232 research outputs found
Tests of stability of stiffened plates, Fritz Engineering Laboratory, Lehigh University, 1948
Effects of concrete composition on transmission length of prestressing strands
The bond behaviour of prestressing strands in precast pretensioned concrete members, and its transmission length, depends on several factors. However, no consensus exists on the main parameters to be considered in the expressions to predict the transmission length. Usually when the concrete properties are considered, only the concrete compressive strength is included. This study analyzes the influence of concrete composition made up of different cement contents and water/cement ratios on the bond behaviour in transmission of seven-wire prestressing strands. The bond properties and the transmission lengths have been determined. The results show that the influence of the water/cement ratio is very small for concretes with lows cement contents, but the influence of the water/cement ratio on the transmission lengths is highly significant when cement content is high. The effect of cement content in the transmission lengths can reveal different tendencies based on the level of the water/cement ratioThe content of this article forms a part of research that the Universitat Politecnica de Valencia's Institute of Concrete Science and Technology (ICITECH) is presently conducting in conjunction with PREVALESA and ISOCRON. This study was funded by the Ministry of Education and Science and ERDF (Project BIA2006-05521). The authors wish to thank the above companies as well as the concrete structures laboratory technicians at the Universitat Politecnica de Valencia for their cooperation. Also, the authors wish to pay their respects to C.A. Arbelaez.Martí Vargas, JR.; Serna Ros, P.; Navarro Gregori, J.; Bonet Senach, JL. (2012). Effects of concrete composition on transmission length of prestressing strands. Construction and Building Materials. 27(1):350-356. https://doi.org/10.1016/j.conbuildmat.2011.07.038S35035627
Study of the Interactions of Ionic Liquids in IC by QSRR
The nature of ionic liquids (ILs) facilitates their analysis by ion chromatography which, unlike conventional high-performance liquid chromatography, enables analysis both of cations and anions. This paper describes a pioneering ion-chromatographic investigation of IL cations and statistical evaluation of quantitative structure–retention relationships with the objective of predicting the molecular mechanism responsible for retention. Eleven ionic liquid imidazolium and pyridinium cations were analyzed on a CS15 cation-exchange column by isocratic elution with acetonitrile–methanesulfonic acid mixtures. Structural descriptors of the cations obtained from molecular modeling were used to describe their hydrophobicity as determined by chromatography. The most statistically significant were three-term QSRR regression equations relating log kw to analyte n-octanol–water partition coefficient (log P), dipole moment (μ), solvent accessible surface area (ASAS), and hydration energy (HE). They indicate the important role of both hydrophobic and polar the retention of ILs on the CS15 column
The Establishment of the European Company: The First Cases from an Industrial Relations Perspective
Towards a Standard Psychometric Diagnostic Interview for Subjects at Ultra High Risk of Psychosis: CAARMS versus SIPS.
Background. Several psychometric instruments are available for the diagnostic interview of subjects at ultra high risk (UHR) of psychosis. Their diagnostic comparability is unknown. Methods. All referrals to the OASIS (London) or CAMEO (Cambridgeshire) UHR services from May 13 to Dec 14 were interviewed for a UHR state using both the CAARMS 12/2006 and the SIPS 5.0. Percent overall agreement, kappa, the McNemar-Bowker χ (2) test, equipercentile methods, and residual analyses were used to investigate diagnostic outcomes and symptoms severity or frequency. A conversion algorithm (CONVERT) was validated in an independent UHR sample from the Seoul Youth Clinic (Seoul). Results. There was overall substantial CAARMS-versus-SIPS agreement in the identification of UHR subjects (n = 212, percent overall agreement = 86%; kappa = 0.781, 95% CI from 0.684 to 0.878; McNemar-Bowker test = 0.069), with the exception of the brief limited intermittent psychotic symptoms (BLIPS) subgroup. Equipercentile-linking table linked symptoms severity and frequency across the CAARMS and SIPS. The conversion algorithm was validated in 93 UHR subjects, showing excellent diagnostic accuracy (CAARMS to SIPS: ROC area 0.929; SIPS to CAARMS: ROC area 0.903). Conclusions. This study provides initial comparability data between CAARMS and SIPS and will inform ongoing multicentre studies and clinical guidelines for the UHR psychometric diagnostic interview.Peer Reviewe
Glucose Recovery from Different Corn Stover Fractions Using Dilute Acid and Alkaline Pretreatment Techniques
Background: Limited availability of corn stover due to the competing uses (organic manure, animal feed, bio-materials, and bioenergy) presents a major concern for its future in the bio-economy. Furthermore, biomass research has exhibited different results due to the differences in the supply of enzymes and dissimilar analytical methods. The effect of the two leading pretreatment techniques (dilute acid and alkaline) on glucose yield from three corn stover fractions (cob, stalk, and leaf) sourced from a single harvest in Uganda were studied at temperatures 100, 120, 140, and 160 °C over reaction times of 5, 10, 30, and 60 min.
Results: From this study, the highest glucose concentrations obtained from the dilute acid (DA) pretreated cobs, stalks, and leaves were 18.4 g/L (66.8% glucose yield), 16.2 g/L (64.1% glucose yield), and 11.0 g/L (49.5% glucose yield), respectively. The optimal pretreatment settings needed to obtain these yields from the DA pretreated samples were at a temperature of 160 °C over an incubation time of 30 min. The highest glucose concentrations obtained from the alkaline (AL) pretreated cobs, stalks, and leaves were 24.7 g/L (81.73% glucose yield), 21.3 g/L (81.23% glucose yield), and 15.0 g/L (51.92% glucose yield), respectively. To be able to achieve these yields, the optimal pretreatment settings for the cobs and stalks were 140 °C and for a retention time of 30 min, while the leaves require optimal conditions of 140 °C and for a retention time of 60 min.
Conclusions: The study recommends that the leaves could be left on the field during harvesting since the recovery of glucose from the pretreated cobs and stalks is higher
Osteopenia, decreased bone formation and impaired osteoblast development in Sox4 heterozygous mice
The transcription factor Sox4 is vital for fetal development, as Sox4–/– homozygotes die in utero. Sox4 mRNA is expressed in the early embryonic growth plate and is regulated by parathyroid hormone, but its function in bone modeling/remodeling is unknown. We report that Sox4+/– mice exhibit significantly lower bone mass (by dual-energy X-ray absorptiometry) from an early age, and fail to obtain the peak bone mass of wild-type (WT) animals. Microcomputed tomography (μCT), histomorphometry and biomechanical testing of Sox4+/– bones show reduced trabecular and cortical thickness, growth plate width, ultimate force and stiffness compared with WT. Bone formation rate (BFR) in 3-month-old Sox4+/– mice is 64% lower than in WT. Primary calvarial osteoblasts from Sox4+/– mice demonstrate markedly inhibited proliferation, differentiation and mineralization. In these cultures, osterix (Osx) and osteocalcin (OCN) mRNA expression was reduced, whereas Runx2 mRNA was unaffected. No functional defects were found in osteoclasts. Silencing of Sox4 by siRNA in WT osteoblasts replicated the defects observed in Sox4+/– cells. We demonstrate inhibited formation and altered microarchitecture of bone in Sox4+/– mice versus WT, without apparent defects in bone resorption. Our results implicate the transcription factor Sox4 in regulation of bone formation, by acting upstream of Osx and independent of Runx2
Effects of pretreatments of Napier Grass with deionized water, sulfuric acid and sodium hydroxide on pyrolysis oil characteristics
The depletion of fossil fuel reserves has led to
increasing interest in liquid bio-fuel from renewable biomass. Biomass is a complex organic material consisting of
different degrees of cellulose, hemicellulose, lignin,
extractives and minerals. Some of the mineral elements
tend to retard conversions, yield and selectivity during
pyrolysis processing. This study is focused on the extraction of mineral retardants from Napier grass using deionized water, dilute sodium hydroxide and sulfuric acid and subsequent pyrolysis in a fixed bed reactor. The raw biomass was characterized before and after each pretreatment
following standard procedure. Pyrolysis study was conducted
in a fixed bed reactor at 600 o�C, 30 �C/min and 30 mL/min N2 flow. Pyrolysis oil (bio-oil) collected was analyzed using standard analytic techniques. The bio-oil yield and characteristics from each pretreated sample were compared with oil from the non-pretreated sample. Bio-oil
yield from the raw sample was 32.06 wt% compared to
38.71, 33.28 and 29.27 wt% oil yield recorded from the
sample pretreated with sulfuric acid, deionized water and
sodium hydroxide respectively. GC–MS analysis of the oil
samples revealed that the oil from all the pretreated biomass had more value added chemicals and less ketones and
aldehydes. Pretreatment with neutral solvent generated
valuable leachate, showed significant impact on the ash
extraction, pyrolysis oil yield, and its composition and
therefore can be regarded as more appropriate for thermochemical conversion of Napier grass
Enzymatic hydrolysis of sorghum straw using native cellulase produced by T. reesei NCIM 992 under solid state fermentation using rice straw
Cellulose is a major constituent of renewable lignocellulosic waste available in large quantities and is considered the most important reservoir of carbon for the production of glucose, for alternative fuel and as a chemical feedstock. Over the past decade, the emphasis has been on the enzymatic hydrolysis of cellulose to glucose and the efficiency of which depends on source of cellulosic substrate, its composition, structure, pretreatment process, and reactor design. In the present study, efforts were made to produce cellulase enzyme using rice straw. The produced enzyme was used for the hydrolysis of selected lignocellulosic substrate, i.e., sorghum straw. When rice straw was used as a substrate for cellulase production under solid state fermentation, the highest enzyme activity obtained was 30.7 FPU/gds, using T. reesei NCIM 992. 25 FPU/g of cellulase was added to differently treated (native, alkali treated, alkali treated followed by 3% acid treated and alkali treated followed by 3 and 5% acid treated) sorghum straw and hydrolysis was carried out at 50 °C for 60 h. 42.5% hydrolysis was obtained after 36 h of incubation. Optimization of enzyme loading, substrate concentration, temperature, time and buffer yielded a maximum of 546.00 ± 0.55 mg/g sugars (54.60 ± 0.44 g/l) with an improved hydrolysis efficiency of 70 ± 0.45%. The enzymatic hydrolyzate can be used for fermentation of ethanol by yeasts
Regeneration of Soft Tissues Is Promoted by MMP1 Treatment after Digit Amputation in Mice
The ratio of matrix metalloproteinases (MMPs) to the tissue inhibitors of metalloproteinases (TIMPs) in wounded tissues strictly control the protease activity of MMPs, and therefore regulate the progress of wound closure, tissue regeneration and scar formation. Some amphibians (i.e. axolotl/newt) demonstrate complete regeneration of missing or wounded digits and even limbs; MMPs play a critical role during amphibian regeneration. Conversely, mammalian wound healing re-establishes tissue integrity, but at the expense of scar tissue formation. The differences between amphibian regeneration and mammalian wound healing can be attributed to the greater ratio of MMPs to TIMPs in amphibian tissue. Previous studies have demonstrated the ability of MMP1 to effectively promote skeletal muscle regeneration by favoring extracellular matrix (ECM) remodeling to enhance cell proliferation and migration. In this study, MMP1 was administered to the digits amputated at the mid-second phalanx of adult mice to observe its effect on digit regeneration. Results indicated that the regeneration of soft tissue and the rate of wound closure were significantly improved by MMP1 administration, but the elongation of the skeletal tissue was insignificantly affected. During digit regeneration, more mutipotent progenitor cells, capillary vasculature and neuromuscular-related tissues were observed in MMP1 treated tissues; moreover, there was less fibrotic tissue formed in treated digits. In summary, MMP1 was found to be effective in promoting wound healing in amputated digits of adult mice. © 2013 Mu et al
- …