10,360 research outputs found
The uneasy case for lower Parking Standards
Minimum parking requirements are the norm for urban and suburban development in the United States (Davidson and Dolnick (2002)). The justification for parking space requirements is that overflow parking will occupy nearby street or off-street parking. Shoup (1999) and Willson (1995) provides cases where there is reason to believe that parking space requirements have forced parcel developers to place more parking than they would in the absence of parking requirements. If the effect of parking minimums is to significantly increase the land area devoted to parking, then the increase in impervious surfaces would likely cause water quality degradation, increased flooding, and decreased groundwater recharge. However, to our knowledge the existing literature does not test the effect of parking minimums on the amount of lot space devoted to parking beyond a few case studies. This paper tests the hypothesis that parking space requirements cause an oversupply of parking by examining the implicit marginal value of land allocated to parking spaces. This is an indirect test of the effects of parking requirements that is similar to Glaeser and Gyourko (2003). A simple theoretical model shows that the marginal value of additional parking to the sale price should be equal to the cost of land plus the cost of parking construction. We estimate the marginal values of parking and lot area with spatial methods using a large data set from the Los Angeles area non-residential property sales and find that for most of the property types the marginal value of parking is significantly below that of the parcel area. This evidence supports the contention that minimum parking requirements significantly increase the amount of parcel area devoted to parking. JEL codes:R52, H23Parking, Land Use, Sprawl
Experimental study on a metal hydride based hydrogen compressor
This is the post-print version of the final paper published in Journal of Alloys and Compounds. The published article is available from the link below. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. Copyright @ 2008 Elsevier B.V.A three-stage metal hydride based hydrogen compressor prototype was built. It has been designed for a hydrogen production facility using a low-pressure alkaline electrolyser. The compression system should transfer heat recovered from the electrolyser into the hydride beds to allow hydrogen desorption flow. The three-stage compressor achieves a compression ratio of 20:1 atm. It performs a thermal cycling of three AB5 hydrides between 20 and 80 °C. Its flow rate, for 25 g of each hydride bed, reaches about 20 l (NTP) of hydrogen per hour. The prototype is now operational. Some improvements in the heat transfer management system are also carried out before proceeding to the interconnection with the electrolyser and to the extent that the hydrogen produced satisfies the high purity requirement of the hydrides used in the compressor.Natural Resources Canada(NRCan), Ministère des Ressources Naturelles
et de la Faune du Québec (MRNF), and Natural Sciences and Engineering Research Council of Canada
Intentional Listening: Practicing a Vital Inclusive Behavior
In a classroom setting intentional listening has six distinctive stages Actively inviting classmates thoughts and opinions reflectively considering every aspect of what others say thanking others for expressing their ideas and beliefs putting what one has heard in a broader societal context connecting peers with similar ideas and insights and identifying the point of intersection between what you have heard and your own intuitions and experiences In instructional environments intentional listening takes practic
Optimum structural design with static aeroelastic constraints
The static aeroelastic performance characteristics, divergence velocity, control effectiveness and lift effectiveness are considered in obtaining an optimum weight structure. A typical swept wing structure is used with upper and lower skins, spar and rib thicknesses, and spar cap and vertical post cross-sectional areas as the design parameters. Incompressible aerodynamic strip theory is used to derive the constraint formulations, and aerodynamic load matrices. A Sequential Unconstrained Minimization Technique (SUMT) algorithm is used to optimize the wing structure to meet the desired performance constraints
- …