43,198 research outputs found
Intercomparisons of GOES-derived cloud parameters and surface observations over San Nicolas Island
The spatial sampling limitations of surface measurement systems necessitate the use of satellite data for the investigation of large-scale cloud processes. Understanding the information contained in the satellite-observed radiances, however, requires a connection between the remotely sensed cloud properties and those more directly observed within the troposphere. Surface measurements taken during the First ISCCP Regional Experiment (FIRE) Marine Stratocumulus Intensive Field Observations (IFO) are compared here to cloud properties determined from Geostationary Operational Environmental Satellite (GOES) data in order to determine how well the island measurements represent larger areas and to verify some of the satellite-measured parameters
Cloud parameters from GOES visible and infrared radiances during the FIRE Cirrus IFO, October 1986
Visible (VIS, 0.65 micron) and infrared (IR, 10.5 microns) channels on geostationary satellites are the key elements of the International Satellite Cloud Climatology Project (ISCCP). All daytime ISCCP cloud parameters are derived from a combination of VIS and IR data. Validation and improvement of the ISCCP and other cloud retrieval algorithms are important components of the First ISCCP Regional Experiment (FIRE) Intensive Field Observations (IFO). Data from the Cirrus IFO (October 19 to November 2, 1986) over Wisconsin are available for validating cirrus cloud retrievals from satellites. The Geostationary Operational Environmental Satellite (GOES) located over the Equator at approximately 100 deg W provided nearly continuous measurements of VIS and IR radiances over the IFO areas. The preliminary results of cloud parameters derived from the IFO GOES data are presented. Cloud attitudes are first derived using an algorithms without corrections for cloud emissivity. These same parameters will then be computed from the same data relying on an emissivity correction algorithm based on correlative data taken during the Cirrus IFO
Quantum oscillations observed in graphene at microwave frequencies
We have measured the microwave conductance of mechanically exfoliated
graphene at frequencies up to 8.5 GHz. The conductance at 4.2 K exhibits
quantum oscillations, and is independent of the frequency
Photo sensor array technology development
The development of an improved capability photo sensor array imager for use in a Viking '75 type facsimile camera is presented. This imager consists of silicon photodiodes and lead sulfide detectors to cover a spectral range from 0.4 to 2.7 microns. An optical design specifying filter configurations and convergence angles is described. Three electronics design approaches: AC-chopped light, DC-dual detector, and DC-single detector, are investigated. Experimental and calculated results are compared whenever possible using breadboard testing and tolerance analysis techniques. Results show that any design used must be forgiving of the relative instability of lead sulfide detectors. A final design using lead sulfide detectors and associated electronics is implemented by fabrication of a hybrid prototype device. Test results of this device show a good agreement with calculated values
A new nickel-base wrought superalloy for applications up to 1033 K (1400 F)
Alloy was melted from high purity raw materials and cast ingots extruded at 1422 K. Material was hot rolled to 0.013 m diameter bar stock. Partial solution heat-treatment followed by aging produced structure of fine gamma prime precipitate reinforcing gamma matrix containing coarser blocky gamma prime particles. Alloy can be processed by powder metallurgy
Laser velocimeter systems analysis applied to a flow survey above a stalled wing
A laser velocimeter operating in the backscatter mode was used to survey the flow above a stalled wing. Polarization was used to separate the two orthogonal velocity components of the fringe-type laser velocimeter, and digital counters were used for data processing. The velocities of the kerosene seed particles were measured with less than 2 percent uncertainty. The particle velocity measurements were collected into histograms. The flow field survey was carried out above an aspect-ratio-8 stalled wing with an NACA 0012 section. The angle of attack was 19.5 deg, the Mach number was 0.49, and the Reynolds number was 1,400,000. The flow field was characterized by the periodic shedding of discrete vortices from near the crest of the airfoil
- …