24,127 research outputs found
Modeling Multicomponent Fuel Droplet Vaporization with Finite Liquid Diffusivity Using Coupled Algebraic-Dqmom with Delumping
Multicomponent fuel droplet vaporization models for use in combustion CFD codes often prioritize computational efficiency over model complexity. This leads to oversimplifying assumptions such as single component droplets or infinite liquid diffusivity. The previously developed Direct Quadrature Method of Moments (DQMoM) with delumping model demonstrated a computationally efficient and accurate approach to solve for every discrete species in a well-mixed vaporizing multicomponent droplet. To expand the method to less restrictive cases, a new solution technique is presented called the Coupled Algebraic-Direct Quadrature Method of Moments (CA-DQMoM). In contrast to previous moment methods for droplet vaporization, CA-DQMoM solves for the evolution of two liquid distributions by coupling a monovariate, homogeneous DQMoM approach with additional algebraic moment equations, allowing for a more complex droplet vaporization model with finite rates of liquid diffusion to be solved with computational efficiency. To further decrease computational expense, an approximation that employs the same nodes for both distributions can be used in certain cases. Finally, a delumping technique is adapted to the finite diffusivity model to reconstruct discrete species information at minimal computational cost. The model is proven to be accurate relative to a full discrete component model for both a kerosene droplet comprised of 36 species and a multicomponent droplet of 200 species while maintaining the computational efficiency of continuous thermodynamics models. The combined accuracy and computational efficiency demonstrated by the CA-DQMoM with delumping model for a multicomponent fuel droplet with finite liquid diffusivity makes it ideal for incorporation into CFD models for complex combustion process
Assessing technical candidates on the social web
This is the pre-print version of this Article. The official published version can be accessed from the link below - Copyright @ 2012 IEEEThe Social Web provides comprehensive and publicly available information about software developers: they can be identified as contributors to open source projects, as experts at maintaining weak ties on social network sites, or as active participants to knowledge sharing sites. These signals, when aggregated and summarized, could be used to define individual profiles of potential candidates: job seekers, even if lacking a formal degree or changing their career path, could be qualitatively evaluated by potential employers through their online
contributions. At the same time, developers are aware of the Web’s public nature and the possible uses of published information when they determine what to share with the world. Some might even try to manipulate public
signals of technical qualifications, soft skills, and reputation in their favor. Assessing candidates on the Web for
technical positions presents challenges to recruiters and traditional selection procedures; the most serious being the interpretation of the provided signals.
Through an in-depth discussion, we propose guidelines for software engineers and recruiters to help them interpret the value and trouble with the signals and metrics they use to assess a candidate’s characteristics and skills
A study of Na(x)Pt3O4 as an O2 electrode bifunctional electrocatalyst
The present study suggests that polytetrafluoroethylene (PTFE) bonded Na(X)Pt3O4 gas porous diffusion electrodes may be a viable candidate for bifunctional O2 reduction and evolution activity. The electrodes exhibited Tafel slopes of about 0.06 V/decade for both O2 reduction an evolution. For O2 reduction, the 0.06 slope doubled to 0.12 V/decade at larger current densities. Preliminary stability testing at 24 C suggest that the Na(x)Pt3O4 electrodes were relatively stable at reducing and oxidizing potentials typically encountered at the O2 electrodes in a regenerative fuel cell
Cohomological Yang-Mills Theory in Eight Dimensions
We construct nearly topological Yang-Mills theories on eight dimensional
manifolds with a special holonomy group. These manifolds are the Joyce manifold
with holonomy and the Calabi-Yau manifold with SU(4) holonomy. An
invariant closed four form on the manifold allows us to
define an analogue of the instanton equation, which serves as a topological
gauge fixing condition in BRST formalism. The model on the Joyce manifold is
related to the eight dimensional supersymmetric Yang-Mills theory. Topological
dimensional reduction to four dimensions gives non-abelian Seiberg-Witten
equation.Comment: 9 pages, latex, Talk given at APCTP Winter School on Dualities in
String Theory, (Sokcho, Korea), February 24-28, 199
Oxygen electrode bifunctional electrocatalyst NiCo2O4 spinel
A significant increase in energy density may be possible if a two-unit alkaline regenerative H2-O2 fuel cell is replaced with a single-unit system that uses passive means for H2O transfer and thermal control. For this single-unit system, new electrocatalysts for the O2 electrode will be required which are not only bifunctionally active but also chemically and electrochemically stable between the voltage range of about 0.7 and 1.5 V. NiCo2O4 spinel is reported to have certain characteristics that make it useful for a study of electrode fabrication techniques. High surface area NiCo2O4 powder was fabricated into unsupported, bifunctional, PTFE-bonded, porous gas fuel cell electrodes by commercial sources using varying PTFE contents and sintering temperatures. The object of this study is to measure the bifunctional activities of these electrodes and to observe what performance differences might result from different commercial electrode fabricators. O2 evolution and O2 reduction data were obtained at 80 C (31 percent KOH). An irreversible reaction (i.e., aging) occurred during O2 evolution at potentials greater than about 1.5 V. Anodic Tafel slopes of 0.06 and 0.12 V/decade were obtained for the aged electrodes. Within the range of 15 to 25 percent, the PTFE content was not a critical parameter for optimizing the electrode for O2 evolution activity. Sintering temperatures between 300 and 340 C may be adequate but heating at 275 C may not be sufficient to properly sinter the PTFE-NiCo2O4 mixture. Electrode disintegration was observed during O2 reduction. Transport of O2 to the NiCo2O4 surface became prohibitive at greater than about -0.02 A/sq cm. Cathodic Tafel slopes of -0.6 and -0.12 V/decade were assumed for the O2 reduction process. A PTFE content of 25 percent (or greater) appears to be preferable for sintering the PTFE-NiCo2O4 mixture
Corrosion testing of candidates for the alkaline fuel cell cathode
It is desirable to employ a corrosion screening test for catalyst or support candidates for the fuel cell cathode before entering upon optimization of the candidate or of the catalytic electrode. To this end, corrosion test electrodes, intended for complete immersion and maximum wetting, have been made with 30 to 40 vol. pct Teflon; with perovskites this is about 10 to 15 pct. The candidates were synthesized by methods intended for single-phase product without special emphasis on high surface area, although the substances tested were no coarser than 2 m squared/g. A typical loading was 25 mg/cm sq of the pure substance, usually on gold screen, a few mm squared of which were left bare for contacting. Contact to the gold lead wire was made by welding with a micro-torch or a spot-welder. Corrosion testing consisted of obtaining current-voltage data under flowing inert gas in the potential region for reduction of O2. The electrode was immersed in 30 pct KOH. Observations were made at 20 C and 80 C, and the results compared with data from gold standards. Results with some perovskites, pyrochlores, spinels, and interstitial compounds will be discussed
O2 reduction at the IFC orbiter fuel cell O2 electrode
O2 reduction Tafel data were obtained for the IFC Orbiter fuel cell O2 electrode (Au-10 percent Pt catalyst) at temperatures between 24 and 81 C. BET measurements gave an electrode surface area of about 2040 sq cm per sq cm of geometric area. The Tafel data could be fitted to three straight line regions. For current densities less than 0.001 A/sq cm, the slope was essentially independent of temperature with a value of about 0.032 V/decade. Above 0.001 A/sq cm, the two regions, designated in the present study as the 0.04 and 0.12 V/decate regions, were temperature dependent. The apparent energies of activation for these two regions were about 9.3 and 6.5 kcal/mol, respectively. Tafel data (1 atmosphere O2) were extrapolated to 120 C for predicting changes in overpotential with increasing temperature. A mechanism is presented for O2 reduction
Corrosion testing of candidates for the alkaline fuel cell cathode
Current/voltage data was obtained for specially made corrosion electrodes of some oxides and of gold materials for the purpose of developing a screening test of catalysts and supports for use at the cathode of the alkaline fuel cell. The data consists of measurements of current at fixed potentials and cyclic voltammograms. These data will have to be correlated with longtime performance data in order to fully evaluate this approach to corrosion screening. Corrosion test screening of candidates for the oxygen reduction electrode of the alkaline fuel cell was applied to two substances, the pyrochlore Pb2Ru2O6.5 and the spinel NiCo2O4. The substrate gold screen and a sample of the IFC Orbiter Pt-Au performance electrode were included as blanks. The pyrochlore data indicate relative stability, although nothing yet can be said about long term stability. The spinel was plainly unstable. For this type of testing to be validated, comparisons will have to be made with long term performance tests
Special Quantum Field Theories In Eight And Other Dimensions
We build nearly topological quantum field theories in various dimensions. We
give special attention to the case of 8 dimensions for which we first consider
theories depending only on Yang-Mills fields. Two classes of gauge functions
exist which correspond to the choices of two different holonomy groups in
SO(8), namely SU(4) and Spin(7). The choice of SU(4) gives a quantum field
theory for a Calabi-Yau fourfold. The expectation values for the observables
are formally holomorphic Donaldson invariants. The choice of Spin(7) defines
another eight dimensional theory for a Joyce manifold which could be of
relevance in M- and F-theories. Relations to the eight dimensional
supersymmetric Yang-Mills theory are presented. Then, by dimensional reduction,
we obtain other theories, in particular a four dimensional one whose gauge
conditions are identical to the non-abelian Seiberg-Witten equations. The
latter are thus related to pure Yang-Mills self-duality equations in 8
dimensions as well as to the N=1, D=10 super Yang-Mills theory. We also exhibit
a theory that couples 3-form gauge fields to the second Chern class in eight
dimensions, and interesting theories in other dimensions.Comment: 36 pages, latex. References have been added together with a not
Solubility, stability, and electrochemical studies of sulfur-sulfide solutions in organic solvents
A preliminary study of the sulfur electrode in organic solvents suggests that the system warrants further investigation for use in a low temperature (100 deg to 120 C) Na-S secondary battery. A qualitative screening was undertaken at 120 C to determine the solubilities and stabilities of Na2S and Na2S2 in representatives of many classes of organic solvents. From the screening and quantitative studies, two classes of solvents were selected for work; amides and cyclic polyalcohols. Voltammetric and Na-S cell charge discharge studies of sulfide solutions in organic solvents (e.g., N, N-dimethylformamide) at 120 C suggested that the reversibilities of the reactions on Pt or high density graphite were moderately poor. However, the sulfur electrode was indeed reducible (and oxidizable) through the range of elemental sulfur to Na2S. Reactions and mechanisms are proposed for the oxidation reduction processes occurring at the sulfur electrode
- …