Controlled release device prevents damage from dynamic stresses

Controlled release device that retards motion by extruding or drawing a tapered ductile pin through a die will control launch vehicle motion at liftoff. The device prevents the damaging dynamic stresses that are imposed on the vehicle when it is instantaneously released at full thrust

Controlled release device Patent

Controlled release device for use in launching rockets or missile

Semiempirical airframe noise prediction model and evaluation with flight data

A semiempirical maximum overall sound pressure level (OASPL) airframe noise model was derived. Noise radiated from aircraft wings was modeled on the trailing edge diffractes quadrupole sound theory. The acoustic dipole sound theory was used to model noise from the landing gear. The model was correlated with maximum OASPL flyover noise measurements obtained for three jet aircraft. One third octave band sound pressure level flyover data was correlated and interpreted

Landing approach airframe noise measurements and analysis

Flyover measurements of the airframe noise produced by the AeroCommander, JetStar, CV-990, and B-747 airplanes are presented for various landing approach configurations. Empirical and semiempirical techniques are presented to correlate the measured airframe noise with airplane design and aerodynamic parameters. Airframe noise for the jet-powered airplanes in the clean configuration (flaps and gear retracted) was found to be adequately represented by a function of airplane weight and the fifth power of airspeed. Results show the airframe noise for all four aircraft in the landing configuration (flaps extended and gear down) also varied with the fifth power of airspeed, but this noise level could not be represented by the addition of a constant to the equation for clean-configuration airframe noise

Performance improvements of a highly integrated digital electronic control system for an F-15 airplane

The NASA highly integrated digital electronic control (HIDEC) program is structured to conduct flight research into the benefits of integrating an aircraft flight control system with the engine control system. A brief description of the HIDEC system installed on an F-15 aircraft is provided. The adaptive engine control system (ADECS) mode is described in detail, together with simulation results and analyses that show the significant excess thrust improvements achievable with the ADECS mode. It was found that this increased thrust capability is accompanied by reduced fan stall margin and can be realized during flight conditions where engine face distortion is low. The results of analyses and simulations also show that engine thrust response is improved and that fuel consumption can be reduced. Although the performance benefits that accrue because of airframe and engine control integration are being demonstrated on an F-15 aircraft, the principles are applicable to advanced aircraft such as the advanced tactical fighter and advanced tactical aircraft

Measured noise reductions resulting from modified approach procedures for business jet aircraft

Five business jet airplanes were flown to determine the noise reductions that result from the use of modified approach procedures. The airplanes tested were a Gulfstream 2, JetStar, Hawker Siddeley 125-400, Sabreliner-60 and LearJet-24. Noise measurements were made 3, 5, and 7 nautical miles from the touchdown point. In addition to a standard 3 deg glide slope approach, a 4 deg glide slope approach, a 3 deg glide slope approach in a low-drag configuration, and a two-segment approach were flown. It was found that the 4 deg approach was about 4 EPNdB quieter than the standard 3 deg approach. Noise reductions for the low-drag 3 deg approach varied widely among the airplanes tested, with an average of 8.5 EPNdB on a fleet-weighted basis. The two-segment approach resulted in noise reductions of 7 to 8 EPNdB at 3 and 5 nautical miles from touchdown, but only 3 EPNdB at 7 nautical miles from touchdown when the airplanes were still in level flight prior to glide slope intercept. Pilot ratings showed progressively increasing workload for the 4 deg, low-drag 3 deg, and two-segment approaches

Summary of results of NASA F-15 flight research program

NASA conducted a multidisciplinary flight research program on the F-15 airplane. The program began in 1976 when two preproduction airplanes were obtained from the U.S. Air Force. Major projects involved stability and control, handling qualities, propulsion, aerodynamics, propulsion controls, and integrated propulsion-flight controls. Several government agencies and aerospace contractors were involved. In excess of 330 flights were flown, and over 85 papers and reports were published. This document describes the overall program, the projects, and the key results. The F-15 was demonstrated to be an excellent flight research vehicle, producing high-quality results

Exhaust-Gas Pressure and Temperature Survey of F404-GE-400 Turbofan Engine

An exhaust-gas pressure and temperature survey of the General Electric F404-GE-400 turbofan engine was conducted in the altitude test facility of the NASA Lewis Propulsion System Laboratory. Traversals by a survey rake were made across the exhaust-nozzle exit to measure the pitot pressure and total temperature. Tests were performed at Mach 0.87 and a 24,000-ft altitude and at Mach 0.30 and a 30,000-ft altitude with various power settings from intermediate to maximum afterburning. Data yielded smooth pressure and temperature profiles with maximum jet temperatures approximately 1.4 in. inside the nozzle edge and maximum jet temperatures from 1 to 3 in. inside the edge. A low-pressure region located exactly at engine center was noted. The maximum temperature encountered was 3800 R

A Hybrid Sensor Based Backstepping Control Approach with its application to Fault-Tolerant Flight Control

Recently, an incremental type sensor based backstepping (SBB) control approach, based on singular perturbation theory and Tikhonov’s theorem, has been proposed. This Lyapunov function based method uses measurements of control variables and less model knowledge, and it is not susceptible to the model uncertainty caused by fault scenarios. In this paper, the SBB method has been implemented on a fixed wing aircraft with its focus on handling structural changes caused by damages. A new hybrid autopilot flight controller has been developed for a Boeing 747-200 aircraft after combining nonlinear dynamic inversion (NDI) with SBB control approach. Two benchmarks for fault tolerant flight control (FTFC), named rudder runaway and engine separation, are employed to evaluate the proposed method. The simulation results show that the proposed control approach leads to a zero tracking-error performance in nominal condition and guarantees the stability of the closed-loop system under failures as long as the reference commands are located in the safe flight envelope

Contingency management to reduce methamphetamine use and sexual risk among men who have sex with men: a randomized controlled trial

<p>Abstract</p> <p>Background</p> <p>Methamphetamine use is associated with HIV acquisition and transmission among men who have sex with men (MSM). Contingency management (CM), providing positive reinforcement for drug abstinence and withholding reinforcement when abstinence is not demonstrated, may facilitate reduced methamphetamine use and sexual risk. We compared CM as a stand-alone intervention to a minimal intervention control to assess the feasibility of conducting a larger, more definitive trial of CM; to define the frequency of behavioral outcomes to power such a trial; and, to compute preliminary estimates of CM's effectiveness.</p> <p>Methods</p> <p>We randomly assigned 127 MSM from Seattle, WA who use methamphetamine to receive a 12-week CM intervention (n = 70) or referral to community resources (n = 57).</p> <p>Results</p> <p>Retention at 24 weeks was 84%. Comparing consecutive study visits, non-concordant UAI declined significantly in both study arms. During the intervention, CM and control participants were comparably likely to provide urine samples containing methamphetamine (adjusted relative risk [aRR] = 1.09; 95%CI: 0.71, 1.56) and to report non-concordant UAI (aRR = 0.80; 95%CI: 0.47, 1.35). However, during post-intervention follow-up, CM participants were somewhat more likely to provide urine samples containing methamphetamine than control participants (aRR = 1.21; 95%CI: 0.95, 1.54, <it>P </it>= 0.11). Compared to control participants, CM participants were significantly more likely to report weekly or more frequent methamphetamine use and use of more than eight quarters of methamphetamine during the intervention and post-intervention periods.</p> <p>Conclusions</p> <p>While it is possible to enroll and retain MSM who use methamphetamine in a trial of CM conducted outside drug treatment, our data suggest that CM is not likely to have a large, sustained effect on methamphetamine use.</p> <p>Trial Registration</p> <p>ClinicalTrials.gov Identifier <b>NCT01174654</b></p