Mapping of sea ice and measurement of its drift using aircraft synthetic aperture radar images

Side-looking radar images of Arctic sea ice were obtained as part of the Arctic Ice Dynamics Joint Experiment. Repetitive coverages of a test site in the Arctic were used to measure sea ice drift, employing single images and blocks of overlapping radar image strips; the images were used in conjunction with data from the aircraft inertial navigation and altimeter. Also, independently measured, accurate positions of a number of ground control points were available. Initial tests of the method were carried out with repeated coverages of a land area on the Alaska coast (Prudhoe). Absolute accuracies achieved were essentially limited by the accuracy of the inertial navigation data. Errors of drift measurements were found to be about ±2.5 km. Relative accuracy is higher; its limits are set by the radar image geometry and the definition of identical features in sequential images. The drift of adjacent ice features with respect to one another could be determined with errors of less than ±0.2 km

Extraction of spatial information from sterioscopic SAR images

Synthetic Aperture Radar (SAR) is now widely used for generating Digital Elevation Models (DEMs) and has advantages over optical data in terms of availability as it allows all-day and all-weather operations. The stereoscopic SAR method, which allows direct extraction of spatial information in three-dimensional space, has been established for decades. However, the traditional stereoscopic methods developed for SAR data depend on many human operations and need ground control points (GCPs), to set up geometric models. The aims of the thesis are not only to propose a refined rigorous stereoscopic SAR method and a new error model to predict theoretic errors, but also to achieve a higher level of automation and accuracy. By using a weighting matrix, which is derived by considering different observations in the space intersection algorithm, the minimal number of the GCPs required for the refined algorithm is only two. To achieve a high degree of automation, an optimized strategy of parameter selection for the pyramidal image correlation scheme employing a region-growing technique has been proposed. This avoids a trial-and-error approach to produce digital parallax data from the same-side SAR image pairs. A new method to derive GCPs automatically has been developed using a SAR image simulation technique, under the condition that a known DEM chip is available, to minimize human interventions and operator error. The proposed method for providing GCPs and the DEMs generated from space intersection have been incorporated into the procedures for geocoding SAR images to validate the proposed algorithms. The results derived show that the stereoscopic SAR data can be applied to geometric rectification in flat-to-moderate areas, and other applications of extraction of spatial information are promising

Techniques for wide-area mapping of forest biomass using radar data

Aspects of forest biomass mapping using SAR (Synthetic Aperture Radar) data were studied in study sites in northern Sweden, Germany, and south-eastern Finland. Terrain topography – via the area of a resolution cell – accounted for 61 percent of the total variation in a Seasat (L-band) SAR scene in a hilly and mountainous study site. A methodology – based on least squares adjustment of tie point and ground control point observations in a multi-temporal SAR mosaic dataset – produced a tie point RMSE (Root Mean Square Error) of 56 m and a GCP RMSE of 240 m in the African mosaic of the GRFM (Global Rain Forest Mapping) project. The mosaic consisted of 3624 JERS SAR scenes. A calibration revision methodology – also based on least squares adjustment and points in overlap areas between scenes – removed a calibration artifact of about 1 dB. A systematic search of the highest correlation between forest stem volume and backscattering amplitude was conducted over all combinations of transmit and receive polarisations in three AIRSAR scenes in a German study site. In the P-band, a high and narrow peak around HV-polarisation was found, where the correlation coefficient was 0.75, 0.59, and 0.71 in scenes acquired in August 1989, June 1991, and July 1991, respectively. In other polarisations of P-band, the correlation coefficient was lower. In L-band, the polarisation response was more flat and correlations lower, between 0.54 and 0.70 for stands with a stem volume 100 m3/ha or less. Three summer-time JERS SAR scenes produced very similar regression models between forest stem volume and backscattering amplitude in a study site in south-eastern Finland. A model was proposed for wide area biomass mapping when biomass accuracy requirements are not high. A multi-date regression model employing three summer scenes and three winter scenes produced a multiple correlation coefficient of 0.85 and a stem volume estimation RMSE of 41.3 m3/ha. JERS SAR scenes that were acquired in cold winter conditions produced very low correlations between stem volume and backscattering amplitude.reviewe

Earth Resources: A continuing bibliography with indexes, issue 36

This bibliography lists 576 reports, articles, and other documents introduced into the NASA Scientific and Technical Information System between October 1 and December 31, 1982. Emphasis is placed on the use of remote sensing and geophysical instrumentation in spacecraft and aircraft to survey and inventory natural resources and urban areas. Subject matter is grouped according to agriculture and forestry, environmental changes and cultural resources, geodesy and cartography, geology and mineral resources, hydrology and water management, data processing and distribution systems, instrumentation and sensors, and economic analysis

Advances on the investigation of landslides by space-borne synthetic aperture radar interferometry

Landslides are destructive geohazards to people and infrastructure, resulting in hundreds of deaths and billions of dollars of damage every year. Therefore, mapping the rate of deformation of such geohazards and understanding their mechanics is of paramount importance to mitigate the resulting impacts and properly manage the associated risks. In this paper, the main outcomes relevant to the joint European Space Agency (ESA) and the Chinese Ministry of Science and Technology (MOST) Dragon-5 initiative cooperation project ID 59,339 “Earth observation for seismic hazard assessment and landslide early warning system” are reported. The primary goals of the project are to further develop advanced SAR/InSAR and optical techniques to investigate seismic hazards and risks, detect potential landslides in wide regions, and demonstrate EO-based landslide early warning system over selected landslides. This work only focuses on the landslide hazard content of the project, and thus, in order to achieve these objectives, the following tasks were developed up to now: a) a procedure for phase unwrapping errors and tropospheric delay correction; b) an improvement of a cross-platform SAR offset tracking method for the retrieval of long-term ground displacements; c) the application of polarimetric SAR interferometry (PolInSAR) to increase the number and quality of monitoring points in landslide-prone areas; d) the semiautomatic mapping and preliminary classification of active displacement areas on wide regions; e) the modeling and identification of landslides in order to identify triggering factors or predict future displacements; and f) the application of an InSAR-based landslide early warning system on a selected site. The achieved results, which mainly focus on specific sensitive regions, provide essential assets for planning present and future scientific activities devoted to identifying, mapping, characterizing, monitoring and predicting landslides, as well as for the implementation of early warning systems.This work was supported by the ESA-MOST China DRAGON-5 project with ref. 59339, by the Spanish Ministry of Science and Innovation, the State Agency of Research (AEI), and the European Funds for Regional Development under grant [grant number PID2020-117303GB-C22], by the Conselleria de Innovación, Universidades, Ciencia y Sociedad Digital in the framework of the project CIAICO/2021/335, by the Natural Science Foundation of China [grant numbers 41874005 and 41929001], the Fundamental Research Funds for the Central University [grant numbers 300102269712 and 300102269303], and China Geological Survey Project [grant numbers DD20190637 and DD20190647]. Xiaojie Liu and Liuru Hu have been funded by Chinese Scholarship Council Grants Ref. [grant number 202006560031] and [grant number 202004180062], respectively

Angular-Based Radiometric Slope Correction for Sentinel-1 on Google Earth Engine

This article provides an angular-based radiometric slope correction routine for Sentinel-1 SAR imagery on the Google Earth Engine platform. Two established physical reference models are implemented. The first model is optimised for vegetation applications by assuming volume scattering on the ground. The second model is optimised for surface scattering, and therefore targeted at urban environments or analysis of soil characteristics. The framework of both models is extended to simultaneously generate masks of invalid data in active layover and shadow affected areas. A case study, using openly available and reproducible code, exemplarily demonstrates the improvement of the backscatter signal in a mountainous area of the Austrian Alps. Furthermore, suggestions for specific use cases are discussed and drawbacks of the method with respect to pixel-area based methods are highlighted. The radiometrically corrected radar backscatter products are overcoming current limitations and are compliant with recent CEOS specifications for SAR backscatter over land. This improves a wide range of potential usage scenarios of the Google Earth Engine platform in mapping various land surface parameters with Sentinel-1 on a large scale and in a rapid manner. The provision of an openly accessible Earth Engine module allows users a smooth integration of the routine into their own workflows

Detecting Methane Ebullition In Winter From Alaskan Lakes Using Synthetic Aperture Radar Remote Sensing

Thesis (Ph.D.) University of Alaska Fairbanks, 2012Methane (CH4) is a greenhouse gas with a high radiative forcing attribute, yet large uncertainties remain in constraining atmospheric CH4 sources and sinks. While freshwater lakes are known atmospheric CH4 sources, flux through ebullition (bubbling) is difficult to quantify in situ due to uneven spatial distribution and temporally irregular gas eruptions. This heterogeneous distribution of CH4 ebullition also creates error when scaling up field measurements for flux estimations. This thesis reviews estimates of CH4 contribution to the atmosphere by freshwater lakes presented in current literature and identifies knowledge gaps and the logistical difficulties in sampling CH 4 flux via ebullition (bubbling). My research investigates various imaging parameters of space-borne synthetic aperture radar (SAR) to constrain current CH4 emissions from northern lakes. In a GIS spatial analysis of lakes on the northern Seward Peninsula, Alaska, comparing field data of ebullition to SAR, I found that SAR L-band backscatter from lake ice was high from lakes with CH4 bubbles trapped by lake ice and low from lakes with low ebullition activity. The 'roughness' component of a Pauli polarimetric decomposition of quad-pol SAR showed a significant correlation with the percentage of lake ice area containing CH4 bubbles and with CH4 ebullition flux. This indicates that the mechanism of SAR scattering from ebullition bubbles trapped by lake ice is single bounce. I conclude that SAR remote sensing could improve our ability to quantify lake ebullition at larger spatial scales than field measurements alone, could offer between-lake comparison of CH 4 ebullition activity, and is a potential tool for developing regional estimations of lake-source CH4