83 research outputs found
The role of advanced waste-To-energy technologies in landfill mining
Publicado en: WIT Transactions on Ecology and the Environment, Volume 224, Issue 1, 20 September 2017, Pages 403-409Recently, the European Parliament has decided to include a specific reference to "Enhanced Landfill Mining" (ELFM) in the Landfill Directive proposing a regulatory framework for ELFM so as to permit the retrieval of secondary raw materials that are present in existing landfill sites. Recent studies are supporting ELFM since they consider that landfill mining would be economically feasible only if combined with energy recovery (i.e., waste-To-energy, WtE) and if a wide range of materials are recovered (i.e., waste-To-materials, WtM). In this study, a combined material (landfill mining) and energy (advanced WtE) recovery is proposed where the excavated waste (MSW refuse) can be directly recycled or pretreated and used in the production of refuse-derived fuel (RDF) for an advanced (gasification-based) WtE plant producing power and heat. Both material and energy recovery are challenging in the circular economy since contributes to a loop-closing objective in human activities. An exhaustive assessment of each particular landfill site must be carried out in order to determine the profitability of the ELFM.Ministerio de Economía y Competitividad ENE2012-31598Ministerio de Ciencia, Innovación y Universidades CTM2016-78089-RUniversidad de Sevilla Contrato de Acceso al Sistema Español de Ciencia, Tecnología e Innovación (VPPI-US
Approximate Prediction of Gas-Solid Conversion in Fluidized Bed Reactors
A simple method is proposed to evaluate the performance of fluidized bed reactors where an nth-order gas-solid reaction occurs. The method takes into account the fluid dynamics of the fluidized bed by a two-phase flow model and the rates of diffusion in the solid reactant particles (internal and external) by a simple particle model. Approximate analytical expressions are derived in terms of three effectiveness factors: interphasic, external and intraparticle. These account for the contribution of fluid-dynamic and diffusional resistances to the overall mass-transfer resistance. Gas conversion is expressed in terms of four dimensionless governing quantities and the reaction order, in this way facilitating computations. Limiting cases of the general solution are discussed by comparison with analytical solutions found in literature. The methodology can be applied to catalytic or non-catalytic systems under isothermal conditions, where one heterogeneous reaction is involved
Data for the modelling of the future power system with a high share of variable renewable energy
Energy and power system models have become necessary tools that provide challenges and technical and economic solutions for integrating high shares of Variable Renewable Energy. Models are focused on analysing strategies of power systems to achieve their decarbonisation targets. The data presented in this paper includes the model algorithm, inputs, equations, modelling assumptions, supplementary materials, and results of the simulations supporting the research article titled “Facing the high share of variable renewable energy in the power system: flexibility and stability requirements”. The analysis is based on data from the system operator of one of the European Union member states (Spain). The developed model allows making projections and calculations to obtain the power generation of each technology, the international interconnections, inertia, emissions, system costs and flexibility requirements of new technologies. These data can be used for energy policy development or decision making on power capacity and the balancing needs of the future power system.Ministerio de Ciencia e Innovación PID2020-114725RA-I00Universidad de Sevilla VI PPIT-USPlan nacional I+D+I CTM2016-78089-RJunta de Andalucía P18-RT-451
Advanced utilisation options for biomass gasification fl y ash
The objective of this work was to search sustainable methods for the direct utilisation of the fly ash generated in a 150 kWth fluidised-bed pilot plant using Orujillo waste, a by-product from olive oil industry. An extensive characterization was made over raw ashes generated in the process. Existing (combustion) fly ash utilisation methods were found not to be directly applicable to these gasification ashes because of the high concentrations of unburned carbon and harmful soluble compounds. Further utilisation options for management of these ashes were identified. Two utilisation paths are investigated in detail in this work: the use of ash in the manufacture of gypsum wallboards and bricks with isolation properties. These utilisation options are based on lowcost preparation methods using ash in significant proportion, yielding a considerable high-value product. They represent promising new applications with high market potential. Dedicated tests to assess these two utilisation options are issued and from this the potential application of these routes is discussed. Keyboards: gasification; pilot plant; waste disposa
Poultry Litter Gasification in a Fluidized Bed Reactor: Effects of Gasifying Agent and Limestone Addition
Air and air-steam gasification of poultry litter was experimentally studied in a laboratory scale bubbling fluidized bed gasifier at atmospheric pressure using silica sand as the bed material. The effects of equivalence ratio (ER), gasifier temperature, steam-to-biomass ratio (SBR), and addition of limestone blended with the poultry litter, on product gas species yields and process efficiency, are discussed. The optimum conditions (maximum carbon conversion, gas yield, heating value, and cold gas efficiency) were achieved at an ER 0.25 and 800 °C, using air (SBR = 0) and poultry litter blended with 8% w/w limestone, yielding a product gas with a lower heating value (LHV) of 4.52 MJ/Nm 3 and an average product gas composition (dry basis) of H 2 : 10.78%, CO: 9.38%, CH 4 : 2.61, and CO 2 : 13.13. Under these optimum processing conditions, the cold gas efficiency, carbon conversion efficiency, and hydrogen conversion efficiency were 89, 73, and 43% respectively. The reported NH 3 measurement at an ER of 0.28 and 750 °C is 2.7% (equivalent to 19,300 mg/Nm 3 ) with 14.7 mg/Nm 3 of HCl observed as the dry product gas. High temperature and steam injection favor production of CO and H 2 , while their effect on CH 4 was almost negligible. It is demonstrated that poultry litter can be gasified by blending with limestone, making it possible to overcome the fluidization problems caused by the mineral composition of poultry litter ash (high K and P content), yielding a gas with a similar heating value compared to gasifying without limestone addition, but with a significantly lower tar content
Development and validation of an HIV risk exposure and indicator conditions questionnaire to support targeted HIV screening
The aim of our study was to develop a Spanish-structured HIV risk of exposure and indicator conditions (RE&IC) questionnaire. People attending to an emergency room or to a primary clinical care center were offered to participate in a prospective, 1 arm, open label study, in which all enrolled patients filled out our developed questionnaire and were HIV tested. Questionnaire accuracy, feasibility, and reliability were evaluated.
Valid paired 5329 HIV RE&IC questionnaire and rapid HIV tests were performed, 69.3% in the primary clinical care center, 49.6% women, median age 37 years old, 74.9% Spaniards, 20.1% Latin-Americans. Confirmed hidden HIV infection was detected in 4.1%, while HIV RE&IC questionnaire was positive in 51.2%. HIV RE&IC questionnaire sensitivity was 100% to predict HIV infection, with a 100% negative predictive value. When considered separately, RE or IC items sensitivity decreases to 86.4% or 91%, and similarly their negative predictive value to 99.9% for both of them. The majority of people studied, 90.8% self-completed HIV RE&IC questionnaire. Median time to complete was 3 minutes. Overall HIV RE&IC questionnaire test-retest Kappa agreement was 0.82 (almost perfect), likewise for IC items 0.89, while for RE items was lower 0.78 (substantial).
A feasible and reliable Spanish HIV RE&IC self questionnaire accurately discriminated all non–HIV-infected people without missing any HIV diagnoses, in a low prevalence HIV infection area. The best accuracy and reliability were obtained when combining HIV RE&IC items
Metodologías activas flexibles para la enseñanza en los Estudios LGBTIQ+ de la UCM en modo sincrónico y asincrónico: Campus Virtual, Redes Sociales y entornos online como herramientas para la innovación docente y participación del alumnado
Memoria del Proyecto de Innovación Docente Curso 2022021, Ciencias Sociales nº 39
A922 Sequential measurement of 1 hour creatinine clearance (1-CRCL) in critically ill patients at risk of acute kidney injury (AKI)
Meeting abstrac
Modeling of biomass gasification in fluidized bed
Modeling of biomass gasification in bubbling and circulating fluidized bed (FB) gasifiers is reviewed. Approaches applied for reactor modeling, from black-box models to computational fluid-dynamic models, are described. Special attention is paid to comprehensive fluidization models, where semi-empirical correlations are used to simplify the fluid-dynamics. The conversion of single fuel particles, char, and gas is examined in detail. The most relevant phenomena to be considered in modeling of FB biomass gasifiers are outlined, and the need for further investigation is identified. An updated survey of published mathematical reactor models for biomass and waste gasification in FB is presented. The overall conclusion is that most of the FB biomass gasification models fit reasonably well experiments selected for validation, despite the various formulations and input data. However, there are few measurements available for comparison with detailed model results. Also, validation of models with data from full-scale FB biomass gasification units remains to be done
- …