Performance of STBC MC-CDMA systems over outdoor realistic MIMO channels

The paper deals with orthogonal space-time block coded MC-CDMA systems in outdoor realistic downlink scenarios with up to two transmit and receive antennas. Assuming no channel state information at the transmitter, we compare several linear single-user detection and spreading schemes, with or without channel coding, achieving a spectral efficiency of 1-2 bits/s/Hz. The different results obtained demonstrate that spatial diversity significantly improves the performance of MC-CDMA systems, and allows different chip-mapping without notably decreasing performance. Moreover, the global system exhibits a good trade-off between complexity at mobile stations and performance. Then, Alamouti's STBC MC-CDMA schemes derive full benefit from the frequency and spatial diversities and can be considered as a very realistic and promising candidate for the air interface downlink of the 4/sup th/ generation mobile radio systems

Timing and Carrier Synchronization in Wireless Communication Systems: A Survey and Classification of Research in the Last 5 Years

Timing and carrier synchronization is a fundamental requirement for any wireless communication system to work properly. Timing synchronization is the process by which a receiver node determines the correct instants of time at which to sample the incoming signal. Carrier synchronization is the process by which a receiver adapts the frequency and phase of its local carrier oscillator with those of the received signal. In this paper, we survey the literature over the last 5 years (2010–2014) and present a comprehensive literature review and classification of the recent research progress in achieving timing and carrier synchronization in single-input single-output (SISO), multiple-input multiple-output (MIMO), cooperative relaying, and multiuser/multicell interference networks. Considering both single-carrier and multi-carrier communication systems, we survey and categorize the timing and carrier synchronization techniques proposed for the different communication systems focusing on the system model assumptions for synchronization, the synchronization challenges, and the state-of-the-art synchronization solutions and their limitations. Finally, we envision some future research directions

PRE-FILTERING IN MC-CDMA DOWNLINK TRANSMISSIONS

Future wireless communication systems are expected to support high-speed and high-quality multimedia services. In theseapplications the received signal is typically affected byfrequency-selective fading, which must be properly counteracted toavoid a severe degradation of the system performance. MC-CDMA is a multiplexing technique that combines OFDM with direct sequence CDMA. It is robust to frequency-selective fading thanks to the underlying OFDM modulation and exploits frequency diversity by spreading the data of different users in the frequency domain. For these reasons it is considered as a promising candidate for the physical layer of future high-speed wireless communications. Recent publications show that MC-CDMA is particularly suitable for downlink transmissions, i.e., from the base station to the mobile terminals. In these applications orthogonal spreading codes are usually employed to provide protection against co-channel interference. In the presence of multipath propagation, however, signals undergo frequency-selective fading and the code orthogonality is lost. This gives rise to multiple-access interference, which strongly limits the system performance. In the past few years several advanced multi-user detection techniques have been proposed and discussed for interference mitigation. However, in spite of their effectiveness, all these methods are quite unattractive for downlink applications since they would entail high complexity and excessive power consumption at the remote units. As an alternative to multi-user detection, pre-filtering techniques can be employed in downlink transmissions to mitigate multiple-access interference and channel distortions. The idea behind pre-filtering is to vary the gain assigned to each subcarrier so that interference is reduced and the signal at the receiver appears undistorted. In this way, simple and low complex single-user detectors can be employed at the remote units, thereby moving most of the computational burden to the base station, where power consumption and computational resources are not critical issues. In general terms, the main contribution of this dissertation is threefold. First, we propose and discuss several linear and non-linear pre-filtering schemes for the downlink of MC-CDMA systems equipped with multiple transmit antennas and operating in a time-division-duplex mode. The resulting schemes are derived according to different optimization criteria and aim at combating the detrimental effects of MAI while maintaining the complexity of the remote units as low as possible. A second contribution comes from providing a unified framework for investigating pre-filtering in the downlink of both MC-CDMA and OFDMA systems. The use of a unified framework comprising both MC-CDMA and OFDMA allows a fair comparison between these multiple-access technologies under the same operating conditions. It turns out that OFDMA outperforms MC-CDMA when the system resources are optimally assigned to the active users according to the actual channel realization. As we shall see, in order to work properly, all the proposed schemes require explicit knowledge of the channel responses of the active users. In time-division-duplex systems this information can be achieved by exploiting the channel reciprocity between alternative uplink and downlink transmissions. If channel variations are sufficiently slow, the channel estimates of the active users can be derived at the base station during an uplink time-slot and reused for pre-filtering in the subsequent downlink time-slot. Thus, a third contribution comes from addressing the problem of channel acquisition in the uplink of an MC-CDMA system equipped with multiple receive antennas

Nonorthogonal Multiple Access for 5G and Beyond

This work was supported in part by the U.K. Engineering and Physical Sciences Research Council (EPSRC) under Grant EP/N029720/1 and Grant EP/N029720/2. The work of L. Hanzo was supported by the ERC Advanced Fellow Grant Beam-me-up

Hybrid Dy-NFIS & RLS equalization for ZCC code in optical-CDMA over multi-mode optical fiber

For long haul coherent optical fiber communication systems, it is significant to precisely monitor the quality of transmission links and optical signals. The channel capacity beyond Shannon limit of Single-mode optical fiber (SMOF) is achieved with the help of Multi-mode optical fiber (MMOF), where the signal is multiplexed in different spatial modes. To increase single-mode transmission capacity and to avoid a foreseen “capacity crunch”, researchers have been motivated to employ MMOF as an alternative. Furthermore, different multiplexing techniques could be applied in MMOF to improve the communication system. One of these techniques is the Optical Code Division Multiple Access (Optical-CDMA), which simplifies and decentralizes network controls to improve spectral efficiency and information security increasing flexibility in bandwidth granularity. This technique also allows synchronous and simultaneous transmission medium to be shared by many users. However, during the propagation of the data over the MMOF based on Optical-CDMA, an inevitable encountered issue is pulse dispersion, nonlinearity and MAI due to mode coupling. Moreover, pulse dispersion, nonlinearity and MAI are significant aspects for the evaluation of the performance of high-speed MMOF communication systems based on Optical-CDMA. This work suggests a hybrid algorithm based on nonlinear algorithm (Dynamic evolving neural fuzzy inference (Dy-NFIS)) and linear algorithm (Recursive least squares (RLS)) equalization for ZCC code in Optical-CDMA over MMOF. Root mean squared error (RMSE), mean squared error (MSE) and Structural Similarity index (SSIM) are used to measure performance results

Approaching universal frequency reuse through base station cooperation

Base Station (BS) architectures are a promising cellular wireless solution to mitigate the interference issues and to avoid the high frequency reuse factors implemented in conventional systems. Combined with block transmission techniques, such as Orthogonal Frequency-Division Multiplexing (OFDM) for the downlink and Single-Carrier with Frequency-Domain Equalization (SC-FDE) for the uplink, these systems provide a significant performance improvement to the overall system. Block transmission techniques are suitable for broadband wireless communication systems, which have to deal with strongly frequency-selective fading channels and are able to provide high bit rates despite the channel adversities. In BS cooperation schemes users in adjacent cells share the same physical channel and the signals received by each BS are sent to a Central Processing Unit (CPU) that combines the different signals and performs the user detections and/or separation, which can be regarded as a Multi-User Detection (MUD) technique. The work presented in this thesis is focused on the study of uplink transmissions in BS cooperations systems, considering single carrier block transmission schemes and iterative receivers based on the Iterative-Block Decision Feedback Equalization (IB-DFE) concept, which combined with the employment of Cyclic Prefix (CP)-assisted block transmission techniques are appropriate to scenarios with strongly time-dispersive channels. Furthermore, the impact of the sampling and quantization applied to the received signals from each Mobile Terminal (MT) to the corresponding BS is studied, with the achievement of the spectral characterization of the quantization noise. This thesis also provides a conventional analytical model for the BER (Bit Error Rate) performance complemented with an approach to improve its results. Finally, this thesis addresses the contextualization of BS cooperation schemes in clustered C-RAN (Centralized-Radio Access Network)-type solutions.As arquitecturas BS cooperation são uma solução promissora de redes celulares sem fios para atenuar o problema da interferência e evitar os factores de reuso elevados, que se encontram implementados nos sistemas convencionais. Combinadas com técnicas de transmissão por blocos, como o OFDM para o downlink e o SC-FDE no uplink, estes sistemas fornecem uma melhoria significativa no desempenho geral do sistema. Técnicas de transmissão por blocos são adequadas para sistemas de comunicações de banda larga sem fios, que têm que lidar com canais que possuem um forte desvanescimento selectivo na frequência e são capazes de fornecer ligações com taxas de transmissão altas apesar das adversidades do canal. Em esquemas BS cooperation os terminais móveis situados em células adjacentes partilham o mesmo canal físico e os sinais recebidos em cada estação de base são enviados para uma Unidade Central de Processamento (CPU) que combina os diferentes sinais recebidos associados a um dado utilizador e realiza a detecção e/ou separação do mesmo, sendo esta considerada uma técnica de Detecção Multi-Utilizador (MUD). O trabalho apresentado nesta tese concentra o seu estudo no uplink de transmissões em sistemas BS cooperation, considerando transmissões em bloco de esquemas monoportadoras e receptores iterativos baseados no conceito B-DFE, em que quando combinados com a implementação de técnicas de transmissao por blocos assistidas por prefixos cíclicos (CP) são apropriados a cenários com canais fortemente dispersivos no tempo. Além disso, é estudado o impacto do processo de amostragem e quantização aplicados aos sinais recebidos de cada terminal móvel para a estação de base, com a obtenção da caracterização espectral do ruído de quantização. Esta tese também fornece um modelo analítico convencional para a computação do desempenho da taxa de erros de bit (BER), com um método melhorado para o mesmo. Por último, esta tese visa a contextualização dos sistemas BS cooperation em soluções do tipo C-RAN