GNSS Precise Point Positioning Using Low-Cost GNSS Receivers

There are positioning techniques available such as Real-Time Kinematic (RTK) which allow user to obtain few cm-level positioning, but require infrastructure cost, i.e., setting up local or regional networks of base stations to provide corrections. Precise Point Positioning (PPP) using dual-frequency receivers is a popular standalone technique to process GNSS data by applying precise satellite orbit and clock correction along with other corrections to produce cm to dm-level positioning. At the time of writing, almost all low-cost and ultra-low-cost (few $10s) GNSS units are single-frequency chips. Single-frequency PPP poses challenges in terms of effectively mitigating ionospheric delay and the multipath, as there is no second frequency to remove the ionospheric delay. The quality of measurements also deteriorates drastically from geodetic-grade to ultra-low-cost hardware. Given these challenges, this study attempts to improve the performance of single-frequency PPP using geodetic-grade hardware, and to capture the potential positioning performance of this new generation of low-cost and ultra-low-cost GNSS chips. Raw measurement analysis and post-fit residuals show that measurements from cellphones are more prone to multipath compared to signals from geodetic-grade and low-cost receivers. Horizontal accuracy of a few-centimetres is demonstrated with geodetic-grade hardware. Whereas accuracy of few-decimetres is observed from low-cost and ultra-low-cost GNSS hardware. With multi-constellation processing, improvements in accuracy and reductions in convergence time over initial 60 minutes period, are also demonstrated with three different set of GNSS hardware. Horizontal and vertical rms of 37 cm and 51 cm, respectively, is achieved using a cellphone

BDS GNSS for Earth Observation

For millennia, human communities have wondered about the possibility of observing phenomena in their surroundings, and in particular those affecting the Earth on which they live. More generally, it can be conceptually defined as Earth observation (EO) and is the collection of information about the biological, chemical and physical systems of planet Earth. It can be undertaken through sensors in direct contact with the ground or airborne platforms (such as weather balloons and stations) or remote-sensing technologies. However, the definition of EO has only become significant in the last 50 years, since it has been possible to send artificial satellites out of Earth’s orbit. Referring strictly to civil applications, satellites of this type were initially designed to provide satellite images; later, their purpose expanded to include the study of information on land characteristics, growing vegetation, crops, and environmental pollution. The data collected are used for several purposes, including the identification of natural resources and the production of accurate cartography. Satellite observations can cover the land, the atmosphere, and the oceans. Remote-sensing satellites may be equipped with passive instrumentation such as infrared or cameras for imaging the visible or active instrumentation such as radar. Generally, such satellites are non-geostationary satellites, i.e., they move at a certain speed along orbits inclined with respect to the Earth’s equatorial plane, often in polar orbit, at low or medium altitude, Low Earth Orbit (LEO) and Medium Earth Orbit (MEO), thus covering the entire Earth’s surface in a certain scan time (properly called ’temporal resolution’), i.e., in a certain number of orbits around the Earth. The first remote-sensing satellites were the American NASA/USGS Landsat Program; subsequently, the European: ENVISAT (ENVironmental SATellite), ERS (European Remote-Sensing satellite), RapidEye, the French SPOT (Satellite Pour l’Observation de laTerre), and the Canadian RADARSAT satellites were launched. The IKONOS, QuickBird, and GeoEye-1 satellites were dedicated to cartography. The WorldView-1 and WorldView-2 satellites and the COSMO-SkyMed system are more recent. The latest generation are the low payloads called Small Satellites, e.g., the Chinese BuFeng-1 and Fengyun-3 series. Also, Global Navigation Satellite Systems (GNSSs) have captured the attention of researchers worldwide for a multitude of Earth monitoring and exploration applications. On the other hand, over the past 40 years, GNSSs have become an essential part of many human activities. As is widely noted, there are currently four fully operational GNSSs; two of these were developed for military purposes (American NAVstar GPS and Russian GLONASS), whilst two others were developed for civil purposes such as the Chinese BeiDou satellite navigation system (BDS) and the European Galileo. In addition, many other regional GNSSs, such as the South Korean Regional Positioning System (KPS), the Japanese quasi-zenital satellite system (QZSS), and the Indian Regional Navigation Satellite System (IRNSS/NavIC), will become available in the next few years, which will have enormous potential for scientific applications and geomatics professionals. In addition to their traditional role of providing global positioning, navigation, and timing (PNT) information, GNSS navigation signals are now being used in new and innovative ways. Across the globe, new fields of scientific study are opening up to examine how signals can provide information about the characteristics of the atmosphere and even the surfaces from which they are reflected before being collected by a receiver. EO researchers monitor global environmental systems using in situ and remote monitoring tools. Their findings provide tools to support decision makers in various areas of interest, from security to the natural environment. GNSS signals are considered an important new source of information because they are a free, real-time, and globally available resource for the EO community

Analysis of multi-constellation GNSS PPP solutions under phase scintillations at high latitudes

In the past few years, the rapid evolution of multi-constellation navigation satellite systems boosted the development of many scientific and engineering applications. More than 100 satellites will be available in a few years, when all the four global constellations (GPS, GLONASS, Galileo, and Beidou) will be fully deployed. This high number of visible satellites has improved the performance of precise point positioning (PPP) techniques both in terms of accuracy and of session length, especially easing the modeling of ionospheric biases. However, in the presence of severe environmental and atmospheric conditions, the performance of PPP considerably deteriorates. It is the case of high-latitude scenarios, where the satellites coverage is limited, the satellites geometry is poor and ionospheric scintillation are frequent. This paper analyzes the quality of PPP solutions in terms of accuracy and convergence time, for a GNSS station in Antarctica. Single and multi-constellation results are compared, proving the benefits of the availability of a higher number of satellites as well as the improved robustness to the presence of moderate and strong phase scintillations. The use of PPP multi-constellation at high latitudes is indeed essential to guarantee high accuracy, and to obtain a low convergence time, of the order of tens of minutes

Cost-Effective GNSS Hardware for High-Accuracy Surveys and Its Prospects for Post-Processed Kinematic (PPK) and Precise Point Positioning (PPP) Strategies

This dissertation determines for the first time the vertical accuracy achievable with low-cost mass-market multi-frequency, multi-GNSS (LM3GNSS) receivers, and antennas in the context of Ellipsoid Reference Survey (ERS), usually employed in bathymetric operations aboard survey platforms. LM3GNSS receivers are relatively new in the market, and their emergence is driven by the automobile industry and several mass-market applications requiring location-based solutions at high accuracies. It is foreseeable that emerging hydrographic survey platforms such as autonomous surface vehicles, small unmanned aircraft, crowd-sourced bathymetric platforms, and offshore GNSS buoy will find LM3GNSS receivers attractive since they are power- and cost-effective (often less than $1,000 per unit). Previous studies have shown that some mass-market GNSS receivers\u27 positioning accuracy is at the sub-meter level in some positioning strategies, but the authors rarely discussed the vertical accuracy. In rare cases where attention is given to the vertical component, the experiment design did not address the dynamic antenna scenario typical of hydrographic survey operations and the positioning performance that meets the hydrographic survey community\u27s aspirations. The LM3GNSS receivers and low-cost antennas considered in this dissertation achieved vertical accuracies within 0.15 m at a 95% confidence level in simulated precise point positioning (PPP) and post-processed kinematic positioning strategies. This dissertation characterizes the signal strength, multipath, carrier-phase residuals, and code residuals in the measurement quality assessment of four LM3GNSS receivers and four low-cost antennas. The dissertation investigates the performances of the LM3GNSS receivers and low-cost antennas in different antenna-receiver pairings, relative to a high-grade GNSS receiver and antenna in simulated-kinematic and precise point positioning (PPP) strategies. This dissertation also shows that solutions with an uncalibrated antenna improve with a cloned ANTEX file making the results comparable to those achieved with high-end GNSS antenna. This dissertation also describes a GNSS processing tool (with graphic user interface), developed from scratch by the author, that implements, among others, orbit interpolation and geodetic computations as steps towards multipath computation and analysis. The dissertation concludes as follows: (1) The LM3GNSS hardware considered in this dissertation provides effective alternative positioning and navigation performance for emerging survey platforms such as ASV and sUAS. (2) LM3GNSS hardware can meet vertical positioning accuracy on the order of 0.15 m at a 95% confidence level in PPP strategy on less dynamic platforms. (3) LM3GNSS receivers can provide PPK solutions at medium (30 – 40 km) baselines with a vertical positioning accuracy better than 0.15m at a 95% confidence level. (4) LM3GNSS receivers in PPP strategy should meet IHO S-44 order-1 and order-2 in shallow waters. (5) Zephyr3 antenna, being a high-end GNSS antenna, may not always offer the best performance with the LM3GNSS receiver, especially in a dynamic environment. (6) Given the current tracking capabilities, the measurement quality, and positioning performances of LM3GNSS receivers relative to the geodetic grade receiver, it is foreseeable that the distinction between high-end GNSS and LM3GNSS receivers will most likely fade away as GNSS hardware technology advances. (7) Maximizing an LM3GNSS receiver in PPK strategy requires a multi-constellation-enabled reference station and high (i.e., 1 Hz) data tracking rate; otherwise, the PPK solutions will likely drift up to 20 cm

Observation-domain sidereal filtering for high-rate GPS precise point positioning

Accurate and timely determination of coseismic displacement (the quasi-permanent displacement of the ground caused by an earthquake) is crucial for tsunami warning and situational awareness systems. Seismometers measure acceleration or velocity very precisely. However, the process of integrating such data to yield displacement data is difficult and error-prone. In contrast, The Global Positioning System (GPS) can measure displacement directly, but is also subject to errors, one of which is multipath. Multipath errors can lead to errors in the measurement of small displacements or obscure the displacement entirely. Errors due to multipath are highly dependent on the geometry of GPS satellite orbits and surrounding reflectors relative to the receiving antenna itself. Each satellite has a ground track repeat period of approximately one sidereal day. Hence, this relative satellite-reflector geometry will repeat with the same period. Using this fact, it is possible to identify and remove the error signature induced by multipath by analysing data from adjacent days, yielding an improved time series of displacements and hence a more discernible coseismic offset. This process is commonly known as 'sidereal filtering'. This thesis describes a sidereal filter algorithm that attempts to remove the multipath error signature from the GPS measurements themselves before processing them rather than from the resulting position time-series. It is shown to generally produce a more stable position time series over periods from a few tens to a few hundred seconds, remove high-frequency multipath error more effectively, yield better stability during satellite outages and measure small centimetre-level displacements more accurately than a position-domain sidereal filter. However, results are inconclusive when applying the algorithm to the measurement of the coseismic displacements of a real earthquake, but it is demonstrated that an observation-domain sidereal filter is better at enabling one to distinguish certain types of seismic wave from a position time series

Ionosphere Monitoring with Remote Sensing

This book focuses on the characterization of the physical properties of the Earth’s ionosphere, contributing to unveiling the nature of several processes responsible for a plethora of space weather-related phenomena taking place in a wide range of spatial and temporal scales. This is made possible by the exploitation of a huge amount of high-quality data derived from both remote sensing and in situ facilities such as ionosondes, radars, satellites and Global Navigation Satellite Systems receivers

Beyond 100: The Next Century in Geodesy

This open access book contains 30 peer-reviewed papers based on presentations at the 27th General Assembly of the International Union of Geodesy and Geophysics (IUGG). The meeting was held from July 8 to 18, 2019 in Montreal, Canada, with the theme being the celebration of the centennial of the establishment of the IUGG. The centennial was also a good opportunity to look forward to the next century, as reflected in the title of this volume. The papers in this volume represent a cross-section of present activity in geodesy, and highlight the future directions in the field as we begin the second century of the IUGG. During the meeting, the International Association of Geodesy (IAG) organized one Union Symposium, 6 IAG Symposia, 7 Joint Symposia with other associations, and 20 business meetings. In addition, IAG co-sponsored 8 Union Symposia and 15 Joint Symposia. In total, 3952 participants registered, 437 of them with IAG priority. In total, there were 234 symposia and 18 Workshops with 4580 presentations, of which 469 were in IAG-associated symposia. ; This volume will publish papers based on International Association of Geodesy (IAG) -related presentations made at the International Association of Geodesy at the 27th IUGG General Assembly, Montreal, July 2019. It will include papers associated with all of the IAG and joint symposia from the meeting, which span all aspects of modern geodesy, and linkages to earth and environmental sciences. It continues the long-running IAG Symposia Series

Beyond 100: The Next Century in Geodesy

This open access book contains 30 peer-reviewed papers based on presentations at the 27th General Assembly of the International Union of Geodesy and Geophysics (IUGG). The meeting was held from July 8 to 18, 2019 in Montreal, Canada, with the theme being the celebration of the centennial of the establishment of the IUGG. The centennial was also a good opportunity to look forward to the next century, as reflected in the title of this volume. The papers in this volume represent a cross-section of present activity in geodesy, and highlight the future directions in the field as we begin the second century of the IUGG. During the meeting, the International Association of Geodesy (IAG) organized one Union Symposium, 6 IAG Symposia, 7 Joint Symposia with other associations, and 20 business meetings. In addition, IAG co-sponsored 8 Union Symposia and 15 Joint Symposia. In total, 3952 participants registered, 437 of them with IAG priority. In total, there were 234 symposia and 18 Workshops with 4580 presentations, of which 469 were in IAG-associated symposia. ; This volume will publish papers based on International Association of Geodesy (IAG) -related presentations made at the International Association of Geodesy at the 27th IUGG General Assembly, Montreal, July 2019. It will include papers associated with all of the IAG and joint symposia from the meeting, which span all aspects of modern geodesy, and linkages to earth and environmental sciences. It continues the long-running IAG Symposia Series