On the other hand, radio-over-fiber is also used for the frequency synchronization that can resolve the performance limitation of wireless interconnect systems. A novel wireless interconnects assisted by radio-over-fiber subsystems is proposed in this dissertation.
In conclusion, multiple advantageous facets of radio-over-fiber systems can be found in various levels of end-to-end interconnect systems. The rapid development of radio-over-fiber systems will quickly change the conventional appearance of modern communications.PhDCommittee Chair: Gee-Kung Chang; Committee Member: Bernard Kippelen; Committee Member: Shyh-Chiang Shen; Committee Member: Thomas K. Gaylord; Committee Member: Umakishore Ramachandra
- …