450 research outputs found
5.5-7.5 MeV Proton generation by a moderate intensity ultra-short laser interaction with H2O nano-wire targets
We report on the first generation of 5.5-7.5 MeV protons by a moderate
intensity short-pulse laser (4.5 \times 1017 W/cm^2, 50 fsec) interacting with
H2O nano-wires (snow) deposited on a Sapphire substrate. In this setup, the
laser intensity is locally enhanced by the tip of the snow nano-wire, leading
to high spatial gradients. Accordingly, the plasma near the tip is subject to
enhanced ponderomotive potential, and confined charge separation is obtained.
Electrostatic fields of extremely high intensities are produced over the short
scale length, and protons are accelerated to MeV-level energies.Comment: submitted to PRL, under press embargo. 6 figure
High resolution X-ray emission spectra from picosecond laser irradiated Ge targets
Investigations of a high resolution X-ray emission spectrum in the range 0.66–0.75 nm obtained by irradiating a Germanium target with high-power p-polarized, 40 picosecond laser radiation at 532 nm wavelength was done. Spectra in the wavelength region of 2l-4l′ and 2l-5l′ L-shell transitions in F-like, Ne-like and Na-like germanium ions were recorded using the FSSR-2D spectrometer equipped with a spherically bent quartz crystal with a spectral resolution λ/Δλ better than 5000. Spectral lines were compared with theoretical values obtained using the LANL plasma kinetic code ATOMIC. Fair agreement between experimental and theoretical spectral lines has been observed, which allowed to measure enough high bulk electron temperature values of 560 eV and electron density of ∼1021 cm−3 in Ge plasma irradiated by rather small commercial high repetition rate Nd:YAG laser system
High resolution and high efficiency coloration of lithium fluoride by soft X-rays irradiation
The efficient coloration of LiF material, in the form of bulk and films, by EUV and soft X-rays emitted by a laser-plasma source is demonstrated. The short penetration depth of soft-X-rays is exploited to obtain high spatial resolution luminescent patterns while the high dynamic range of proportionality between X-ray dose and coloration is exploited for using LiF as image detector in micro-radiography and soft X-ray microscopy applications
Effect of plastic coating on the density of plasma formed in Si foil targets irradiated by ultra-high-contrast relativistic laser pulses
The formation of high energy density matter occurs in inertial confinement fusion, astrophysical, and geophysical systems. In this context, it is important to couple as much energy as possible into a target while maintaining high density. A recent experimental campaign, using buried layer (or "sandwich" type) targets and the ultrahigh laser contrast Vulcan petawatt laser facility, resulted in 500 Mbar pressures in solid density plasmas (which corresponds to about 4.6×107J/cm3 energy density). The densities and temperatures of the generated plasma were measured based on the analysis of X-ray spectral line profiles and relative intensities
Recommended from our members
X-ray emission from stainless steel foils irradiated by femtosecond petawatt laser pulses
We report about nonlinear growth of x-ray emission intensity emitted from plasma generated by femtosecond petawatt laser pulses irradiating stainless steel foils. X-ray emission intensity increases as ∼ I 4.5 with laser intensity I on a target. High spectrally resolved x-ray emission from front and rear surfaces of 5 μm thickness stainless steel targets were obtained at the wavelength range 1.7-2.1 Å, for the first time in experiments at femtosecond petawatt laser facility J-KAREN-P. Total intensity of front x-ray spectra three times dominates to rear side spectra for maximum laser intensity I ≈ 3.21021 W/cm2. Growth of x-ray emission is mostly determined by contribution of bremsstrahlung radiation that allowed estimating bulk electron plasma temperature for various magnitude of laser intensity on target
- …