Slow and fast single photons from a quantum dot interacting with the excited state hyperfine structure of the Cesium D1-line

Hybrid interfaces between distinct quantum systems play a major role in the implementation of quantum networks. Quantum states have to be stored in memories to synchronize the photon arrival times for entanglement swapping by projective measurements in quantum repeaters or for entanglement purification. Here, we analyze the distortion of a single-photon wave packet propagating through a dispersive and absorptive medium with high spectral resolution. Single photons are generated from a single In(Ga)As quantum dot with its excitonic transition precisely set relative to the Cesium D1 transition. The delay of spectral components of the single-photon wave packet with almost Fourier-limited width is investigated in detail with a 200 MHz narrow-band monolithic Fabry-Pérot resonator. Reflecting the excited state hyperfine structure of Cesium, “slow light” and “fast light” behavior is observed. As a step towards room-temperature alkali vapor memories, quantum dot photons are delayed for 5 ns by strong dispersion between the two 1.17 GHz hyperfine-split excited state transitions. Based on optical pumping on the hyperfine-split ground states, we propose a simple, all-optically controllable delay for synchronization of heralded narrow-band photons in a quantum network.DFG, 43659573, SFB 787: Halbleiter - Nanophotonik: Materialien, Modelle, BauelementeEC/H2020/679183/EU/Entanglement distribution via Semiconductor-Piezoelectric Quantum-Dot Relays/SPQRe

Characterization of wavelength tunable lasers for future optical communication systems

The use of tunable lasers (TL) in dense wavelength division multiplexed (DWDM) networks for optical switching, routing and networking has gained a lot of interest in recent years. Employment of such TLs as tunable transmitters in wavelength packet switched (WPS) networks is one of the possible applications of these devices. In such systems, the information to be transmitted could be encoded onto a destination dependent wavelength and the routing of traffic could be performed on a packet-by-packet basis. The authors investigate the possibility of using TLs in DWDM WPS networks by focusing on the characterisation of the instantaneous frequency drift of a TL due to wavelength tuning and direct modulation. Characterization of the linewidth of the TLs is also presented to verify the feasibility of using TLs in systems employing advanced modulation formats

Basics of RF electronics

RF electronics deals with the generation, acquisition and manipulation of high-frequency signals. In particle accelerators signals of this kind are abundant, especially in the RF and beam diagnostics systems. In modern machines the complexity of the electronics assemblies dedicated to RF manipulation, beam diagnostics, and feedbacks is continuously increasing, following the demands for improvement of accelerator performance. However, these systems, and in particular their front-ends and back-ends, still rely on well-established basic hardware components and techniques, while down-converted and acquired signals are digitally processed exploiting the rapidly growing computational capability offered by the available technology. This lecture reviews the operational principles of the basic building blocks used for the treatment of high-frequency signals. Devices such as mixers, phase and amplitude detectors, modulators, filters, switches, directional couplers, oscillators, amplifiers, attenuators, and others are described in terms of equivalent circuits, scattering matrices, transfer functions; typical performance of commercially available models is presented. Owing to the breadth of the subject, this review is necessarily synthetic and non-exhaustive. Readers interested in the architecture of complete systems making use of the described components and devoted to generation and manipulation of the signals driving RF power plants and cavities may refer to the CAS lectures on Low-Level RF.Comment: 36 pages, contribution to the CAS - CERN Accelerator School: Specialised Course on RF for Accelerators; 8 - 17 Jun 2010, Ebeltoft, Denmar

Silicon-Nitride Platform for Narrowband Entangled Photon Generation

CMOS-compatible photonic chips are highly desirable for real-world quantum optics devices due to their scalability, robustness, and integration with electronics. Despite impressive advances using Silicon nanostructures, challenges remain in reducing their linear and nonlinear losses and in creating narrowband photons necessary for interfacing with quantum memories. Here we demonstrate the potential of the silicon nitride (Si3N4) platform by realizing an ultracompact, bright, entangled photon-pair source with selectable photon bandwidths down to 30 MHz, which is unprecedented for an integrated source. Leveraging Si3N4's moderate thermal expansion, simple temperature control of the chip enables precise wavelength stabilization and tunability without active control. Single-mode photon pairs at 1550 nm are generated at rates exceeding 107 s-1 with mW's of pump power and are used to produce time-bin entanglement. Moreover, Si3N4 allows for operation from the visible to the mid-IR, which make it highly promising for a wide range of integrated quantum photonics applications.Comment: Please don't hesitate to email comments and suggestion

Reconfigurable Reflectarrays and Array Lenses for Dynamic Antenna Beam Control: A Review

Advances in reflectarrays and array lenses with electronic beam-forming capabilities are enabling a host of new possibilities for these high-performance, low-cost antenna architectures. This paper reviews enabling technologies and topologies of reconfigurable reflectarray and array lens designs, and surveys a range of experimental implementations and achievements that have been made in this area in recent years. The paper describes the fundamental design approaches employed in realizing reconfigurable designs, and explores advanced capabilities of these nascent architectures, such as multi-band operation, polarization manipulation, frequency agility, and amplification. Finally, the paper concludes by discussing future challenges and possibilities for these antennas.Comment: 16 pages, 12 figure

Miniaturized High-Q Tunable RF Filters

This dissertation focuses on the investigation and development of novel efficient tuning techniques and the design of miniaturized high-Q tunable RF filters for high-performance reconfigurable systems and applications. First, a detailed survey of the available tuning concepts and state-of-art tunable filters is provided. Then, a novel so-called inset resonator configuration is presented for the applications of fixed and tunable coaxial filters. The design procedure of frequency tunable filters with constant absolute bandwidth (CABW) is described, and various tunable inset filters are implemented, offering many desirable merits, including the wide tuning range and stable high-Q with minimum variation. For wide octave frequency tuning ranges with CABW, a second novel concept is presented using so-called re-entrant caps tuners. Beside simplicity and compactness, this technique also features enhanced spurious performance and wider tuning capabilities than the conventional means. Also, in this dissertation, various miniaturized reconfigurable dual-band/dual-mode bandpass filters and diplexers are presented using compact dual-mode high-Q TM-mode dielectric resonators. Furthermore, a novel microfluidic-based ultra-wide frequency tuning technique for TM010-mode dielectric resonators and filters is introduced in this dissertation. In addition to the very wide tuning window, this mechanism has key advantages of low-cost, simplicity, and intrinsic switch-off. Lastly, the dissertation includes a novel bandwidth reconfiguration concept with multi-octave tuning using a single element for coaxial bandpass filters. This mechanism brings many features including the fast tuning, constant high-Q, intrinsic switch-off, and wide BW-reconfiguration

SBIR: development of ferroelectric filters

Issued as final reportnGima

A Novel Method for Tuning a Transistor-Based non-Foster Matching Circuit for Electrically Small Wideband Antennas

This dissertation reviews the application of non-Foster circuits for wideband antenna matching, and introduces a novel, rapid means of “tuning” the circuit to accommodate variations in antenna loadings. The tuning is accomplished via the judicious addition of a common transistor.A detailed literature search is provided, and non-Foster circuits are discussed in detail, including the myriad of implementations with focus on tuning. A comparison between different tuning methods is presented. The novel tuning method is evaluated via the normalized determinant function to ensure stability. Evaluations include simulations using commercially available software and experimentation to ensure not only stability but also that noise added by the active circuitry is manageable. Wideband stable operation is confirmed by pairing the tunable non-Foster matching circuit with an electrically small, resistively loaded dipole, and performance gains are demonstrated using the tunability feature. The resistively loaded dipole alone demonstrates reasonable performance at higher frequencies, but performance degrades considerably at lower frequencies, when the dipole is electrically small. The tunable non-Foster circuit is shown to alleviate some of this degradation. Additionally, applications other than wideband antenna matching can benefit from tunable non-Foster circuits such as tunable filters and phase shifters, and these are discussed as well. Finally, practical limitations of non-Foster circuits are presented