Virtual inertia for suppressing voltage oscillations and stability mechanisms in DC microgrids

Renewable energy sources (RES) are gradually penetrating power systems through power electronic converters (PECs), which greatly change the structure and operation characteristics of traditional power systems. The maturation of PECs has also laid a technical foundation for the development of DC microgrids (DC-MGs). The advantages of DC-MGs over AC systems make them an important access target for RES. Due to the multi-timescale characteristics and fast response of power electronics, the dynamic coupling of PEC control systems and the transient interaction between the PEC and the passive network are inevitable, which threatens the stable operation of DC-MGs. Therefore, this dissertation focuses on the study of stabilization control methods, the low-frequency oscillation (LFO) mechanism analysis of DC-MGs and the state-of-charge (SoC) imbalance problem of multi-parallel energy storage systems (ESS). Firstly, a virtual inertia and damping control (VIDC) strategy is proposed to enable bidirectional DC converters (BiCs) to damp voltage oscillations by using the energy stored in ESS to emulate inertia without modifications to system hardware. Both the inertia part and the damping part are modeled in the VIDC controller by analogy with DC machines. Simulation results verify that the proposed VIDC can improve the dynamic characteristics and stability in islanded DC-MG. Then, inertia droop control (IDC) strategies are proposed for BiC of ESS based on the comparison between conventional droop control and VIDC. A feedback analytical method is presented to comprehend stability mechanisms from multi-viewpoints and observe the interaction between variables intuitively. A hardware in the loop (HIL) experiment verifies that IDC can simplify the control structure of VIDC in the promise of ensuring similar control performances. Subsequently, a multi-timescale impedance model is established to clarify the control principle of VIDC and the LFO mechanisms of VIDC-controlled DC-MG. Control loops of different timescales are visualized as independent loop virtual impedances (LVIs) to form an impedance circuit. The instability factors are revealed and a dynamic stability enhancement method is proposed to compensate for the negative damping caused by VIDC and CPL. Experimental results have validated the LFO mechanism analysis and stability enhancement method. Finally, an inertia-emulation-based cooperative control strategy for multi-parallel ESS is proposed to address the SoC imbalance and voltage deviation problem in steady-state operation and the voltage stability problem. The contradiction between SoC balancing speed and maintaining system stability is solved by a redefined SoC-based droop resistance function. HIL experiments prove that the proposed control performs better dynamics and static characteristics without modifying the hardware and can balance the SoC in both charge and discharge modes

European White Book on Real-Time Power Hardware in the Loop Testing : DERlab Report No. R- 005.0

The European White Book on Real-Time-Powerhardware-in-the-Loop testing is intended to serve as a reference document on the future of testing of electrical power equipment, with specifi c focus on the emerging hardware-in-the-loop activities and application thereof within testing facilities and procedures. It will provide an outlook of how this powerful tool can be utilised to support the development, testing and validation of specifi cally DER equipment. It aims to report on international experience gained thus far and provides case studies on developments and specifi c technical issues, such as the hardware/software interface. This white book compliments the already existing series of DERlab European white books, covering topics such as grid-inverters and grid-connected storag

Active distribution power system with multi-terminal DC links

A fast power restoration operational scheme and relevant stabilizing control is proposed for active distribution power systems with multi-terminal DC network in replacement of the conventional normal open switches. A 9-feeder benchmark distribution power system is established with a 4-terminal medium power DC system injected. The proposed power restoration scheme is based on the coordination among distributed control among relays, load switches, voltage source converters and autonomous operation of multi-terminal DC system. A DC stabilizer is proposed with virtual impedance method to damp out potential oscillation caused by constant power load terminals. The proposed system and controls are validated by frequency domain state space model and time domain case study with Matlab/Simulink

Frequency support characteristics of grid-interactive power converters based on the synchronous power controller

Grid-interactive converters with primary frequency control and inertia emulation have emerged and are promising for future renewable generation plants because of the contribution in power system stabilization. This paper gives a synchronous active power control solution for gridinteractive converters , as a way to emulate synchronous generators for inerita characteristics and load sharing. As design considerations, the virtual angle stability and transient response are both analyzed, and the detailed implementation structure is also given without entailing any difficulty in practice. The analytical and experimental validation of frequency support characteristics differentiates the work from other publications on generator emulation control. The 10 kW simulation and experimental frequency sweep tests on a regenerative source test bed present good performance of the proposed control in showing inertia and droop characteristics, as well as the controllable transient response.Peer ReviewedPostprint (author's final draft

Improving long line stability by integrating renewables using static synchronous generators

Postprint (author's final draft

Start-up of virtual synchronous machine: methods and experimental comparison

A modern grid is smarter mainly in the advance in information and communication technologies, while the power processing mechanism does not make a big difference. To make a modern grid smarter, the grid control should be improved to process the power in a smarter way. Therefore, it is easily foreseen that virtual synchronous machines, which emulates the synchronous machines based on power converters, may have big potentials in a future energy internet. This paper uses the Synchronous Power Controller with emulated and improved synchronous machine characteristics for renewable generation systems and proposes two start-up strategies. The proposed strategies are explained in detail, verified and compared by experimental results.Peer ReviewedPostprint (published version

Multi-terminal HVDC grids with inertia mimicry capability

The high-voltage multi-terminal dc (MTDC) systems are foreseen to experience an important development in the next years. Currently, they have appeared to be a prevailing technical and economical solution for harvesting offshore wind energy. In this study, inertia mimicry capability is added to a voltage-source converter-HVDC grid-side station in an MTDC grid connected to a weak ac grid, which can have low inertia or even operate as an islanded grid. The presented inertia mimicry control is integrated in the generalised voltage droop strategy implemented at the primary level of a two-layer hierarchical control structure of the MTDC grid to provide higher flexibility, and thus controllability to the network. Besides, complete control framework from the operational point of view is developed to integrate the low-level control of the converter stations in the supervisory control centre of the MTDC grid. A scaled laboratory test results considering the international council on large electric systems (CIGRE) B4 MTDC grid demonstrate the good performance of the converter station when it is connected to a weak islanded ac grid.Peer ReviewedPostprint (author's final draft

Measurements, Models, Systems and Design

531 s.