23 research outputs found
Recommended from our members
Reservoir scale reactive-transport modeling of a buoyancy-controlled CO2 plume with impurities (SO2, NO2, O2)
A demonstration project for the geological storage of CO2 is currently being considered in the deep Precipice Sandstone formation of the Surat Basin, Queensland, Australia. Because of the presence of potential fresh water resources in this formation, a reservoir-scale two-dimensional reactive-transport model was developed to assess temporal and spatial changes in water quality imposed by co-injecting CO2 with SO2, NO2, and O2 at this location. The model shows that because the injection rate is relatively low (60,000 tons/year), flow is buoyancy-dominated and under these conditions the predicted CO2 flow pattern is quite sensitive to fine-scale heterogeneities and the resolution of the numerical mesh. The model also shows that SO2 and NO2 readily partition into the aqueous phase in close vicinity of their injection point, lowering pH somewhat beyond the acidification from CO2 dissolution. Only O2 under redox disequilibrium conditions is modeled to persist in the CO2 plume away from the injection point, however at sub-ppm levels. This modeling effort demonstrates acidification near the wellbore due to the preferential stripping of gas impurities, and accumulation of CO2 around a lithostratigraphic boundary above the target formation, where relatively rapid mineral dissolution (muscovite, chlorite and calcite) and precipitation (ankerite, kaolinite and chalcedony) occur
Use of 16S rRNA Gene Based Clone Libraries to Assess Microbial Communities Potentially Involved in Anaerobic Methane Oxidation in a Mediterranean Cold Seep
This study provides data on the diversities of bacterial and archaeal communities in an active methane seep at the Kazan mud volcano in the deep Eastern Mediterranean sea. Layers of varying depths in the Kazan sediments were investigated in terms of (1) chemical parameters and (2) DNA-based microbial population structures. The latter was accomplished by analyzing the sequences of directly amplified 16S rRNA genes, resulting in the phylogenetic analysis of the prokaryotic communities. Sequences of organisms potentially associated with processes such as anaerobic methane oxidation and sulfate reduction were thus identified. Overall, the sediment layers revealed the presence of sequences of quite diverse bacterial and archaeal communities, which varied considerably with depth. Dominant types revealed in these communities are known as key organisms involved in the following processes: (1) anaerobic methane oxidation and sulfate reduction, (2) sulfide oxidation, and (3) a range of (aerobic) heterotrophic processes. In the communities in the lowest sediment layer sampled (22–34 cm), sulfate-reducing bacteria and archaea of the ANME-2 cluster (likely involved in anaerobic methane oxidation) were prevalent, whereas heterotrophic organisms abounded in the top sediment layer (0–6 cm). Communities in the middle layer (6–22 cm) contained organisms that could be linked to either of the aforementioned processes. We discuss how these phylogeny (sequence)-based findings can support the ongoing molecular work aimed at unraveling both the functioning and the functional diversities of the communities under study
Preservation of organic matter in sediments promoted by iron
The biogeochemical cycles of iron and organic carbon are strongly interlinked. In oceanic waters, organic ligands have been shown to control the concentration of dissolved iron. In soils, solid iron phases shelter and preserve organic carbon, but the role of iron in the preservation of organic matter in sediments has not been clearly established. Here we use an iron reduction method previously applied to soils to determine the amount of organic carbon associated with reactive iron phases in sediments of various mineralogies collected from a wide range of depositional environments. Our findings suggest that 21.5 ± 8.6 per cent of the organic carbon in sediments is directly bound to reactive iron phases. We further estimate that a global mass of (19–45) × 1015 grams of organic carbon is preserved in surface marine sediments as a result of its association with iron. We propose that these associations between organic carbon and iron, which are formed primarily through co-precipitation and/or direct chelation, promote the preservation of organic carbon in sediments. Because reactive iron phases are metastable over geological timescales, we suggest that they serve as an efficient ‘rusty sink’ for organic carbon, acting as a key factor in the long-term storage of organic carbon and thus contributing to the global cycles of carbon, oxygen and sulphur
Recommended from our members
Sr-isotopic ratios trace mixing and dispersion in CO<inf>2</inf> push-pull injection experiments at the CO2CRC Otway Research Facility, Australia
Analysis of 87Sr/86Sr ratios and modelling of formation water, injection water and produced water
compositions from the CO2CRC Otway Research Facility in Victoria, Australia are used to test tracer
behaviour and response in push-pull experiments. Such experiments are an essential pre-requisite to
understanding the controls imposed by reservoir heterogeneities on CO2 dissolution rates which may
be an important stabilising mechanism for geological carbon storage. The experiments (Otway stage
2B extension in 2014) comprised two sequential tests in which ~ 100 tonnes of CO2-saturated water
was injected with combinations of Sr and Br or Li and Fluorescein tracers, each injection being followed
by two staged extractions of ~ 10 tons and a final extraction of ~ 50 tons all spaced at ~ 10 day
intervals. Analysis of the 87Sr/86Sr ratios of the produced fluids from the first injection, spiked with
SrCl2 and NaBr, is consistent with Sr behaving conservatively. This contrasts with previous interpretations
in which Br was argued to have behaved conservatively while Sr, which dilutes ~ three times as
fast as Br, was thought to be lost to a mineral phase. Such Sr-loss cannot explain the evolution of
87Sr/86Sr ratios. The analysis of 87Sr/86Sr ratios in the waters produced after the second injection episode,
spiked with LiCl and Fluorescein tracers, allows calculation of the fractions of the formation waters
and the injection waters from both tests 1 and 2. The Sr, Li and SO4 tracers (the later formed by oxidation
of formation sulphide) all indicate similar rates of dilution that is consistent with conservative
behaviour. The results of the two injection episodes with spaced extractions are compared with two
subsequent push-pull injections in which the produced waters, spiked with methanol, were extracted
continuously. These continuous extraction experiments exhibited significantly less dilution over the
same range of produced to injected water volumes (upto only ~ 0.6) than the earlier experiments with
spaced extractions. This implies that some process related to the pauses in extraction enhances mixing
of injected and formation waters. Achieving the objective of using push-pull experiments to assess
reservoir heterogeneities and CO2 dissolution rates will require better assessment of the various tracers
to establish which behave conservatively followed a proper understanding of the causes of the variations
in mixing as fluids are extracted from the formations.This study was supported by the UK Natural Environment Research council Highlight grant
NE/N015908/1. It is a contribution to GeoCquest, a BHP-supported collaborative project of the University
of Melbourne (Australia), the University of Cambridge (UK) and Stanford University (USA),
aimed at developing a better understanding of small-scale heterogeneity and its influence on CO2 trapping
mechanisms. The authors would like to thank CO2CRC Ltd. for giving access to data from the
CO2CRC’s Otway Research Facility
Recommended from our members
Reservoir scale reactive-transport modeling of a buoyancy-controlled CO2 plume with impurities (SO2, NO2, O2)
A demonstration project for the geological storage of CO2 is currently being considered in the deep Precipice Sandstone formation of the Surat Basin, Queensland, Australia. Because of the presence of potential fresh water resources in this formation, a reservoir-scale two-dimensional reactive-transport model was developed to assess temporal and spatial changes in water quality imposed by co-injecting CO2 with SO2, NO2, and O2 at this location. The model shows that because the injection rate is relatively low (60,000 tons/year), flow is buoyancy-dominated and under these conditions the predicted CO2 flow pattern is quite sensitive to fine-scale heterogeneities and the resolution of the numerical mesh. The model also shows that SO2 and NO2 readily partition into the aqueous phase in close vicinity of their injection point, lowering pH somewhat beyond the acidification from CO2 dissolution. Only O2 under redox disequilibrium conditions is modeled to persist in the CO2 plume away from the injection point, however at sub-ppm levels. This modeling effort demonstrates acidification near the wellbore due to the preferential stripping of gas impurities, and accumulation of CO2 around a lithostratigraphic boundary above the target formation, where relatively rapid mineral dissolution (muscovite, chlorite and calcite) and precipitation (ankerite, kaolinite and chalcedony) occur
Changes in the deep subsurface microbial biosphere resulting from a field-scale CO2 geosequestration experiment
Subsurface microorganisms may respond to increased CO2 levels in ways that significantly affect pore fluid chemistry. Changes in CO2 concentration or speciation may result from the injection of supercritical CO2 (scCO2) into deep aquifers. Therefore, understanding subsurface microbial responses to scCO2, or unnaturally high levels of dissolved CO2, will help to evaluate the use of geosequestration to reduce atmospheric CO2 emissions. This study characterized microbial community changes at the 16S rRNA gene level during a scCO2 geosequestration experiment in the 1.4 km-deep Paaratte Formation of the Otway Basin, Australia. One hundred and fifty tons of mixed scCO2 and groundwater was pumped into the sandstone Paaratte aquifer over 4 days. A novel U-tube sampling system was used to obtain groundwater samples under in situ pressure conditions for geochemical analyses and DNA extraction. Decreases in pH and temperature of 2.6 log units and 5.8°C, respectively, were observed. Polyethylene glycols (PEGs) were detected in the groundwater prior to scCO2 injection and were interpreted as residual from drilling fluid used during the emplacement of the CO2 injection well. Changes in microbial community structure prior to scCO2 injection revealed a general shift from Firmicutes to Proteobacteria concurrent with the disappearance of PEGs. However, the scCO2 injection event, including changes in response to the associated variables (e.g., pH, temperature and salinity), resulted in increases in the relative abundances of Comamonadaceae and Sphingomonadaceae suggesting the potential for enhanced scCO2 tolerance of these groups. This study demonstrates a successful new in situ sampling approach for detecting microbial community changes associated with an scCO2 geosequestration event