2,473 research outputs found
Distributed multi-user MIMO transmission using real-time sigma-delta-over-fiber for next generation fronthaul interface
To achieve the massive device connectivity and high data rate demanded by 5G, wireless transmission with wider signal bandwidths and higher-order multiple-input multiple-output (MIMO) is inevitable. This work demonstrates a possible function split option for the next generation fronthaul interface (NGFI). The proof-of-concept downlink architecture consists of real-time sigma-delta modulated signal over fiber (SDoF) links in combination with distributed multi-user (MU) MIMO transmission. The setup is fully implemented using off-the-shelf and in-house developed components. A single SDoF link achieves an error vector magnitude (EVM) of 3.14% for a 163.84 MHz-bandwidth 256-QAM OFDM signal (958.64 Mbps) with a carrier frequency around 3.5 GHz transmitted over 100 m OM4 multi-mode fiber at 850 nm using a commercial QSFP module. The centralized architecture of the proposed setup introduces no frequency asynchronism among remote radio units. For most cases, the 2 x 2 MU-MIMO transmission has little performance degradation compared to SISO, 0.8 dB EVM degradation for 40.96 MHz-bandwidth signals and 1.4 dB for 163.84 MHz-bandwidth on average, implying that the wireless spectral efficiency almost doubles by exploiting spatial multiplexing. A 1.4 Gbps data rate (720 Mbps per user, 163.84 MHz-bandwidth, 64-QAM) is reached with an average EVM of 6.66%. The performance shows that this approach is feasible for the high-capacity hot-spot scenario
Ubiquitous Cell-Free Massive MIMO Communications
Since the first cellular networks were trialled in the 1970s, we have
witnessed an incredible wireless revolution. From 1G to 4G, the massive traffic
growth has been managed by a combination of wider bandwidths, refined radio
interfaces, and network densification, namely increasing the number of antennas
per site. Due its cost-efficiency, the latter has contributed the most. Massive
MIMO (multiple-input multiple-output) is a key 5G technology that uses massive
antenna arrays to provide a very high beamforming gain and spatially
multiplexing of users, and hence, increases the spectral and energy efficiency.
It constitutes a centralized solution to densify a network, and its performance
is limited by the inter-cell interference inherent in its cell-centric design.
Conversely, ubiquitous cell-free Massive MIMO refers to a distributed Massive
MIMO system implementing coherent user-centric transmission to overcome the
inter-cell interference limitation in cellular networks and provide additional
macro-diversity. These features, combined with the system scalability inherent
in the Massive MIMO design, distinguishes ubiquitous cell-free Massive MIMO
from prior coordinated distributed wireless systems. In this article, we
investigate the enormous potential of this promising technology while
addressing practical deployment issues to deal with the increased
back/front-hauling overhead deriving from the signal co-processing.Comment: Published in EURASIP Journal on Wireless Communications and
Networking on August 5, 201
On bounds and algorithms for frequency synchronization for collaborative communication systems
Cooperative diversity systems are wireless communication systems designed to
exploit cooperation among users to mitigate the effects of multipath fading. In
fairly general conditions, it has been shown that these systems can achieve the
diversity order of an equivalent MISO channel and, if the node geometry
permits, virtually the same outage probability can be achieved as that of the
equivalent MISO channel for a wide range of applicable SNR. However, much of
the prior analysis has been performed under the assumption of perfect timing
and frequency offset synchronization. In this paper, we derive the estimation
bounds and associated maximum likelihood estimators for frequency offset
estimation in a cooperative communication system. We show the benefit of
adaptively tuning the frequency of the relay node in order to reduce estimation
error at the destination. We also derive an efficient estimation algorithm,
based on the correlation sequence of the data, which has mean squared error
close to the Cramer-Rao Bound.Comment: Submitted to IEEE Transaction on Signal Processin
Synchronization in wireless communications
The last decade has witnessed an immense increase of wireless communications services in order to keep pace with the ever increasing demand for higher data rates combined with higher mobility. To satisfy this demand for higher data rates, the throughput over the existing transmission media had to be increased. Several techniques were proposed to boost up the data rate: multicarrier systems to combat selective fading, ultra wide band (UWB) communications systems to share the spectrum with other users, MIMO transmissions to increase the capacity of wireless links, iteratively decodable codes (e.g., turbo codes and LDPC codes) to improve the quality of the link, cognitive radios, and so forth
- …