252 research outputs found
Low Temperature MOCVD-Processed Alumina Coatings
We first present a Review about the preparation of alumina as thin films by the technique of MOCVD at low temperature (550°C and below). Then we present our results about thin films prepared by the low pressure MOCVD technique, using aluminium tri-isopropoxide as a source, and characterized by elemental analysis (EMPA, EDS, ERDA, RBS), FTIR, XRD and TGA. The films were grown in a horizontal, hot-wall reactor, with N2 as a carrier gas either pure or added with
water vapour. The deposition temperature was varied in the range 350-550°C. The films are amorphous. Those prepared at 350°C without water added in the gas phase have a formula close to AlOOH. Those deposited above 415°C are made of pure alumina Al2O3. When water is added in the gas phase, the films are pure alumina whatever the deposition temperature
Protective Alumina Coatings by Low Temperature Metalorganic Chemical Vapour Deposition
Alumina thin films were processed from aluminium tri-iso-propoxide in a horizontal, with N2 as a carrier gas, occasional addition of water in the gas phase, deposition temperature in the range 350-700°C, total pressure 0.67 kPa (2 kPa when water was used). The films do not diffract X-ray when prepared below 700°C. At 700°C, they start to crystallize as γ-alumina. EDS, EPMA, ERDA, RBS, FTIR and TGA revealed that films prepared in the range 350-
415°C, without water in the gas phase, have an overall composition Al2O3-x(OH)2x, with x tending to 0 with increasing temperature. Al2O3 is obtained above 415°C. When water is added in the vapour phase, the film composition is Al2O3, even below 415°C. Coatings deposited in these conditions show promising protection properties
Phase Transformations of Metallorganic Chemical Vapor Deposition Processed Alumina Coatings Investigated by In Situ Deflection
Phase transformations of Al2O3 films, deposited by metallorganic chemical vapor deposition from aluminium tri-isopropoxide on AISI 301 stainless steel, were investigated using an original technique of deflection associated with X-ray diffraction and electron microscopy. The samples were first oxidized at 1123 K in air to obtain a 0.9 m thick Cr2O3 protective oxide film on one side of the samples. Then, 1 m thick amorphous Al2O3 films were deposited on the opposite side at 823 K and 2 kPa. The deflection of such dissymmetrical samples was recorded during anisothermal treatments, consisting in slow heating to 1173 K in Ar atmosphere. The coefficient of thermal expansion of both the Cr2O3 and the amorphous Al2O3 films was determined to be 710−6 K−1 and 14.7 10−6 K−1, respectively. Crystallization kinetics of amorphous to mainly –Al2O3 become significant at temperatures equal or greater than 983 K. Transformation of metastable Al2O3 to –Al2O3 is initiated below 1173 K. It is demonstrated that deflection is a powerful tool for investigating the behavior of thin films deposited on a substrate and especially to reveal transformations occurring in these films during heat-treatments
Aluminium tri-iso-propoxide: Shelf life, transport properties, and decomposition kinetics for the low temperature processing of aluminium oxide-based coatings
Aluminium tri-iso-propoxide (ATI) is a common precursor for the MOCVD of alumina coatings. However, little is known on its long term stability while its saturated vapour pressure in function of the temperature is controversial. The present contribution deals with these questions through FTIR, TGA and vapour pressure measurements. Low pressure MOCVD from ATI was performed in the temperature range 250–700 °C. Whereas the pyrolytic decomposition of ATI leads to hydroxo species free alumina films above 415 °C, it is shown in this paper that the thermal decomposition of ATI in the presence of water vapour yields pure alumina films at temperatures as low as 300–350 °C. The films prepared in the range 250–700 °C do not diffract X-rays. Arrhenius plots for both pyrolytic (Ea∼12 kJ/mole) and water assisted (Ea∼9 kJ/mole) decomposition reveal diffusion-limited processes with higher growth rate values in the former case
Role of in vivo reflectance confocal microscopy in the analysis of melanocytic lesions
No abstract available</p
Artificial intelligence and architectural design : an introduction
Descripció del recurs: 27 juliol 2022The aim of this book on artificial intelligence for architects and designers is to guide future designers, in general, and architects, in particular, to support the social and cultural wellbeing of the humanity in a digital and global environment. This objective is today essential but also extremely large, interdisciplinary and interartistic, so we have done just a brief introduction of the subject. We will start with the argument fixed by the Professor Jonas Langer in his web some years ago, that we have defined as: “The Langer’s Tree”.Primera edició
Inorganic nitrate and nitrite supplementation fails to improve skeletal muscle mitochondrial efficiency in mice and humans
Supported by Medical Research Council program grant MRC G1001340 (to M Madhani, M Feelisch, and MP Frenneaux). We thank Lesley Cheyne for their contributions to the present study. The authors’ responsibilities were as follows—VSV, M Madhani, JDH, MF, DD, MPF: designed the research; MN, NEKP, KS, BLL, M Minnion, BOF, DV, DC-T, PGC: conducted the research; DV: provided essential materials; MN, NEKP, M Minnion, BOF, DC-T, MF, PGC: analyzed the data; MN, NEKP, PGC, MPF: wrote the paper; MPF: had primary responsibility for the final manuscript; and all authors: read and approved the final manuscript. None of the authors reported a conflict of interest related to the study.Peer reviewedPublisher PD
Changes in disease burden in Poland between 1990-2017 in comparison with other Central European countries : a systematic analysis for the Global Burden of Disease Study 2017
BACKGROUND:Systematic collection of mortality/morbidity data over time is crucial for monitoring trends in population health, developing health policies, assessing the impact of health programs. In Poland, a comprehensive analysis describing trends in disease burden for major conditions has never been published. The Global Burden of Diseases, Injuries, and Risk Factors Study (GBD) provides data on the burden of over 300 diseases in 195 countries since 1990. We used the GBD database to undertake an assessment of disease burden in Poland, evaluate changes in population health between 1990-2017, and compare Poland with other Central European (CE) countries. METHODS:The results of GBD 2017 for 1990 and 2017 for Poland and CE were used to assess rates and trends in years of life lost (YLLs), years lived with disability (YLDs), disability-adjusted life years (DALYs). Data came from cause-of-death registration systems, population health surveys, disease registries, hospitalization databases, and the scientific literature. Analytical approaches have been used to adjust for missing data, errors in cause-of-death certification, and differences in data collection methodology. Main estimation strategies were ensemble modelling for mortality and Bayesian meta-regression for disability. RESULTS:Between 1990-2017, age-standardized YLL rates for all causes declined in Poland by 46.0% (95% UI: 43.7-48.2), YLD rates declined by 4.0% (4.2-4.9), DALY rates by 31.7% (29.2-34.4). For both YLLs and YLDs, greater relative declines were observed for females. There was a large decrease in communicable, maternal, neonatal, and nutritional disease DALYs (48.2%; 46.3-50.4). DALYs due to non-communicable diseases (NCDs) decreased slightly (2.0%; 0.1-4.6). In 2017, Poland performed better than CE as a whole (ranked fourth for YLLs, sixth for YLDs, and fifth for DALYs) and achieved greater reductions in YLLs and DALYs than most CE countries. In 2017 and 1990, the leading cause of YLLs and DALYs in Poland and CE was ischaemic heart disease (IHD), and the leading cause of YLDs was low back pain. In 2017, the top 20 causes of YLLs and YLDs in Poland and CE were the same, although in different order. In Poland, age-standardized DALYs from neonatal causes, other cardiovascular and circulatory diseases, and road injuries declined substantially between 1990-2017, while alcohol use disorders and chronic liver diseases increased. The highest observed-to-expected ratios were seen for alcohol use disorders for YLLs, neonatal sepsis for YLDs, and falls for DALYs (3.21, 2.65, and 2.03, respectively). CONCLUSIONS:There was relatively little geographical variation in premature death and disability in CE in 2017, although some between-country differences existed. Health in Poland has been improving since 1990; in 2017 Poland outperformed CE as a whole for YLLs, YLDs, and DALYs. While the health gap between Poland and Western Europe has diminished, it remains substantial. The shift to NCDs and chronic disability, together with marked between-gender health inequalities, poses a challenge for the Polish health-care system. IHD is still the leading cause of disease burden in Poland, but DALYs from IHD are declining. To further reduce disease burden, an integrated response focused on NCDs and population groups with disproportionally high burden is needed
- …