AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing

The enormous success of advanced wireless devices is pushing the demand for higher wireless data rates. Denser spectrum reuse through the deployment of more access points per square mile has the potential to successfully meet the increasing demand for more bandwidth. In theory, the best approach to density increase is via distributed multiuser MIMO, where several access points are connected to a central server and operate as a large distributed multi-antenna access point, ensuring that all transmitted signal power serves the purpose of data transmission, rather than creating "interference." In practice, while enterprise networks offer a natural setup in which distributed MIMO might be possible, there are serious implementation difficulties, the primary one being the need to eliminate phase and timing offsets between the jointly coordinated access points. In this paper we propose AirSync, a novel scheme which provides not only time but also phase synchronization, thus enabling distributed MIMO with full spatial multiplexing gains. AirSync locks the phase of all access points using a common reference broadcasted over the air in conjunction with a Kalman filter which closely tracks the phase drift. We have implemented AirSync as a digital circuit in the FPGA of the WARP radio platform. Our experimental testbed, comprised of two access points and two clients, shows that AirSync is able to achieve phase synchronization within a few degrees, and allows the system to nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC and higher layer aspects of a practical deployment. To the best of our knowledge, AirSync offers the first ever realization of the full multiuser MIMO gain, namely the ability to increase the number of wireless clients linearly with the number of jointly coordinated access points, without reducing the per client rate.Comment: Submitted to Transactions on Networkin

A MIMO-OFDM testbed, channel measurements, and system considerations for outdoor-indoor WiMAX

The design, implementation, and test of a real-time flexible 2×2 (Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing) MIMO-OFDM IEEE 802.16 prototype are presented. For the design, a channel measurement campaign on the 3.5GHz band has been carried out, focusing on outdoor-indoor scenarios. The analysis of measured channels showed that higher capacity can be achieved in case of obstructed scenarios and that (Channel Distribution Information at the Transmitter) CDIT capacity is close to (Channel State Information at the Transmitter) CSIT with much lower complexity and requirements in terms of channel estimation and feedback. The baseband prototype used an (Field Programmable Gate Array) FPGA where enhanced signal processing algorithms are implemented in order to improve system performance. We have shown that for MIMO-OFDM systems, extra signal processing such as enhanced joint channel and frequency offset estimation is needed to obtain a good performance and approach in practice the theoretical capacity improvements

Frequency-aware rate adaptation and MAC protocol

There has been burgeoning interest in wireless technologies that can use wider frequency spectrum. Technology advances, such as 802.11n and ultra-wideband (UWB), are pushing toward wider frequency bands. The analog-to-digital TV transition has made 100-250 MHz of digital whitespace bandwidth available for unlicensed access. Also, recent work on WiFi networks has advocated discarding the notion of channelization and allowing all nodes to access the wide 802.11 spectrum in order to improve load balancing. This shift towards wider bands presents an opportunity to exploit frequency diversity. Specifically, frequencies that are far from each other in the spectrum have significantly different SNRs, and good frequencies differ across sender-receiver pairs. This paper presents FARA, a combined frequency-aware rate adaptation and MAC protocol. FARA makes three departures from conventional wireless network design: First, it presents a scheme to robustly compute per-frequency SNRs using normal data transmissions. Second, instead of using one bit rate per link, it enables a sender to adapt the bitrate independently across frequencies based on these per-frequency SNRs. Third, in contrast to traditional frequency-oblivious MAC protocols, it introduces a MAC protocol that allocates to a sender-receiver pair the frequencies that work best for that pair. We have implemented FARA in FPGA on a wideband 802.11-compatible radio platform. Our experiments reveal that FARA provides a 3.1x throughput improvement in comparison to frequency-oblivious systems that occupy the same spectrum.Industrial Technology Research InstituteNational Science Foundation (U.S.)

SourceSync: A Distributed Wireless Architecture for Exploiting Sender Diversity

Diversity is an intrinsic property of wireless networks. Recent years have witnessed the emergence of many distributed protocols like ExOR, MORE, SOAR, SOFT, and MIXIT that exploit receiver diversity in 802.11-like networks. In contrast, the dual of receiver diversity, sender diversity, has remained largely elusive to such networks. This paper presents SourceSync, a distributed architecture for harnessing sender diversity. SourceSync enables concurrent senders to synchronize their transmissions to symbol boundaries, and cooperate to forward packets at higher data rates than they could have achieved by transmitting separately. The paper shows that SourceSync improves the performance of opportunistic routing protocols. Specifically, SourceSync allows all nodes that overhear a packet in a wireless mesh to simultaneously transmit it to their nexthops, in contrast to existing opportunistic routing protocols that are forced to pick a single forwarder from among the overhearing nodes. Such simultaneous transmission reduces bit errors and improves throughput. The paper also shows that SourceSync increases the throughput of 802.11 last hop diversity protocols by allowing multiple APs to transmit simultaneously to a client, thereby harnessing sender diversity. We have implemented SourceSync on the FPGA of an 802.11-like radio platform. We have also evaluated our system in an indoor wireless testbed, empirically showing its benefits.National Science Foundation (U.S.) (Award CNS-0831660)United States. Defense Advanced Research Projects Agency. Information Theory for Mobile Ad-Hoc Networks Progra

Random Access Heterogeneous Mimo Networks

This paper presents the design and implementation of 802.11n+, a fully distributed random access protocol for MIMO networks. 802.11n+ allows nodes that differ in the number of antennas to contend not just for time, but also for the degrees of freedom provided by multiple antennas. We show that even when the medium is already occupied by some nodes, nodes with more antennas can transmit concurrently without harming the ongoing transmissions. Furthermore, such nodes can contend for the medium in a fully distributed way. Our testbed evaluation shows that even for a small network with three competing node pairs, the resulting system about doubles the average network throughput. It also maintains the random access nature of today's 802.11n networks.United States. Defense Advanced Research Projects Agency. Information Theory for Mobile Ad-Hoc Networks ProgramNational Science Foundation (U.S.)