Constraining the range of Yukawa gravity interaction from S2 star orbits III: improvement expectations for graviton mass bounds

Recently, the LIGO-Virgo collaboration discovered gravitational waves and in their first publication on the subject the authors also presented a graviton mass constraint as $m_g < 1.2 \times 10^{-22}$ eV (Abbott et al., 2016). In the paper we analyze a potential to reduce upper bounds for graviton mass with future observational data on trajectories of bright stars near the Galactic Center. Since gravitational potentials are different for these two cases, expressions for relativistic advance for general relativity and Yukawa potential are different functions on eccentricity and semimajor axis, it gives an opportunity to improve current estimates of graviton mass with future observational facilities. In our considerations of an improvement potential for a graviton mass estimate we adopt a conservative strategy and assume that trajectories of bright stars and their apocenter advance will be described with general relativity expressions and it gives opportunities to improve graviton mass constraints. In contrast with our previous studies, where we present current constraints on parameters of Yukawa gravity (Borka et al., 2013) and graviton mass (Zakharov et al., 2016) from observations of S2 star, in the paper we express expectations to improve current constraints for graviton mass, assuming the GR predictions about apocenter shifts will be confirmed with future observations. We concluded that if future observations of bright star orbits during around fifty years will confirm GR predictions about apocenter shifts of bright star orbits it give an opportunity to constrain a graviton mass at a level around $5 \times 10^{-23}$ eV or slightly better than current estimates obtained with LIGO observations.Comment: 16 pages, 1 Figure, 1 Table, corrected minor typo

Physical model of quantum-well infrared photodetectors

A fully quantum mechanical model for electron transport in quantum well infrared photodetectors is presented, based on a self-consistent solution of the coupled rate equations. The important macroscopic parameters like current density, responsivity and capture probability can be estimated directly from this first principles calculation. The applicability of the model was tested by comparison with experimental measurements from a GaAs/AlGaAs device, and good agreement was found. The model is general and can be applied to any other material system or QWIP design

Predictive control of wind turbines by considering wind speed forecasting techniques

A wind turbine system is operated such that the points of wind rotor curve and electrical generator curve coincide. In order to obtain maximum power output of a wind turbine generator system, it is necessary to drive the wind turbine at an optimal rotor speed for a particular wind speed. A Maximum Power Point Tracking (MPPT) controller is used for this purpose. In fixed-pitch variable-speed wind turbines, wind-rotor parameters are fixed and the restoring torque of the generator needs to be adjusted to maintain optimum rotor speed at a particular wind speed for optimum power output. In turbulent wind environment, control of variable-speed fixed-pitch wind turbine systems to continuously operate at the maximum power points becomes difficult due to fluctuation of wind speeds. In this paper, wind speed forecasting techniques will be considered for predictive optimum control system of wind turbines

Optically pumped intersublevel midinfrared lasers based on InAs-GaAs quantum dots

We propose an optically pumped laser based on intersublevel transitions in InAs-GaAs pyramidal self-Assembled quantum dots. A theoretical rate equations model of the laser is given in order to predict the dependence of the gain on pumping flux and temperature. The energy levels and wave functions were calculated using the 8-band k . p method where the symmetry of the pyramid was exploited to reduce the computational complexity. Carrier dynamics in the laser were modeled by taking both electron-longitudinal optical phonon and electron-longitudinal acoustic phonon interactions into account. The proposed laser emits at 14.6 μm with a gain of g ≈ 570 cm(-1) at the pumping flux Φ= 10(24) cm(-2) s(-1) and a temperature of T = 77 K. By varying the size of the investigated dots, laser emission in the spectral range 13-21 μm is predicted. In comparison to optically pumped lasers based on quantum wells, an advantage of the proposed type of laser is a lower pumping flux, due to the longer carrier lifetime in quantum dots, and also that both surface and edge emission are possible. The appropriate waveguide and cavity designs are presented, and by comparing the calculated values of the gain with the estimated losses, lasing is predicted even at room temperature for all the quantum dots investigated

Investigation of thermal effects in quantum-cascade lasers

The development of a thermal model for quantum cascade lasers (QCLs) is presented. The model is used in conjunction with a self-consistent scattering rate calculation of the electron dynamics of an InGaAs-AlAsSb QCL to calculate the temperature distribution throughout the device which can be a limiting factor for high temperature operation. The model is used to investigate the effects of various driving conditions and device geometries, such as epilayer down bonding and buried heterostructures, on the active region temperature. It is found that buried heterostructures have a factor of eight decrease in thermal time constants compared to standard ridge waveguide structures in pulsed mode and allow a /spl sim/78% increase in heat sink temperature compared to epilayer down mounted devices in continuous-wave mode. The model presented provides a valuable tool for understanding the thermal dynamics inside a quantum cascade laser and will help to improve their operating temperatures

The influence of microlensing on the shape of the AGN Fe K-alpha line

We study the influence of gravitational microlensing on the AGN Fe K-alpha line confirming that unexpected enhancements recently detected in the iron line of some AGNs can be produced by this effect. We use a ray tracing method to study the influence of microlensing in the emission coming from a compact accretion disc considering both geometries, Schwarzschild and Kerr. Thanks to the small dimensions of the region producing the AGN Fe K-alpha line, the Einstein Ring Radii associated to even very small compact objects have size comparable to the accretion disc hence producing noticeable changes in the line profiles. Asymmetrical enhancements contributing differently to the peaks or to the core of the line are produced by a microlens, off-centered with respect to the accretion disc. In the standard configuration of microlensing by a compact object in an intervening galaxy, we found that the effects on the iron line are two orders of magnitude larger than those expected in the optical or UV emission lines. In particular, microlensing can satisfactorily explain the excess in the iron line emission found very recently in two gravitational lens systems, H 1413+117 and MG J0414+0534. Exploring other physical {scenario} for microlensing, we found that compact objects (of the order of one Solar mass) which belong to {the bulge or the halo} of the host galaxy can also produce significant changes in the Fe K$_\alpha$ line profile of an AGN. However, the optical depth estimated for this type of microlensing is {very small, $\tau\sim 0.001$, even in a favorable case.Comment: Astron. Astrophys. accepte

Optically pumped terahertz laser based on intersubband transitions in a GaN/AlGaN double quantum well

A design for a GaN/AlGaN optically pumped terahertz laser emitting at 34 µm (ΔE~36 meV) is presented. This laser uses a simple three-level scheme where the depopulation of the lower laser level is achieved via resonant longitudinal-optical-phonon emission. The quasibound energies and associated wave functions are calculated with the intrinsic electric field induced by the piezoelectric and the spontaneous polarizations. The structures based on a double quantum well were simulated and the output characteristics extracted using a fully self-consistent rate equation model with all relevant scattering processes included. Both electron-longitudinal-optical phonon and electron-acoustic-phonon interactions were taken into account. The carrier distribution in subbands was assumed to be Fermi–Dirac-like, with electron temperature equal to the lattice temperature, but with different Fermi levels for each subband. A population inversion of 12% for a pumping flux Φ=10(27) cm(–2) s(–1) at room temperature was calculated for the optimized structure. By comparing the calculated modal gain and estimated waveguide and mirror losses the feasibility of laser action up to room temperature is predicted

Influence of Intra-cell Traffic on the Output Power of Base Station in GSM

In this paper we analyze the influence of intracell traffic in a GSM cell on the base station output power. It is proved that intracell traffic increases this power. If offered traffic is small, the increase of output power is equal to the part of intracell traffic. When the offered traffic and, as the result, call loss increase, the increase of output power becomes less. The results of calculation are verified by the computer simulation of traffic process in the GSM cell. The calculation and the simulation consider the uniform distribution of mobile users in the cell, but the conclusions are of a general nature