Experimental study on a metal hydride based hydrogen compressor

Abstract

This is the post-print version of the final paper published in Journal of Alloys and Compounds. The published article is available from the link below. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. Copyright @ 2008 Elsevier B.V.A three-stage metal hydride based hydrogen compressor prototype was built. It has been designed for a hydrogen production facility using a low-pressure alkaline electrolyser. The compression system should transfer heat recovered from the electrolyser into the hydride beds to allow hydrogen desorption flow. The three-stage compressor achieves a compression ratio of 20:1 atm. It performs a thermal cycling of three AB5 hydrides between 20 and 80 °C. Its flow rate, for 25 g of each hydride bed, reaches about 20 l (NTP) of hydrogen per hour. The prototype is now operational. Some improvements in the heat transfer management system are also carried out before proceeding to the interconnection with the electrolyser and to the extent that the hydrogen produced satisfies the high purity requirement of the hydrides used in the compressor.Natural Resources Canada(NRCan), Ministère des Ressources Naturelles et de la Faune du Québec (MRNF), and Natural Sciences and Engineering Research Council of Canada