Beamlet scraping and its influence on the beam divergence at the BATMAN Upgrade test facility

For the ITER fusion experiment, two neutral beam injectors are required for plasma heating and current drive. Each injector supplies a power of about 17 MW, obtained from neutralization of 40 A (46 A), 1 MeV (0.87 MeV) negative deuterium (hydrogen) ions. The full beam is composed of 1280 beamlets, formed in 16 beamlet groups, and strict requirements apply to the beamlet core divergence (<7 mrad). The test facility BATMAN Upgrade uses an ITER-like grid with one beamlet group, which consists of 70 apertures. In a joint campaign performed by IPP and Consorzio RFX to better assess the beam optics, the divergence of a single beamlet was compared to a group of beamlets at BATMAN Upgrade. The single beamlet is measured with a carbon fiber composite tile calorimeter and by beam emission spectroscopy, whereas the divergence of the group of beamlets is measured by beam emission spectroscopy only. When increasing the RF power at low extraction voltages, the divergence of the beamlet and of the group of beamlets is continuously decreasing and no inflection point toward an overperveant beam is found. At the same time, scraping of the extracted ion beam at the second grid (extraction grid) takes place at higher RF power, supported by the absence of the normally seen linear behavior between the measured negative ion density in the plasma close to the extraction system and the measured extracted ion current. Beside its influence on the divergence, beamlet scraping needs to be considered for the determination of the correct perveance and contributes to the measured coextracted electron current

Negative ion density in the ion source SPIDER in Cs free conditions

The SPIDER experiment, operated at the Neutral Beam Test Facility of Consorzio RFX, Padua, hosts the prototype of the H-/D- ion source for the ITER neutral beam injectors. The maximization of the ion current extracted from the source and the minimization of the amount of co-extracted electrons are among the most relevant targets to accomplish. The Cavity Ring-Down Spectroscopy diagnostic measures the negative ion density in the source close to the acceleration system, so as to have feedback information to optimize the source parameters and to maximize the amount of negative ions that can be extracted at optimal beam divergence. This work shows how the magnetic filter field and the bias currents, present in SPIDER to limit the amount of co-extracted electrons and the electron-ion stripping reactions, affect the density of negative ions available for extraction. Moreover, the influence of the extraction process on the density of negative ions available for extraction is also presented. In this study SPIDER was operated in hydrogen and deuterium in Cs-free conditions, therefore negative ions were mostly produced by reactions in the plasma volume.Comment: 13 pages, 8 figures. Preprint of a published pape

Development and first operation of a Cavity Ring Down Spectroscopy diagnostic in the negative ion source SPIDER

The Neutral Beam Injectors of the ITER experiment will rely on negative ion sources to produce 16.7 MW beams of H/D particles accelerated at 1 MeV. The prototype of these sources was built and is currently operated in the SPIDER experiment (Source for the Production of Ions o Deuterium Extracted from an RF plasma), part of the Neutral Beam Test Facility of Consorzio RFX, Padua. In SPIDER, the H-/D- ion source is coupled to a three grids 100 kV acceleration system. One of the main targets of the experimentation in SPIDER is to uniformly maximize the extracted current density; to achieve this it is important to study the density of negative ions available in proximity of the ion acceleration system. In SPIDER, line-integrated measurements of negative ion density are performed by a Cavity Ring Down Spectroscopy (CRDS) diagnostic. Its principle of operation is based on the absorption of the photons of a laser beam pulse by H-/D- photo-detachment; the absorption detection is enhanced by trapping the laser pulse in an optical cavity, containing the absorbing medium (i.e. negative ions). The paper presents and discusses the CRDS diagnostic setup in SPIDER, including the first measurements of negative ion density, correlated to the main source parameters.Comment: 5 pages, 7 figures. Contributer paper for the HTPD 2020 conference. Accepted manuscrip

First hydrogen operation of NIO1: characterization of the source plasma by means of an optical emission spectroscopy diagnostic

NIO1 is a compact and flexible radiofrequency H- ion source, developed by Consorzio RFX and INFN-LNL. Aim of the experimentation on NIO1 is the optimization of both the production of negative ions and their extraction and beam optics. In the initial phase of its commissioning, NIO1 was operated with nitrogen, but now the source is regularly operated also with hydrogen. To evaluate the source performances an optical emission spectroscopy diagnostic was installed. The system includes a low resolution spectrometer in the spectral range of 300-850 nm and a high resolution (50 pm) one, to study respectively the atomic and the molecular emissions in the visible range. The spectroscopic data have been interpreted also by means of a collisional-radiative model developed at IPP Garching. Besides the diagnostic hardware and the data analysis methods, the paper presents the first plasma measurements across a transition to the full H mode, in a hydrogen discharge. The characteristic signatures of this transition in the plasma parameters are described, in particular the sudden increase of the light emitted from the plasma above a certain power threshold.Comment: 3 pages, 2 figures. Contributed paper for the ICIS 2015 conference. Accepted manuscrip

The effects of anthocyanin-rich Myrtaceae fruits peel powder on fibrosis-associated hepatocarcinogenesisin mice.

Fruits from Myrtaceae family, as jabuticaba (Myrciaria jaboticaba (Vell) O. Berg), jamelão (Syzygium cumini (L.) Skeels) and jambo (Syzygium malaccense), raise interest due to their high levels of anthocyanins, antioxidant compounds, and, thus, potential for chronic disease risk reduction¹. Therefore, the study evaluated whether the ingestion of jabuticaba, jamelão or jambo peel powder attenuates fibrosis-associated hepatocarcinogenesis. Neonatal female C3H/Hej mice were submitted to a diethylnitrosamine (DEN)/carbon tetrachloride (CCl4)-induced fibrosis-associated hepatocarcinogenesis model. Mice also received basal diet or basal diet containing 2% of jabuticaba, jamelão or jambo dehydrated peels for 10 weeks. HPLC analysis of dehydrated fruit peels revealed high levels of anthocyanins in jabuticaba (802.89±22.88 mg/100g), jamelão (575.95±9.42 mg/100g) and jambo (156.05±10.39 mg/100g). These fruits displayed different types of anthocyanins (Figures 1-3). Interestingly, only the ingestion of basal diet containing jamelão peel powder attenuated liver fibrosis compared to DEN/CCl4 (Figure 4). Mechanisms will be evaluated, as well as the effects of these fruits on the development of preneoplasic/neoplastic liver lesions.WTPC. 21 a 26 de abril

Deformidade apresentada pela escova dental Alcance após vinte e um dias de uso, em função da freqüência diária de escovação

61

Start of SPIDER operation towards ITER neutral beams

Heating Neutral Beam (HNB) Injectors will constitute the main plasma heating and current drive tool both in ITER and JT60-SA, which are the next major experimental steps for demonstrating nuclear fusion as viable energy source. In ITER, in order to achieve the required thermonuclear fusion power gain Q=10 for short pulse operation and Q=5 for long pulse operation (up to 3600s), two HNB injectors will be needed [1], each delivering a total power of about 16.5 MW into the magnetically-confined plasma, by means of neutral hydrogen or deuterium particles having a specific energy of about 1 MeV. Since only negatively charged particles can be efficiently neutralized at such energy, the ITER HNB injectors [2] will be based on negative ions, generated by caesium-catalysed surface conversion of atoms in a radio-frequency driven plasma source. A negative deuterium ion current of more than 40 A will be extracted, accelerated and focused in a multi-aperture, multi-stage electrostatic accelerator, having 1280 apertures (~ 14 mm diam.) and 5 acceleration stages (~200 kV each) [3]. After passing through a narrow gas-cell neutralizer, the residual ions will be deflected and discarded, whereas the neutralized particles will continue their trajectory through a duct into the tokamak vessels to deliver the required heating power to the ITER plasma for a pulse duration of about 3600 s. Although the operating principles and the implementation of the most critical parts of the injector have been tested in different experiments, the ITER NBI requirements have never been simultaneously attained. In order to reduce the risks and to optimize the design and operating procedures of the HNB for ITER, a dedicated Neutral Beam Test Facility (NBTF) [4] has been promoted by the ITER Organization with the contribution of the European Union\u2019s Joint Undertaking for ITER and of the Italian Government, with the participation of the Japanese and Indian Domestic Agencies (JADA and INDA) and of several European laboratories, such as IPP-Garching, KIT-Karlsruhe, CCFE-Culham, CEA-Cadarache. The NBTF, nicknamed PRIMA, has been set up at Consorzio RFX in Padova, Italy [5]. The planned experiments will verify continuous HNB operation for one hour, under stringent requirements for beam divergence (< 7 mrad) and aiming (within 2 mrad). To study and optimise HNB performances, the NBTF includes two experiments: MITICA, full-scale NBI prototype with 1 MeV particle energy and SPIDER, with 100 keV particle energy and 40 A current, aiming at testing and optimizing the full-scale ion source. SPIDER will focus on source uniformity, negative ion current density and beam optics. In June 2018 the experimental operation of SPIDER has started

Evoluçao Tardia da Estimulaçao VDD com Cabo-Eletrodo Atrioventricular Unico com Eletrodos Atriais em Passagem

Introduçao: A estimulaçao bicameral com cabo-eletrodo único e eletrodos atriais em passagem (modo VDD) está indicada, pela simplicidade, em pacientes com bloqueio atrioventricular (BAV) total e funçao sinusal normal. Entretanto, sua efetividade para sentir a atividade elétrica atrial em longo prazo é questionável. Objetivo: Verificar evoluçao de 92 pacientes com implante de marcapasso VDD em período superior a 5 anos. Métodos: Os sistemas implantados constavam de cabo-eletrodo único com eletrodos atriais em passagem, revestimento fractal SL60 Biotronik e gerador VDD, mantido inicialmente em programaçao padrao. A onda P foi registrada no momento do implante (média de 2,38±1,23 mV) e na última avaliaçao, além de eventos durante a evoluçao (tempo médio de 52,05 meses). Resultado: Observou-se perda do sincronismo atrial em dez (10,87%) pacientes: dois (2,17%) apresentaram fibrilaçao atrial, cinco (5,43%), perda do potencial elétrico atrial e três (3,26%), deslocamento do eletrodo, requerendo reposicionamento. Em dez casos (10,87%), houve necessidade de reprogramaçao para o modo VVI e, em um paciente (1,09%), aperfeiçoamento para o modo DDD. Na última avaliaçao ou na avaliaçao final, 74 (80,43%) pacientes mantinham estimulaçao VDD, sete (7,61%) estavam em outro modo de estimulaçao e 11 (11,96%) haviam falecido. A onda P era de 1,22±0,83 mV, enquanto que, no implante, era de 2,12±0,87 mV; n.s). Conclusao: A estimulaçao VDD com cabo-eletrodo único e eletrodos fractais atriais em passagem permite manter o sincronismo atrioventricular em um percentual elevado de pacientes com atividade elétrica atrial normal. A necessidade de drogas antiarrítmicas ou cronotrópico-negativas deve ser avaliada caso a caso