Simplified conservative testing method of touch and step voltages by multiple auxiliary electrodes at reduced distance

Grounding systems (GSs) must be tested periodically in order to maintain the touch voltage (TV) and step voltage (SV) below a safe value in all of the zones of the installation. Measurements of the ground resistance and of the TV and SV are typically done by the fall-of-potential (FoP) method, locating the auxiliary current electrode at remote distance to test the effective behavior of the GS. In urban areas, it could be very complicated or impossible to install the auxiliary current electrode as required, not having area around with sufficient accessibility. At this aim, this paper describes a methodology of using multiple current electrodes at short distances, modifying the classic FoP practice, so that the measurements of TV and SV are always conservative. The adequacy of a GS is verified if the values of the TV and SV, tested inside and in the vicinity of the GS, are below the permissible limits, regardless if they are true or conservatively increased. Thus, the measured TV and SV by the suggested method, always conservative, allow verifying the adequacy of GSs, in the cases where it is impossible to locate the remote auxiliary electrode

Grounding System Adequacy of HV/MV Substations in Areas With Reduced Accessibility

The adequacy of grounding systems has to be verified periodically in the operational time. With urban development and buildings growth adjacent to power systems as HV/MV substations, it is very rare to have area around with sufficient accessibility for installing the potential and current electrodes. This paper discusses a safety criterion to verify the effectiveness of a grounding system. This criterion suggests conservative tests for both ground potential rise and touch voltages and step voltages that allow to verify the grounding systems effectiveness in areas with reduced accessibility and to monitor its evolution in the time

Characterizing the chemical pathways for water formation -- A deep search for hydrogen peroxide

In 2011, hydrogen peroxide (HOOH) was observed for the first time outside the solar system (Bergman et al., A&A, 2011, 531, L8). This detection appeared a posteriori quite natural, as HOOH is an intermediate product in the formation of water on the surface of dust grains. Following up on this detection, we present a search for HOOH in a diverse sample of sources in different environments, including low-mass protostars and regions with very high column densities, such as Infrared Dark Clouds (IRDCs). We do not detect the molecule in any other source than Oph A, and derive 3$\sigma$ upper limits for the abundance of HOOH relative to H$_2$ lower than in Oph A for most sources. This result sheds a different light on our understanding of the detection of HOOH in Oph A, and shifts the puzzle to why this source seems to be special. Therefore we rediscuss the detection of HOOH in Oph A, as well as the implications of the low abundance of HOOH, and its similarity with the case of O$_2$. Our chemical models show that the production of HOOH is extremely sensitive to the temperature, and favored only in the range 20$-$30 K. The relatively high abundance of HOOH observed in Oph A suggests that the bulk of the material lies at a temperature in the range 20$-$30 K.Comment: 18 pages, 3 figures, invited refereed paper at the Faraday Discussion 16

Ultracapacitors for port crane applications: Sizing and techno-economic analysis

The use of energy storage with high power density and fast response time at container terminals (CTs) with a power demand of tens of megawatts is one of the most critical factors for peak reduction and economic benefits. Peak shaving can balance the load demand and facilitate the participation of small power units in generation based on renewable energies. Therefore, in this paper, the economic efficiency of peak demand reduction in ship to shore (STS) cranes based on the ultracapacitor (UC) energy storage sizing has been investigated. The results show the UC energy storage significantly reduce the peak demand, increasing the load factor, load leveling, and most importantly, an outstanding reduction in power and energy cost. In fact, the suggested approach is the start point to improve reliability and reduce peak demand energy consumption

Recent advances in karst research: from theory to fieldwork and applications

Karst landscapes and karst aquifers, which are composed of a variety of soluble rocks such as salt, gypsum, anhydrite, limestone, dolomite and quartzite, are fascinating areas of study. As karst rocks are abundant on the Earth's surface, the fast evolution of karst landscapes and the rapid flow of water through karst aquifers present challenges from a number of different perspectives. This collection of 25 papers deals with different aspects of these challenges, including karst geology, geomorphology and speleogenesis, karst hydrogeology, karst modelling, and karst hazards and management. Together these papers provide a state-of-the-art review of the current challenges and solutions in describing karst from a scientific perspective