Low-speed aerodynamic characteristics of a highly swept arrow wing configuration with several deflected leading edge concepts

The effectiveness of leading edge concepts for minimizing or controlling leading edge flow separation was studied. Emphasis was placed on low speed performance, stability, and control characteristics of configurations with highly swept wings. Simple deflection of the leading edge, a variable camber leading edge system, and a leading edge vortex flow system were among the concepts studied. The data are presented without analysis

Reynolds number effects on pressure loss and turbulence characteristics of four tube-bundle heat exchangers

The aerodynamic characteristics of pressure loss and turbulence on four tube-bundle configurations representing heat-exchanger geometries with nominally the same heat capacity were measured as a function of Reynolds numbers from about 4000 to 400,000 based on tube hydraulic diameter. Two configurations had elliptical tubes, the other two had round tubes, and all four had plate fins. The elliptical-tube configurations had lower pressure loss and turbulence characteristics than the round-tube configurations over the entire Reynolds number range

Longitudinal aerodynamics of a low-wing lift-fan transport including hover characteristics in and out of ground effect

A wind-tunnel investigation was conducted in the Langley V/STOL tunnel to determine the longitudinal aerodynamic characteristics of a six-fan, tip-driven (remote) lift-fan VTOL transport throughout transition. The large midspan lift-fan pods and cruise fans were removed to determine their influence on the stability and control of the configuration. Data were obtained in the hovering mode for ranges of model height above ground. The data are presented without analysis or discussion

Experimental and theoretical aerodynamic characteristics of a high-lift semispan wing model

Experimental and theoretical aerodynamic characteristics were compared for a high-lift, semispan wing configuration that incorporated a slightly modified version of the NASA Advanced Laminar Flow Control airfoil section. The experimental investigation was conducted in the Langley 14- by 22-Foot Subsonic Tunnel at chord Reynolds numbers of 2.36 and 3.33 million. A two-dimensional airfoil code and a three-dimensional panel code were used to obtain aerodynamic predictions. Two-dimensional data were corrected for three-dimensional effects. Comparisons between predicted and measured values were made for the cruise configuration and for various high-lift configurations. Both codes predicted lift and pitching moment coefficients that agreed well with experiment for the cruise configuration. These parameters were overpredicted for all high-lift configurations. Drag coefficient was underpredicted for all cases. Corrected two-dimensional pressure distributions typically agreed well with experiment, while the panel code overpredicted the leading-edge suction peak on the wing. One important feature missing from both of these codes was a capability for separated flow analysis. The major cause of disparity between the measured data and predictions presented herein was attributed to separated flow conditions

Low-speed aerodynamic characteristics of a highly swept, untwisted uncambered arrow wing

An investigation was conducted in the Langley 4- by 7-Meter Tunnel to provide a detailed study of wing pressure distributions and forces and moments acting on a highly swept arrow-wing model at low Mach numbers (0.25). A limited investigation of the effect of spoilers at several locations was also conducted. Analysis of the pressure data shows that for the configuration with undeflected leading edges, vortex separation occurs on the outboard wing panel for angles of attack on the order of only 3 deg, whereas conventional leading-edge separation occurs at a nondimensional semispan station of 0.654 for the same incidence angle. The pressure data further show that vortex separation exists at wing stations more inboard for angles of attack on the order of 7 deg and that these vortices move inboard and forward with increasing angle of attack. The force and moment data show the expected nonlinear increments in lift and pitching moment and the increased drag associated with the vortex separation. The pressure data and corresponding force and moment data confirm that deflecting the entire wing leading edge uniformly to 30 deg is effective in forestalling the onset of flow separation to angles of attack greater than 8.6 deg; however, the inboard portion of the leading edge is overdeflected. The investigation further identifies the contribution of the trailing-edge flap deflection to the leading-edge upwash fields

Effect of Pylon Wake with and Without Pylon Blowing on Propeller Thrust

Pylon trailing edge blowing was investigated as a means of alleviating the effects of the pylon wake on a pusher arrangement of an advanced single-rotation turboprop. Measurements were made of steady-state propeller thrust and pylon wake pressures and turbulence levels with and without blowing. Results show that the pylon trailing edge blowing practically eliminated the pylon wake, significantly reduced the pylon wake turbulence, and had a relatively small effect on the steady-state propeller thrust. The data are presented with a minimum of analysis

Low-speed wind-tunnel tests of an advanced eight-bladed propeller

As part of a research program on advanced turboprop aircraft aerodynamics, a low-speed wind-tunnel investigation was conducted to document the basic performance and force and moment characteristics of an advanced eight-bladed propeller. The results show that in addition to the normal force and pitching moment produced by the propeller/nacelle combination at angle of attack, a significant side force and yawing moment are also produced. Furthermore, it is shown that for test conditions wherein compressibility effects can be ignored, accurate simulation of propeller performance and flow fields can be achieved by matching the nondimensional power loading of the model propeller to that of the full-scale propeller

Evaluation of the Langley 4- by 7-meter tunnel for propeller noise measurements

An experimental and theoretical evaluation of the Langley 4- by 7- Meter Tunnel was conducted to determine its suitability for obtaining propeller noise data. The tunnel circuit and open test section are described. An experimental evaluation is performed using microphones placed in and on the tunnel floor. The reflection characteristics and background noise are determined. The predicted source (propeller) near-field/far-field boundary is given using a first-principles method. The effect of the tunnel-floor boundry layer on the noise from the propeller is also predicted. A propeller test stand used for part of his evaluation is also described. The measured propeller performance characteristics are compared with those obtained at a larger scale, and the effect of the test-section configuration on the propeller performance is examined. Finally, propeller noise measurements were obtained on an eight-bladed SR-2 propeller operating at angles of attack -8 deg, 0 deg, and 4.6 deg to give an indication of attainable signal-to-noise ratios

Effect of age, body condition, pregnancy and lactation on circulating leptin concentrations in beef cattle

A series of experiments were conducted to evaluate the potential role of leptin in bovine reproduction. In Experiment 1, mean circulating leptin concentrations of postpartum cows were not affected by exogenous dexamethasone treatments. In Experiment 2, mean leptin concentrations were not correlated with female age or body weight but were positively correlated with body condition scores of beef cattle. Leptin concentrations were higher in 1 year old heifers (8.9 ng/ml) compared with 2 year old cows (6.0 ng/ml), but heifer leptin concentrations were not different than 4 to 6 year old cows (8.0 ng/ml) and cows ≥7 years of age (10.5 ng/ml). Mean leptin concentrations were negatively correlated with age in heifers and cows ≤2 years of age and positively correlated with age in cows \u3e3 years of age. In Experiment 3, there were no differences in mean leptin concentrations for 56 days starting 14 days following AI among 2-year old and 3-year old cows pregnant to AI (1.2 ng/ml), the clean-up bulls (1.2 ng/ml) and nonpregnant females (2.2 ng/ml) after a 60-day breeding season. Plasma leptin concentrations were lower for lactating cows (1.0 ng/ml) compared with nonlactating cows (2.1 ng/ml). Female age did not affect circulating leptin concentrations. In Experiment 4, oviduct and uterine epithelial cells from mid-luteal phase females stained positive for the long form of the leptin receptor, and uterine biopsies revealed intense staining for the long form of the leptin receptor on the luminal side of the uterine endometrium. Bovine blastocysts stained positive for the long form of the leptin receptor in the trophoblast cells. In Experiment 5, addition of leptin to culture medium at 0, 100 and 1,000 ng/ml did not affect the percentage embryos developing to the blastocyst stage. Also, leptin did not affect the ratio of blastocysts:8- to 16-cell embryos among the 0 ng/ml treatment group, the 100 ng/ml treatment and the 1,000 ng/ml treatment groups. Results indicate that in the beef cow, the release of leptin and subsequent role(s) of leptin in reproductive processes are likely different than those that have been reported for mice, rats and humans