Efficient AoA-based wireless indoor localization for hospital outpatients using mobile devices

The motivation of this work is to help outpatients find their corresponding departments or clinics, thus, it needs to provide indoor positioning services with a room-level accuracy. Unlike wireless outdoor localization that is dominated by the global positioning system (GPS), wireless indoor localization is still an open issue. Many different schemes are being developed to meet the increasing demand for indoor localization services. In this paper, we investigated the AoA-based wireless indoor localization for outpatients’ wayfinding in a hospital, where Wi-Fi access points (APs) are deployed, in line, on the ceiling. The target position can be determined by a mobile device, like a smartphone, through an efficient geometric calculation with two known APs coordinates and the angles of the incident radios. All possible positions in which the target may appear have been comprehensively investigated, and the corresponding solutions were proven to be the same. Experimental results show that localization error was less than 2.5 m, about 80% of the time, which can satisfy the outpatients’ requirements for wayfinding

Indoor wireless communications and applications

Chapter 3 addresses challenges in radio link and system design in indoor scenarios. Given the fact that most human activities take place in indoor environments, the need for supporting ubiquitous indoor data connectivity and location/tracking service becomes even more important than in the previous decades. Specific technical challenges addressed in this section are(i), modelling complex indoor radio channels for effective antenna deployment, (ii), potential of millimeter-wave (mm-wave) radios for supporting higher data rates, and (iii), feasible indoor localisation and tracking techniques, which are summarised in three dedicated sections of this chapter

xD-Track: Leveraging Multi-Dimensional Information for Passive Wi-Fi Tracking

We describe the design and implementation of xD-Track, the first practical Wi-Fi based device-free localization system that employs a simultaneous and joint estimation of time-of-flight, angle-of-arrival, angle-of-departure, and Doppler shift to fully characterize the wireless channel between a sender and receiver. Using this full characterization, xD-Track introduces novel methods to measure and isolate the signal path that reflects off a person of interest, allowing it to localize a human with just a single pair of access points, or a single client-access point pair. Searching the multiple dimensions to accomplish the above is highly computationally burdensome, so xD-Track introduces novel methods to prune computational requirements, making our approach suitable for real-time person tracking. We implement xD-Track on the WARP software-defined radio platform and evaluate in a cluttered office environment. Experiments tracking people moving indoors demonstrate a 230% angle-of-arrival accuracy improvement and a 98% end-to-end tracking accuracy improvement over the state of the art localization scheme SpotFi, adapted for device-free localization. The general platform we propose can be easily extended for other applications including gesture recognition and Wi-Fi imaging to significantly improve performance

UWB in 3D Indoor Positioning and Base Station Calibration

There are several technologies available for object locating and tracking in outdoor and indoor environments but performance requirements are getting tighter and precise object tracking is still largely an open challenge for researchers. Ultra wideband technology (UWB) has been identified as one of the most promising techniques to enhance a mobile node with accurate ranging and tracking capabilities. For indoor applications almost all positioning technologies require physical installation of fixed infrastructure. This infrastructure is usually expensive to deploy and maintain. The aim of this thesis is to improve the accessibility of the RF-positioning systems by lowering the configuration cost. Real time localisation and tracking systems (RTLS) based on RF technologies pose challenges especially for the deployment of positioning system over large areas or throughout buildings within a number of rooms. If calibration is done manually by providing information about the exact position of the base stations, the initial set-up is particularly time consuming and laborious. In this thesis a method for estimating the position and orientation (x, y, z, yaw, pitch and roll) of a base station of a real time localization system is presented. The algorithm uses two-dimensional Angle of Arrival information (i.e. azimuth and elevation measurements). This allows more inaccurate manual initial survey of the base stations and improves the final accuracy of the positioning. The thesis presents an implementation of the algorithm, simulations and empirical results. In the experiments, hardware and software procured from Ubisense was used. The Ubisense RTLS bases on UWB technology and utilises Angle of Arrival and Time Difference of Arrival techniques. Performance and functionality of the Ubisense RTLS were measured in various radio environments as well as the implementation of the calibration algorithm. Simulations and experiment studies showed that camera calibration method can be successfully adapted to position systems based on UWB technology and that the base stations can be calibrated in a sufficient accuracy. Because of more flexible calibration, the final positioning accuracy of the Ubisense system was as whole in average better.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format

waveSLAM: Empowering accurate indoor mapping using off-the-shelf millimeter-wave self-sensing

Proceedings of: 2023 IEEE 98th Vehicular Technology Conference: VTC2023-Fall, 10-13 October 2023, Hong Kong.This paper presents the design, implementation and evaluation of waveSLAM, a low-cost mobile robot system that uses the millimetre wave (mmWave) communication devices to enhance the indoor mapping process targeting environments with reduced visibility or glass/mirror walls. A unique feature of waveSLAM is that it only leverages existing Commercial-Off-The-Shelf (COTS) hardware (Lidar and mmWave radios) that are mounted on mobile robots to improve the accurate indoor mapping achieved with optical sensors. The key intuition behind the waveSLAM design is that while the mobile robots moves freely, the mmWave radios can periodically exchange angle and distance estimates between themselves (self-sensing) by bouncing the signal from the environment, thus enabling accurate estimates of the target object/material surface. Our experiments verify that waveSLAM can archive cm-level accuracy with errors below 22 cm and 20◦ in angle orientation which is compatible with Lidar when building indoor maps.This work has been partially funded by the European Union's Horizon Europe research and innovation program under grant agreement No 101095759 (Hexa-X-II) and the Spanish Ministry of Economic Affairs and Digital Transformation and the European Union-Next Generation EU through the UNICO 5G I+D 6G-EDGEDT

Non-GPS Navigation Using Vision-Aiding and Active Radio Range Measurements

The military depends on the Global Positioning System (GPS) for a wide array of advanced weaponry guidance and precision navigation systems. Lack of GPS access makes precision navigation very difficult. Inclusion of inertial sensors in existing navigation systems provides short-term precision navigation, but drifts significantly over long-term navigation. This thesis is motivated by the need for inertial sensor drift-constraint in degraded and denied GPS environments. The navigation system developed consists of inertial sensors, a simulated barometer, three Raytheon DH500 radios, and a stereo-camera image-aiding system. The Raytheon DH500 is a combat communication radio which also provides range measurements between radios. The measurements from each sensor are fused together with an extended Kalman filter to estimate the navigation trajectory. Residual monitoring and the Sage-Husa adaptive algorithm are individually tested in the Kalman filter range update algorithm to help improve the radio range positioning performance. The navigation system is shown to provide long-term inertial sensor drift-constraint with position errors as low as 3 meters

The Effects of Cognitive Jamming on Wireless Sensor Networks used for Geolocation

The increased use of Wireless Sensor Networks (WSN) for geolocation has led to an increased reliance on this technology. Jamming, protecting jamming, and detecting jamming in a WSN are areas of study that have greatly increased in interest. This research uses simulations and data collected from hardware experiments to test the effects of jamming on a WSN. Hardware jamming was tested using a Universal Software Radio Peripheral (USRP) Version 2 to assess the effects of jamming on a cooperative network of Java Sun SPOTs. The research combines simulations and data collected from the hardware experiments to see the effects of jamming on cooperative and noncooperative geolocation