782 research outputs found
Loss-resilient Coding of Texture and Depth for Free-viewpoint Video Conferencing
Free-viewpoint video conferencing allows a participant to observe the remote
3D scene from any freely chosen viewpoint. An intermediate virtual viewpoint
image is commonly synthesized using two pairs of transmitted texture and depth
maps from two neighboring captured viewpoints via depth-image-based rendering
(DIBR). To maintain high quality of synthesized images, it is imperative to
contain the adverse effects of network packet losses that may arise during
texture and depth video transmission. Towards this end, we develop an
integrated approach that exploits the representation redundancy inherent in the
multiple streamed videos a voxel in the 3D scene visible to two captured views
is sampled and coded twice in the two views. In particular, at the receiver we
first develop an error concealment strategy that adaptively blends
corresponding pixels in the two captured views during DIBR, so that pixels from
the more reliable transmitted view are weighted more heavily. We then couple it
with a sender-side optimization of reference picture selection (RPS) during
real-time video coding, so that blocks containing samples of voxels that are
visible in both views are more error-resiliently coded in one view only, given
adaptive blending will erase errors in the other view. Further, synthesized
view distortion sensitivities to texture versus depth errors are analyzed, so
that relative importance of texture and depth code blocks can be computed for
system-wide RPS optimization. Experimental results show that the proposed
scheme can outperform the use of a traditional feedback channel by up to 0.82
dB on average at 8% packet loss rate, and by as much as 3 dB for particular
frames
Cross-layer Optimized Wireless Video Surveillance
A wireless video surveillance system contains three major components, the video capture and preprocessing, the video compression and transmission over wireless sensor networks (WSNs), and the video analysis at the receiving end. The coordination of different components is important for improving the end-to-end video quality, especially under the communication resource constraint. Cross-layer control proves to be an efficient measure for optimal system configuration. In this dissertation, we address the problem of implementing cross-layer optimization in the wireless video surveillance system.
The thesis work is based on three research projects. In the first project, a single PTU (pan-tilt-unit) camera is used for video object tracking. The problem studied is how to improve the quality of the received video by jointly considering the coding and transmission process. The cross-layer controller determines the optimal coding and transmission parameters, according to the dynamic channel condition and the transmission delay. Multiple error concealment strategies are developed utilizing the special property of the PTU camera motion.
In the second project, the binocular PTU camera is adopted for video object tracking. The presented work studied the fast disparity estimation algorithm and the 3D video transcoding over the WSN for real-time applications. The disparity/depth information is estimated in a coarse-to-fine manner using both local and global methods. The transcoding is coordinated by the cross-layer controller based on the channel condition and the data rate constraint, in order to achieve the best view synthesis quality.
The third project is applied for multi-camera motion capture in remote healthcare monitoring. The challenge is the resource allocation for multiple video sequences. The presented cross-layer design incorporates the delay sensitive, content-aware video coding and transmission, and the adaptive video coding and transmission to ensure the optimal and balanced quality for the multi-view videos.
In these projects, interdisciplinary study is conducted to synergize the surveillance system under the cross-layer optimization framework. Experimental results demonstrate the efficiency of the proposed schemes. The challenges of cross-layer design in existing wireless video surveillance systems are also analyzed to enlighten the future work.
Adviser: Song C
Cross-layer Optimized Wireless Video Surveillance
A wireless video surveillance system contains three major components, the video capture and preprocessing, the video compression and transmission over wireless sensor networks (WSNs), and the video analysis at the receiving end. The coordination of different components is important for improving the end-to-end video quality, especially under the communication resource constraint. Cross-layer control proves to be an efficient measure for optimal system configuration. In this dissertation, we address the problem of implementing cross-layer optimization in the wireless video surveillance system.
The thesis work is based on three research projects. In the first project, a single PTU (pan-tilt-unit) camera is used for video object tracking. The problem studied is how to improve the quality of the received video by jointly considering the coding and transmission process. The cross-layer controller determines the optimal coding and transmission parameters, according to the dynamic channel condition and the transmission delay. Multiple error concealment strategies are developed utilizing the special property of the PTU camera motion.
In the second project, the binocular PTU camera is adopted for video object tracking. The presented work studied the fast disparity estimation algorithm and the 3D video transcoding over the WSN for real-time applications. The disparity/depth information is estimated in a coarse-to-fine manner using both local and global methods. The transcoding is coordinated by the cross-layer controller based on the channel condition and the data rate constraint, in order to achieve the best view synthesis quality.
The third project is applied for multi-camera motion capture in remote healthcare monitoring. The challenge is the resource allocation for multiple video sequences. The presented cross-layer design incorporates the delay sensitive, content-aware video coding and transmission, and the adaptive video coding and transmission to ensure the optimal and balanced quality for the multi-view videos.
In these projects, interdisciplinary study is conducted to synergize the surveillance system under the cross-layer optimization framework. Experimental results demonstrate the efficiency of the proposed schemes. The challenges of cross-layer design in existing wireless video surveillance systems are also analyzed to enlighten the future work.
Adviser: Song C
Considering Bluetooth's Subband Codec (SBC) for Wideband Speech and Audio on the Internet
The Bluetooth Special Interest Group (SIG) has standardized the subband coding (SBC) audio codec to connect headphones via wireless Bluetooth links. SBC compresses audio at high fidelity while having an ultra-low algorithm delay. To make SBC suitable for the Internet, we extend it by using a time and packet loss concealment (PLC) algorithm that is based on ITU's G.711 Appendix I. The design is novel in the aspect of the interface between codec and speech receiver. We developed a new approach on how to distribute the functionality of a speech receiver between codec and application. Our approach leads to easier implementations of high quality VoIP applications.
We conducted subjective and objective listening tests of the audio quality of SBC and PLC in order to determine an optimal coding mode and the trade-off between coding mode and packet loss rate. More precisely, we conducted MUSHRA listening tests for selected sample items. These tests results are then compared with the results of multiple objective assessment algorithms (ITU P.862 PESQ, ITU BS.1387-1 PEAQ, Creusere's algorithm). We found out that a combination of the PEAQ basic and advanced values best matches---after third order linear regression---the subjective MUSHRA results . The linear regression has coefficient of determination of R²=0.907². By comparison, our individual human ratings show a correlation of about R=0.9 compared to our averaged human rating results.
Using the combination of both PEAQ algorithms, we calculate hundred thousands of objective audio quality ratings varying audio content and algorithmic parameters of SBC and PLC. The results show which set of parameters value are best suitable for a bandwidth and delay constrained link. The transmission quality of SBC is enhanced significantly by selecting optimal encoding parameters as compared to the default parameter sets given in the standard.
Finally, we present preliminary objective tests results on the comparison of the audio codecs SBC, CELT, APT-X and ULD coding speech and audio transmission. They all allow a mono and stereo transmission of music at ultra-low coding delays (<10ms), which is especially useful for distributed ensemble performances over the Internet
3D video coding and transmission
The capture, transmission, and display of
3D content has gained a lot of attention in the last few
years. 3D multimedia content is no longer con fined to
cinema theatres but is being transmitted using stereoscopic
video over satellite, shared on Blu-RayTMdisks,
or sent over Internet technologies. Stereoscopic displays
are needed at the receiving end and the viewer needs to
wear special glasses to present the two versions of the
video to the human vision system that then generates
the 3D illusion. To be more e ffective and improve the
immersive experience, more views are acquired from a
larger number of cameras and presented on di fferent displays,
such as autostereoscopic and light field displays.
These multiple views, combined with depth data, also
allow enhanced user experiences and new forms of interaction
with the 3D content from virtual viewpoints.
This type of audiovisual information is represented by a
huge amount of data that needs to be compressed and
transmitted over bandwidth-limited channels. Part of
the COST Action IC1105 \3D Content Creation, Coding
and Transmission over Future Media Networks" (3DConTourNet)
focuses on this research challenge.peer-reviewe
Low Complexity Multiview Video Coding
3D video is a technology that has seen a tremendous attention in the recent years. Multiview Video Coding (MVC) is an extension of the popular H.264 video coding standard and is commonly used to compress 3D videos. It offers an improvement of 20% to 50% in compression efficiency over simulcast encoding of multiview videos using the conventional H.264 video coding standard. However, there are two important problems associated with it: (i) its superior compression performance comes at the cost of significantly higher computational complexity which hampers the real-world realization of MVC encoder in applications such as 3D live broadcasting and interactive Free Viewpoint Television (FTV), and (ii) compressed 3D videos can suffer from packet loss during transmission, which can degrade the viewing quality of the 3D video at the decoder. This thesis aims to solve these problems by presenting techniques to reduce the computational complexity of the MVC encoder and by proposing a consistent error concealment technique for frame losses in 3D video transmission.
The thesis first analyses the complexity of the MVC encoder. It then proposes two novel techniques to reduce the complexity of motion and disparity estimation. The first method achieves complexity reduction in the disparity estimation process by exploiting the relationship between temporal levels, type of macroblocks and search ranges while the second method achieves it by exploiting the geometrical relation- ship between motion and disparity vectors in stereo frames. These two methods are then combined with other state-of-the-art methods in a unique framework where gains add up. Experimental results show that the proposed low-complexity framework can reduce the encoding time of the standard MVC encoder by over 93% while maintaining similar compression efficiency performance.
The addition of new View Synthesis Prediction (VSP) modes to the MVC encoding framework improves the compression efficiency of MVC. However, testing additional modes comes at the cost of increased encoding complexity. In order to reduce the encoding complexity, the thesis, next, proposes a bayesian early mode decision technique for a VSP enhanced MVC coder. It exploits the statistical similarities between the RD costs of the VSP SKIP mode in neighbouring views to terminate the mode decision process early. Results indicate that the proposed technique can reduce the encoding time of the enhanced MVC coder by over 33% at similar compression efficiency levels.
Finally, compressed 3D videos are usually required to be broadcast to a large number of users where transmission errors can lead to frame losses which can degrade the video quality at the decoder. A simple reconstruction of the lost frames can lead to inconsistent reconstruction of the 3D scene which may negatively affect the viewing experience of a user. In order to solve this problem, the thesis proposes, at the end, a consistency model for recovering frames lost during transmission. The proposed consistency model is used to evaluate inter-view and temporal consistencies while selecting candidate blocks for concealment. Experimental results show that the proposed technique is able to recover the lost frames with high consistency and better quality than two standard error concealment methods and a baseline technique based on the boundary matching algorithm
Recommended from our members
End-to-end 3D video communication over heterogeneous networks
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Three-dimensional technology, more commonly referred to as 3D technology, has revolutionised many fields including entertainment, medicine, and communications to name a few. In addition to 3D films, games, and sports channels, 3D perception has made tele-medicine a reality. By the year 2015, 30% of the all HD panels at home will be 3D enabled, predicted by consumer electronics manufacturers. Stereoscopic cameras, a comparatively mature technology compared to other 3D systems, are now being used by ordinary citizens to produce 3D content and share at a click of a button just like they do with the 2D counterparts via sites like YouTube. But technical challenges still exist, including with autostereoscopic multiview displays. 3D content requires many complex considerations--including how to represent it, and deciphering what is the best compression format--when considering transmission or storage, because of its increased amount of data. Any decision must be taken in the light of the available bandwidth or storage capacity, quality and user expectations. Free viewpoint navigation also remains partly unsolved. The most pressing issue getting in the way of widespread uptake of consumer 3D systems is the ability to deliver 3D content to heterogeneous consumer displays over the heterogeneous networks. Optimising 3D video communication solutions must consider the entire pipeline, starting with optimisation at the video source to the end display and transmission optimisation. Multi-view offers the most compelling solution for 3D videos with motion parallax and freedom from wearing headgear for 3D video perception. Optimising multi-view video for delivery and display could increase the demand for true 3D in the consumer market. This thesis focuses on an end-to-end quality optimisation in 3D video communication/transmission, offering solutions for optimisation at the compression, transmission, and decoder levels.Brunel University - Isambard Research Scholarshi
- …