Practical, reliable and inexpensive assay of lycopene in tomato products based on the combined use of light emitting diode (LED) and the optothermal window

Light emitting diode (LED) combined with the concept of optothermal window (OW) is proposed as a new approach (LED-OW) to detect lycopene in a wide range of tomato-based products (tomato juice, tomato ketchup, tomato passata and tomato puree). Phytonutrient lycopene is a dominant antioxidant in these products while beta-carotene is present in significantly lower quantities. Therefore for all practical reasons the interfering effect of beta-carotene at 502 nm analytical wavelength can be neglected. The LED-OW method is low-cost and simple, yet accurate and precise. The major attributes of the new method are its rapid speed of response and the fact that no preparation whatsoever of the sample is needed before the analysis. The lycopene found in tomato products studied here varies from 8 mg/100 g to 60 mg/100 g fresh product. Results obtained by LED-OW method were compared to the outcome of conventional, time consuming spectrophotometric methods and the correlation was very good (R = 0.98). Precision of the LED-OW instrumental setup ranged from 0.5 to 7.4%; the RSD achieved for lycopene-richest samples (= 40 mg/100 g) did not exceed 1.7%. Repeatability of analysis by LED-OW was found to vary between 0.7 and 7.1%

Position and Stiffness Control of One DoF Revolute Joint Using a Biphasic Media Variable Stiffness Actuator

At this time, several industrial processes and service tasks need safe interactions between humans and robots. This safety can be achieved using compliance design and control of mechanisms. This paper presents a compliant revolute joint mechanism using a variable stiffness actuator. The method for adapting the stiffness in the actuator includes a member onfigured to transmit motion that is connected to a fluidic circuit, into which a biphasic control fluid circulates. Actuator's stiffness is controlled by changing pressure of control fluid into distribution lines. The used control fluid is biphasic, composed of separated gas and liquid fractions with predefined ratio. A mathematical model of the actuator is presented, a modelbased control method is implemented to track the desired position and stiffness, and equations relating to the dynamics of the mechanism are provided. Results from force loaded and unloaded simulations and experiments with a physical prototype are discussed

Aqueous phase reforming of pilot-scale Fischer-Tropsch water effluent for sustainable hydrogen production

Fischer-Tropsch (FT) synthesis produces an aqueous stream containing light oxygenates as major by-product. The low carbon concentration of the organics makes its thermal recovery unprofitable. Thus, novel processes are needed to utilize this waste carbon content. In this work, the aqueous phase reforming of the wastewater obtained from a 15 kWth Fischer-Tropsch plant was explored as a promising process to produce hydrogen at mild temperatures. The FT product water was firstly characterized and afterward subjected to the reforming at different reaction temperatures and time, using a platinum catalyst supported on activated carbon. It was observed that, besides activity, the selectivity towards hydrogen was favored at higher temperatures; equally, increasing the reaction time allowed to obtain the total conversion of most molecules found in the solution, without decreasing the selectivity and reaching a plateau at 4 hours in the hydrogen productivity. In order to get more insights into the reaction mechanism and product distribution derived from the APR of FT product water, several tests were performed with single compounds, finding characteristic features. The importance of the position of the hydroxyl group in the molecule structure was highlighted, with secondary alcohols more prone to dehydrogenation pathways compared to primary alcohols. Moreover, no interference among the substrates was reported despite the mixture is constituted by several molecules: in fact, the results obtained with the real FT product water were analogous to the linear combination of the single compound tests. Finally, the reuse of the catalyst showed no appreciable deactivation phenomena

Optical properties of high quality Cu2ZnSnSe4 thin films

Cu2ZnSnSe4 thin films, fabricated on bare or molybdenum coated glass substrates by magnetron sputtering and selenisation, were studied by a range of techniques. Photoluminescence spectra reveal an excitonic peak and two phonon replicas of a donor-acceptor pair (DAP) recombination. Its acceptor and donor ionisation energies are 27 and 7 meV, respectively. This demonstrates that high-quality Cu2ZnSnSe4 thin films can be fabricated. An experimental value for the longitudinal optical phonon energy of 28 meV was estimated. The band gap energy of 1.01 eV at room temperature was determined using optical absorption spectr

Aqueous phase reforming of the residual waters derived from lignin-rich hydrothermal liquefaction: investigation of representative organic compounds and actual biorefinery streams

Secondary streams in biorefineries need to be valorized to improve the economic and environmental sustainability of the plants. Representative model compounds of the water fraction from the hydrothermal liquefaction (HTL) of biomass were subjected to aqueous phase reforming (APR) to produce hydrogen. Carboxylic and bicarboxylic acids, hydroxyacids, alcohols, cycloketones and aromatics were identified as model compounds and tested for APR. The tests were performed with a Pt/C catalyst and the influence of the carbon concentration (0.3–1.8 wt. C%) was investigated. Typically, the increase of the concentration negatively affected the conversion of the feed toward gaseous products, without influencing the selectivity toward hydrogen production. A synthetic ternary mixture (glycolic acid, acetic acid, lactic acid) was subjected to APR to evaluate any differences in performance compared to the tests with single compounds. Indeed, glycolic acid reacted faster in the mixture than in the corresponding single compound test, while acetic acid remained almost unconverted. The influence of the reaction time, temperature and carbon concentration was also evaluated. Finally, residual water resulting from the HTL of a lignin-rich stream originating from an industrial-scale lignocellulosic ethanol process was tested for the first time, after a thorough characterization. In this framework, the stability of the catalyst was studied and found to be correlated to the presence of aromatics in the aqueous feedstock. For this reason, the influence of an extraction procedure for the selective removal of these compounds was explored, leading to an improvement in the APR performance

Tuberculosis in roe deer from Spain and Italy

TUBERCULOSIS (TB) is a chronic infectious disease caused by bacteria of the genus Mycobacterium (Grange and others 1990). The detection of wildlife reservoirs of disease is important, particularly in areas where there is a relatively low incidence of the disease in domestic animals. Tuberculosis cases in roe deer (Capreolus capreolus) are reported only sporadically, despite the wide distribution and the abundance of this cervid. Roe deer with TB have been reported in Germany (Schmidt 1938), Switzerland (Bouvier 1963), France (Zanella and others 2008) and the UK (Gunning 1985, Delahay and others 2007). This short communication is the first report of TB in roe deer in Spain and Italy, and discusses the implications of these findings for wildlife and livestock disease control. The prevalence of mycobacterial infections, such as TB and paratuberculosis, seems to be increasing in Spain. Wildlife species may act as disease reservoirs, so this short communication also elucidates the epidemiology of mycobacterial infections in species such as roe deer

Relationship between the prevalence of Dibothriocephalus latus(Cestoda: Diphyllobothriidea) and the load of Escherichia coli: New findings in a neglected fish-borne parasitic zoonosis

The sub-Alpine lakes of Switzerland, Italy and France have long been reported as an endemic area of diphyllobothriosis, a parasitic zoonosis aused by Dibothriocephalus latus. With this study, we explored the hypothesis for a relationship between the prevalence of D. latus in Perca fluviatilis and the Escherichia coli load in lake water. To do this, we identified eleven sampling sites in three areas (north, centre and south) of Lake Iseo (north Italy) to determine E. coli load and the prevalence of D. latus in P. fluviatilis. Prevalence and 95% confidence interval (CI) of D. latus infestation ranged from 0% (95% CI: 0.71–0.0) in Sarnico (southern area) to 20% (95% CI: 33.0–11.2) in Pisogne (northern area). There were significant differences in prevalence be-tween the sites (χ2= 31.12; p- value= .0006) and in E. coli load (Kruskal–Wallis test; p- value= .0005). There was decreasing gradient of E. coli load and prevalence of D. latus infestation from north to south. A significant positive correlation (r= .881; p- value= .003) was found between E. coli load and prevalence of D. latus. Also, linear regression showed a significant relationship between E. coli load and prevalence of infestation (R2= .775). Our findings offer an explanation for the link between E. coliload in water and D. latus prevalence. The potential factors in this link are the ef-ficiency of the local wastewater treatment plant, the bathymetric profile of the lake and the life cycle of D. latus, which is mainly affected by light and water temperature.KEYWORDSItaly, Lake Iseo, Perca fluviatilis, prevalence of infestation, wastewater treatment plant, the bathymetric profile of the lake and the life cycle of D. latus, which is mainly affected by light and water temperature

Dual inhibition of CDK4/6 and PI3K/AKT/mTOR signaling impairs energy metabolism in MPM cancer cells

Background: Malignant pleural mesothelioma (MPM) is an aggressive malignancy associated to asbestos exposure. One of the most frequent genetic alteration in MPM patients is CDKN2A/ARF loss, leading to aberrant activation of the Rb pathway. In MPM cells, we previously demonstrated the therapeutic efficacy of targeting this signaling with the CDK4/6 inhibitor palbociclib in combination with PI3K/mTOR inhibitors. Here, we investigated whether such combination may have an impact on cell energy metabolism. Methods: The study was performed in MPM cells of different histotypes; metabolic analyses were conducted by measuring GLUT-1 expression and glucose uptake/consumption, and by SeaHorse technologies. Results: MPM cell models differed for their ability to adapt to metabolic stress conditions, such as glucose starvation and hypoxia. Independently of these differences, combined treatments with palbociclib and PI3K/mTOR inhibitors inhibited cell proliferation more efficaciously than single agents. The drugs alone reduced glucose uptake/consumption as well as glycolysis, and their combination further enhanced these effects under both normoxic and hypoxic conditions. Moreover, the drug combinations significantly impaired mitochondrial respiration as compared with individual treatments. These metabolic effects were mediated by the concomitant inhibition of Rb/E2F/c-myc and PI3K/AKT/mTOR signaling. Conclusions: Dual blockade of glycolysis and respiration contributes to the anti-tumor efficacy of palbociclib-PI3K/mTOR inhibitors combination