QoS multicast tree construction in IP/DWDM optical internet by bio-inspired algorithms

Copyright @ Elsevier Ltd. All rights reserved.In this paper, two bio-inspired Quality of Service (QoS) multicast algorithms are proposed in IP over dense wavelength division multiplexing (DWDM) optical Internet. Given a QoS multicast request and the delay interval required by the application, both algorithms are able to find a flexible QoS-based cost suboptimal routing tree. They first construct the multicast trees based on ant colony optimization and artificial immune algorithm, respectively. Then a dedicated wavelength assignment algorithm is proposed to assign wavelengths to the trees aiming to minimize the delay of the wavelength conversion. In both algorithms, multicast routing and wavelength assignment are integrated into a single process. Therefore, they can find the multicast trees on which the least wavelength conversion delay is achieved. Load balance is also considered in both algorithms. Simulation results show that these two bio-inspired algorithms can construct high performance QoS routing trees for multicast applications in IP/DWDM optical Internet.This work was supported in part ny the Program for New Century Excellent Talents in University, the Engineering and Physical Sciences Research Council (EPSRC) of UK under Grant EP/E060722/1, the National Natural Science Foundation of China under Grant no. 60673159 and 70671020, the National High-Tech Reasearch and Development Plan of China under Grant no. 2007AA041201, and the Specialized Research Fund for the Doctoral Program of Higher Education under Grant no. 20070145017

Design and provisioning of WDM networks for traffic grooming

Wavelength Division Multiplexing (WDM) is the most viable technique for utilizing the enormous amounts of bandwidth inherently available in optical fibers. However, the bandwidth offered by a single wavelength in WDM networks is on the order of tens of Gigabits per second, while most of the applications\u27 bandwidth requirements are still subwavelength. Therefore, cost-effective design and provisioning of WDM networks require that traffic from different sessions share bandwidth of a single wavelength by employing electronic multiplexing at higher layers. This is known as traffic grooming. Optical networks supporting traffic grooming are usually designed in a way such that the cost of the higher layer equipment used to support a given traffic matrix is reduced. In this thesis, we propose a number of optimal and heuristic solutions for the design and provisioning of optical networks for traffic grooming with an objective of network cost reduction. In doing so, we address several practical issues. Specifically, we address the design and provisioning of WDM networks on unidirectional and bidirectional rings for arbitrary unicast traffic grooming, and on mesh topologies for arbitrary multipoint traffic grooming. In multipoint traffic grooming, we address both multicast and many-to-one traffic grooming problems. We provide a unified frame work for optimal and approximate network dimensioning and channel provisioning for the generic multicast traffic grooming problem, as well as some variants of the problem. For many-to-one traffic grooming we propose optimal as well as heuristic solutions. Optimal formulations which are inherently non-linear are mapped to an optimal linear formulation. In the heuristic solutions, we employ different problem specific search strategies to explore the solution space. We provide a number of experimental results to show the efficacy of our proposed techniques for the traffic grooming problem in WDM networks

Wavelengths switching and allocation algorithms in multicast technology using m-arity tree networks topology

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University London.In this thesis, the m-arity tree networks have been investigated to derive equations for their nodes, links and required wavelengths. The relationship among all parameters such as leaves nodes, destinations, paths and wavelengths has been found. Three situations have been explored, firstly when just one server and the leaves nodes are destinations, secondly when just one server and all other nodes are destinations, thirdly when all nodes are sources and destinations in the same time. The investigation has included binary, ternary, quaternary and finalized by general equations for all m-arity tree networks. Moreover, a multicast technology is analysed in this thesis to transmit data carried by specific wavelengths to several clients. Wavelengths multicast switching is well examined to propose split-convert-split-convert (S-C-S-C) multicast switch which consists of light splitters and wavelengths converters. It has reduced group delay by 13% and 29% compared with split-convert (S-C) and split-convert-split (S-C-S) multicast switches respectively. The proposed switch has also increased the received signal power by a significant value which reaches 28% and 26.92% compared with S-C-S and S-C respectively. In addition, wavelengths allocation algorithms in multicast technology are proposed in this thesis using tree networks topology. Distributed scheme is adopted by placing wavelength assignment controller in all parents’ nodes. Two distributed algorithms proposed shortest wavelength assignment (SWA) and highest number of destinations with shortest wavelength assignment (HND-SWA) algorithms to increase the received signal power, decrease group delay and reduce dispersion. The performance of the SWA algorithm was almost better or same as HND-SWA related to the power, dispersion and group delay but they are always better than other two algorithms. The required numbers of wavelengths and their utilised converters have been examined and calculated for the researched algorithms. The HND-SWA has recorded the superior performance compared with other algorithms. It has reduced number of utilised wavelengths up to about 19% and minimized number of the used wavelengths converters up to about 29%. Finally, the centralised scheme is discussed and researched and proposed a centralised highest number of destinations (CHND) algorithm with static and dynamic scenarios to reduce network capacity decreasing (Cd) after each wavelengths allocation. The CDHND has reduced (Cd) by about 16.7% compared with the other algorithms

Silicon Photonic Subsystems for Inter-Chip Optical Networks

The continuous growth of electronic compute and memory nodes in terms of the number of I/O pins, bandwidth, and areal throughput poses major integration and packaging challenges associated with offloading multi-Tbit/s data rates within the few pJ/bit targets. While integrated photonics are already deployed in long and short distances such as inter and intra data centers communications, the promising characteristics of the silicon photonic platform set it as the future technology for optical interconnects in ultra short inter-chip distances. The high index contrast between the waveguide and the cladding together with strong thermo-optic and carrier effects in silicon allows developing a wide range of micro-scale and low power optical devices compatible with the CMOS fabrication processes. Furthermore, the availability of photonic foundries and new electrical and optical co-packaging techniques further pushes this platform for the next steps of commercial deployment. The work in this dissertation presents the current trends in high-performance memory and processor nodes and gives motivation for disaggregated and reconfigurable inter-chip network enabled with the silicon photonic layer. A dense WDM transceiver and broadband switch architectures are discussed to support a bi-directional network of ten hybrid-memory cubes (HMC) interconnected to ten processor nodes with an overall aggregated bandwidth of 9.6Tbit/s. Latency and energy consumption are key performance parameters in a processor to primary memory nodes connectivity. The transceiver design is based on energy-efficient micro-ring resonators, and the broadband switch is constructed with 2x2 Mach-Zehnder elements for nano-second reconfiguration. Each transceiver is based on hundreds of micro-rings to convert the native HMC electrical protocol to the optical domain and the switch is based on tens of hundreds of 2x2 elements to achieve non-blocking all-to-all connectivity. The next chapters focus on developing methods for controlling and monitoring such complex and highly integrated silicon photonic subsystems. The thermo-optic effect is characterized and we show experimentally that the phase of the optical carrier can be reliably controlled with pulse-width modulation (PWM) signal, ultimately relaxing the need for hundreds of digital to analog converters (DACs). We further show that doped waveguide heaters can be utilized as \textit{in-line} optical power monitors by measuring photo-conductance current, which is an alternative for the conventional tapping and integration of photo-diodes. The next part concerned with a common cascaded micro-ring resonator in a WDM transceiver design. We develop on an FPGA control algorithm that abstracts the physical layer and takes user-defined inputs to set the resonances to the desired wavelength in a unicast and multicast transmission modes. The associated sensitivities of these silicon ring resonators are presented and addressed with three closed-loop solutions. We first show a closed-loop operation based on tapping the error signal from the drop port of the micro-ring. The second solution presents a resonance wavelength locking with a single digital I/O for control and feedback signals. Lastly, we leverage the photo-conductance effect and demonstrate the locking procedure using only the doped heater for both control and feedback purposes. To achieve the inter-chip reconfigurability we discuss recent advances of high-port-count SiP broadband switches for reconfigurable inter-chip networks. To ensure optimal operation in terms of low insertion loss, low cross-talk and high signal integrity per routing path, hundreds of 2x2 Mach-Zehnder elements need to be biased precisely for the cross and bar states. We address this challenge with a tapless and a design agnostic calibration approach based on the photo-conductance effect. The automated algorithm returns a look-up table for all for each 2x2 element and the associated calibrated biases. Each routing scenario is then tested for insertion loss, crosstalk and bit-error rate of 25Gbit/s 4-level pulse amplitude modulation signals. The last part utilizes the Mach-Zehnder interferometers in WDM transceiver applications. We demonstrate a polarization insensitive four-channel WDM receiver with 40Gbit/s per channel and a transmitter design generating 8-level pulse amplitude modulation signals at 30Gbit/s