119 research outputs found
Microwave-assisted non-thermal hemp degumming
The microwave-assisted non-thermal degumming of hemp fibre has been studied and then compared with the water bath heating under different time and temperature conditions. The results show that the residual gum content of the lean hemp using microwave-assisted heating method is lower than that obtained using water bath heating. The residual gum content gap between the two degumming processes increases first and then decreases as the heating time and temperature are increased. This proves the existence of non-thermal effects in microwave heating process besides the thermal effects in water bath heating. In addition, the structures of the lean hemp fibres obtained from these two methods are also studied by scanning electron microscopy and fourier transform infrared spectroscopy.
Silicon Avalanche Based Light Emitting Diodes and Their Potential Integration into CMOS and RF Integrated Circuit Technology
Recommended from our members
Local microstructure evolution at shear bands in metallic glasses with nanoscale phase separation
At room temperature, plastic flow of metallic glasses (MGs) is sharply localized in shear bands, which are a key feature of the plastic deformation in MGs. Despite their clear importance and decades of study, the conditions for formation of shear bands, their structural evolution and multiplication mechanism are still under debate. In this work, we investigate the local conditions at shear bands in new phase-separated bulk MGs containing glassy nanospheres and exhibiting exceptional plasticity under compression. It is found that the glassy nanospheres within the shear band dissolve through mechanical mixing driven by the sharp strain localization there, while those nearby in the matrix coarsen by Ostwald ripening due to the increased atomic mobility. The experimental evidence demonstrates that there exists an affected zone around the shear band. This zone may arise from low-strain plastic deformation in the matrix between the bands. These results suggest that measured property changes originate not only from the shear bands themselves, but also from the affected zones in the adjacent matrix. This work sheds light on direct visualization of deformation-related effects, in particular increased atomic mobility, in the region around shear bands
Simulation and Analysis of Fluid-Solid Coupling of Wave Impact Sandcastle Based on COMSOL
It is a complex problem to study the interaction between sand castle and flowing water, which needs to consider the complexity of seawater flow and the stress of sand castle structure. The authors use the fluid-solid coupling model to establish the connection between the fluid field and the structural mechanical field, and use the finite element analysis to complete the simulation modeling of the transient process of wave impact and sandcastle foundation deformation. This paper analyzes the stress and the first principal strain of the sand castle foundation in the direction of flow velocity when the sand castle foundation is hit by waves, as a method to judge the strength of the sand castle.The best shape: the boundary value of sand castle collapse caused by strain have been determined, so as to obtain the maximum stress that a sand castle foundation can bear before collapse, which makes it possible to use the fatigue strength calculation theory of sand castle solid to carry out the quantitative calculation of sand castle durability. At the same time, the impact of waves is abstracted as wave motion equation. Finally, the finite element analysis technology is adopted to calculate the main strain of sandcastles of different shapes under the impact of the same wave, and through the comparison of the main strain, the authors get the sandcastle shape with the strongest anti-wave impact ability, which is the eccentric circular platform body.Affected by rain: the authors considered the effect of rainwater infiltration on the sandcastle's stress, and simplified the process of rain as a continuous and uniform infiltration of rain into the sandcastle's surface. The rain changes the gravity of the sand on the castle's surface. Simulation analysis is adopted to calculate the surface stress of sand castle with different degree of water seepage and different geometry. By comparison, it has been found that the smooth cone is more able to withstand the infiltration of rain without collapse.
Selective Manganese-Catalyzed Oxidation of Hydrosilanes to Silanols under Neutral Reaction Conditions
Recommended from our members
The genome of Populus alba x Populus tremula var. glandulosa clone 84K
Poplar 84K (Populus alba x P. tremula var. glandulosa) is a fast-growing poplar hybrid. Originated in South Korea, this hybrid has been extensively cultivated in northern China. Due to the economic and ecological importance of this hybrid and high transformability, we now report the de novo sequencing and assembly of a male individual of poplar 84K using PacBio and Hi-C technologies. The final reference nuclear genome (747.5 Mb) has a contig N50 size of 1.99 Mb and a scaffold N50 size of 19.6 Mb. Complete chloroplast and mitochondrial genomes were also assembled from the sequencing data. Based on similarities to the genomes of P. alba var. pyramidalis and P. tremula, we were able to identify two subgenomes, representing 356 Mb from P. alba (subgenome A) and 354 Mb from P. tremula var. glandulosa (subgenome G). The phased assembly allowed us to detect the transcriptional bias between the two subgenomes, and we found that the subgenome from P. tremula displayed dominant expression in both 84K and another widely used hybrid, P. tremula x P. alba. This high-quality poplar 84K genome will be a valuable resource for poplar breeding and for molecular biology studies.Open access journalThis item from the UA Faculty Publications collection is made available by the University of Arizona with support from the University of Arizona Libraries. If you have questions, please contact us at [email protected]
Plants changed the response of bacterial community to the nitrogen and phosphorus addition ratio
IntroductionHuman activities have increased the nitrogen (N) and phosphorus (P) supply ratio of the natural ecosystem, which affects the growth of plants and the circulation of soil nutrients. However, the effect of the N and P supply ratio and the effect of plant on the soil microbial community are still unclear.MethodsIn this study, 16s rRNA sequencing was used to characterize the response of bacterial communities in Phragmites communis (P.communis) rhizosphere and non-rhizosphere soil to N and P addition ratio.ResultsThe results showed that the a-diversity of the P.communis rhizosphere soil bacterial community increased with increasing N and P addition ratio, which was caused by the increased salt and microbially available C content by the N and P ratio. N and P addition ratio decreased the pH of non-rhizosphere soil, which consequently decreased the a-diversity of the bacterial community. With increasing N and P addition ratio, the relative abundance of Proteobacteria and Bacteroidetes increased, while that of Actinobacteria and Acidobacteria decreased, which reflected the trophic strategy of the bacterial community. The bacterial community composition of the non-rhizosphere soil was significantly affected by salt, pH and total carbon (TC) content. Salt limited the relative abundance of Actinobacteria, and increased the relative abundance of Bacteroidetes. The symbiotic network of the rhizosphere soil bacterial community had lower robustness. This is attributed to the greater selective effect of plants on the bacterial community influenced by nutrient addition.DiscussionPlants played a regulatory role in the process of N and P addition affecting the bacterial community, and nutrient uptake by the root system reduced the negative impact of N and P addition on the bacterial community. The variations in the rhizosphere soil bacterial community were mainly caused by the response of the plant to the N and P addition ratio
Local microstructure evolution at shear bands in metallic glasses with nanoscale phase separation.
At room temperature, plastic flow of metallic glasses (MGs) is sharply localized in shear bands, which are a key feature of the plastic deformation in MGs. Despite their clear importance and decades of study, the conditions for formation of shear bands, their structural evolution and multiplication mechanism are still under debate. In this work, we investigate the local conditions at shear bands in new phase-separated bulk MGs containing glassy nanospheres and exhibiting exceptional plasticity under compression. It is found that the glassy nanospheres within the shear band dissolve through mechanical mixing driven by the sharp strain localization there, while those nearby in the matrix coarsen by Ostwald ripening due to the increased atomic mobility. The experimental evidence demonstrates that there exists an affected zone around the shear band. This zone may arise from low-strain plastic deformation in the matrix between the bands. These results suggest that measured property changes originate not only from the shear bands themselves, but also from the affected zones in the adjacent matrix. This work sheds light on direct visualization of deformation-related effects, in particular increased atomic mobility, in the region around shear bands.Financial support for this research is gratefully acknowledged: for J.H. from the Alexander von Humboldt Foundation, the National Natural Science Foundation of China (Grant No. 51374194 and 51574216) and the Natural Science Foundation of Liaoning Province of China (Grant No.2015020172); for J.E. and I.K. from the German Federal Ministry of Education and Science (Project No 05K12OD1) and the German Science Foundation under the Leibniz Program (Grant EC 111/26-1); for D.H.K. from the Global Research Laboratory Program of the Korean Ministry of Education, Science and Technology; and for A.L.G. from the Engineering and Physical Sciences Research Council (UK) and the World Premier International Research Center Initiative (WPI), MEXT, Japan.This is the author accepted manuscript. It is currently under an indefinite embargo pending publication by Nature Publishing Group
A neutralizing bispecific single-chain antibody against SARS-CoV-2 Omicron variant produced based on CR3022
IntroductionThe constantly mutating SARS-CoV-2 has been infected an increasing number of people, hence the safe and efficacious treatment are urgently needed to combat the COVID-19 pandemic. Currently, neutralizing antibodies (Nabs), targeting the receptor-binding domain (RBD) of the SARS-CoV-2 spike protein are potentially effective therapeutics against COVID-19. As a new form of antibody, bispecific single chain antibodies (BscAbs) can be easily expressed in E. coli and exhibits broad-spectrum antiviral activity.MethodsIn this study, we constructed two BscAbs 16-29, 16-3022 and three single chain variable fragments (scFv) S1-16, S2-29 and S3022 as a comparison to explore their antiviral activity against SARS-CoV-2. The affinity of the five antibodies was characterized by ELISA and SPR and the neutralizing activity of them was analyzed using pseudovirus or authentic virus neutralization assay. Bioinformatics and competitive ELISA methods were used to identify different epitopes on RBD.ResultsOur results revealed the potent neutralizing activity of two BscAbs 16-29 and 16-3022 against SARS-CoV-2 original strain and Omicron variant infection. In addition, we also found that SARS-CoV RBD-targeted scFv S3022 could play a synergistic role with other SARS-CoV-2 RBD-targeted antibodies to enhance neutralizing activity in the form of a BscAb or in cocktail therapies.DiscussionThis innovative approach offers a promising avenue for the development of subsequent antibody therapies against SARSCoV-2. Combining the advantages of cocktails and single-molecule strategies, BscAb therapy has the potential to be developed as an effective immunotherapeutic for clinical use to mitigate the ongoing pandemic
Corrigendum: A neutralizing bispecific single-chain antibody against SARS-CoV-2 Omicron variant produced based on CR3022
- …