Detectability of Gravitational Waves from SN 1987A

We discuss the potential for detection of gravitational waves from a rapidly spinning neutron star produced by supernova 1987A taking the parameters claimed by Middleditch et al. (2000) at face value. Asssuming that the dominant mechanism for spin down is gravitational waves emitted by a freely precessing neutron star, it is possible to constrain the wobble angle, the effective moment of inertai of the precessing crust and the crust cracking stress limit. Our analysis, suggests that, if the interpretation of the Middleditch data is correct, the compact remnant of SN 1987A may well provide a reliable and predictable source of gravitational waves well within the capability of LIGO II

Better VPS Fabrication of Crucibles and Furnace Cartridges

An experimental investigation has shown that by (1) vacuum plasma spraying (VPS) of suitable refractory metal alloys on graphite mandrels, and then (2) heat-treating the VPS alloy deposits under suitable conditions, it is possible to fabricate improved crucibles and furnace cartridges that could be used at maximum temperatures between 1,400 and 1,600 C and that could withstand chemical attack by the materials to be heated in the crucibles and cartridges. Taken by itself, the basic concept of fabricating furnace cartridges by VPS of refractory materials onto graphite mandrels is not new; taken by itself, the basic concept of heat treatment of VPS deposits for use as other than furnace cartridges is also not new; however, prior to this investigation, experimental crucibles and furnace cartridges fabricated by VPS had not been heat treated and had been found to be relatively weak and brittle. Accordingly, the investigation was directed toward determining whether certain combinations of (1) refractory alloy compositions, (2) VPS parameters, and (3) heat-treatment parameters could result in VPS-fabricated components with increased ductility

Pitting and Repair of the Space Shuttle's Inconel(Registered TradeMark) Honeycomb Conical Seal Panel

During return to flight servicing of the rudder speed brake (RSB) for each Space Shuttle Orbiter, inspectors discovered numerous small pits on the surface of the #4 right hand side honeycomb panel that covers the rudder speed brake actuators. Shortly after detection of the problem, concurrent investigations were initiated to determine the extent of damage, the root cause, and to develop a repair plan, since fabrication of a replacement panel is impractical for cost, schedule, and sourcing considerations. This paper describes the approach, findings, conclusions and recommendations associated with the investigation of the conical seal pitting. It documents the cause and contributing factors of the pitting, the means used to isolate each contributor, and the supporting evidence for the primary cause of the pitting. Finally, the selection, development and verification of the repair procedure used to restore the conical seal panel is described with supporting process and metallurgical rationale for selection

Ethics of sham surgery: Perspective of patients

Sham surgery is used as a control condition in neurosurgical clinical trials in Parkinson's disease (PD) but remains controversial. This study aimed to assess the perspective of patients with PD and the general public on the use of sham surgery controls. We surveyed consecutive patients from a university-based neurology outpatient clinic and a community-based general internal medicine practice. Background information was provided regarding PD and two possible methods of testing the efficacy of a novel gene transfer procedure, followed by questions that addressed participants' opinions related to the willingness to participate and permissibility of blinded and unblinded trial designs. Two hundred eighty-eight (57.6%) patients returned surveys. Patients with PD expressed less willingness to participate in the proposed gene transfer surgery trials. Unblinded studies received greater support, but a majority would still allow the use of sham surgery. Those in favor of sham surgery were more educated and more likely to use societal perspective rationales. Patients with PD are more cautious about surgical research participation than patients with non-PD. Their policy views were similar to others', with a majority supporting the use of sham controls. Future research needs to determine whether eliciting more considered judgments of laypersons would reveal different levels of support for sham surgery. © 2007 Movement Disorder SocietyPeer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/57916/1/21775_ftp.pd

Measurement of the branching ratio of pi^0 -> e^+e^- using K_L -> 3 pi^0 decays in flight

The branching ratio of the rare decay pi^0 -> e^+e^- has been measured in E799-II, a rare kaon decay experiment using the KTeV detector at Fermilab. The pi^0's were produced in fully-reconstructed K_L -> 3 pi^0 decays in flight. We observed 275 candidate pi^0 -> e^+e^- events, with an expected background of 21.4 +- 6.2 events which includes the contribution from Dalitz decays. We measured BR(pi^0 -> e^+e^-, x>0.95) = (6.09 +- 0.40 +- 0.24) times 10^{-8}, where the first error is statistical and the second systematic. This result is the first significant observation of the excess rate for this decay above the unitarity lower bound.Comment: New version shortened to PRL length limit. 5 pages, 4 figures. Published in Phys. Rev. Let

CEBAF Injector Model for K\u3csub\u3eL\u3c/sub\u3e Beam Conditions

The Jefferson Lab KL experiment will run at the Continuous Electron Beam Accelerator Facility with a much lower bunch repetition rate (7.80 or 15.59 MHz) than nominally used (249.5 or 499 MHz). While the proposed average current of 2.5 - 5.0 µA is relatively low compared to the maximum CEBAF current of approximately 180 µA, the corresponding bunch charge is atypically high for CEBAF injector operation. In this work, we investigated the evolution and transmission of low-rep-rate, high-bunch-charge (0.32 to 0.64 pC) beams through the CEBAF injector. Using the commercial software General Particle Tracer, we have simulated and analyzed the beam characteristics for both values of bunch charge. We performed these simulations with the existing injector using a 130 kV gun voltage. We have calculated and measured the transmission as a function of the photocathode laser spot size and pulse length. We report on the findings of these simulations and optimum parameters for operating the experiment

Engaging Citizen Scientists to Keep Transit Times Fresh and Ensure the Efficient Use of Transiting Exoplanet Characterization Missions

This white paper advocates for the creation of a community-wide program to maintain precise mid-transit times of exoplanets that would likely be targeted by future platforms. Given the sheer number of targets that will require careful monitoring between now and the launch of the next generation of exoplanet characterization missions, this network will initially be devised as a citizen science project -- focused on the numerous amateur astronomers, small universities and community colleges and high schools that have access to modest sized telescopes and off-the-shelf CCDs.Comment: White Paper submitted to Astro2020 Science Call, 5 pages, 3 figures, community comments and involvement are welcome

Standardisation framework for the Maudsley staging method for treatment resistance in depression

Background: Treatment-resistant depression (TRD) is a serious and relatively common clinical condition. Lack of consensus on defining and staging TRD remains one of the main barriers to understanding TRD and approaches to intervention. The Maudsley Staging Method (MSM) is the first multidimensional model developed to define and stage treatment-resistance in “unipolar depression”. The model is being used increasingly in treatment and epidemiological studies of TRD and has the potential to support consensus. Yet, standardised methods for rating the MSM have not been described adequately. The aim of this report is to present standardised approaches for rating or completing the MSM. Method: Based on the initial development of the MSM and a narrative review of the literature, the developers of the MSM provide explicit guidance on how the three dimensions of the MSM–treatment failure, severity of depressive episode and duration of depressive episode– may be rated. Result: The core dimension of the MSM, treatment failure, may be assessed using the Maudsley Treatment Inventory (MTI), a new method developed for the purposes of completing the MSM. The MTI consists of a relatively comprehensive list of medications with options for rating doses and provisions treatment for multiple episodes. The second dimension, severity of symptoms, may be assessed using simple instruments such as the Clinical Global Impression, the Psychiatric Status Rating or checklist from a standard diagnostic checklist. The standardisation also provides a simple rating scale for scoring the third dimension, duration of depressive episode. Conclusion: The approaches provided should have clinical and research utility in staging TRD. However, in proposing this model, we are fully cognisant that until the pathophysiology of depression is better understood, staging methods can only be tentative approximations. Future developments should attempt to incorporate other biological/ pathophysiological dimensions for staging