31 research outputs found
Bromide and other ions in the snow, firn air, and atmospheric boundary layer at Summit during GSHOX
Measurements of gas phase soluble bromide in the boundary layer and in firn air, and Br− in aerosol and snow, were made at Summit, Greenland (72.5° N, 38.4° W, 3200 m a.s.l.) as part of a larger investigation into the influence of Br chemistry on HOx cycling. The soluble bromide measurements confirm that photochemical activation of Br− in the snow causes release of active Br to the overlying air despite trace concentrations of Br− in the snow (means 15 and 8 nmol Br− kg−1 of snow in 2007 and 2008, respectively). Mixing ratios of soluble bromide above the snow were also found to be very small (mean \u3c1 ppt both years, with maxima of 3 and 4 ppt in 2007 and 2008, respectively), but these levels clearly oxidize and deposit long-lived gaseous elemental mercury and may perturb HOx partitioning. Concentrations of Br− in surface snow tended to increase/decrease in parallel with the specific activities of the aerosol-associated radionuclides 7Be and 210Pb. Earlier work has shown that ventilation of the boundary layer causes simultaneous increases in 7Be and 210Pb at Summit, suggesting there is a pool of Br in the free troposphere above Summit in summer time. Speciation and the source of this free tropospheric Br− are not well constrained, but we suggest it may be linked to extensive regions of active Br chemistry in the Arctic basin which are known to cause ozone and mercury depletion events shortly after polar sunrise. If this hypothesis is correct, it implies persistence of the free troposphere Br− for several months after peak Br activation in March/April. Alternatively, there may be a ubiquitous pool of Br− in the free troposphere, sustained by currently unknown sources and processes
Aerosol major ion record at Mount Washington
This study examined the seasonal cycles and regional-scale meteorological controls on the chemical properties of bulk aerosols collected from 1999 to 2004 at Mount Washington, the highest peak in the northeastern United States. The concentrations of NH4+ and SO42− peaked during summer months. The pattern for aerosol NO3− was more complicated with relatively high median concentrations characterizing spring and summer months, but with major elevated events occurring during fall, winter, and spring. The seasonal relationship between NH4+ and SO42− indicated that during warmer months a mixture of (NH4)2SO4 and NH4HSO4 was present, while it was mainly the latter in winter. More acidity and higher concentrations of the major species were generally associated with winds from the southwest and west sectors. The highest (≥95th percentile) concentrations of SO42− and NH4+ were associated with air mass transport from major upwind source regions in the Midwest and along the eastern seaboard. The ionic composition and seasonal cycle observed at Mount Washington were similar to those measured at other northeastern sites, but the range and average concentrations were much lower. These differences were exaggerated during wintertime. Included in this paper are several Eulerian case studies of SO2 conversion to SO42− during transit from Whiteface Mountain, New York, to Mount Washington. The calculations suggest a gas-phase SO2 oxidation rate of ∼1–2% per hour and demonstrate the possibility of using these two sites to investigate the chemical evolution of air masses as they move from Midwestern source regions to northern New England
Mount Carmel Area Community Center Strategic Plan
This document outlines various strategic planning areas for the Mount Carmel Area Community Center located in Mount Carmel, Pennsylvania, to consider, including: building repairs, partners, funding, operations, and marketing. The project builds on prior Bucknell University student reports conducted in partnership with the Mount Carmel Area Community Center (MCACC).
This project was completed as a course requirement for MORS 400: Management Consulting at Bucknell University in Spring 2023, taught by Prof. Eric Martin. The project was in partnership with the Mount Carmel Area Community Center
Spectral aerosol extinction (SpEx): a new instrument for in situ ambient aerosol extinction measurements across the UV/visible wavelength range
We introduce a new instrument for the measurement of in situ ambient aerosol extinction over the 300– 700 nm wavelength range, the spectral aerosol extinction (SpEx) instrument. This measurement capability is envisioned to complement existing in situ instrumentation, allowing for simultaneous measurement of the evolution of aerosol optical, chemical, and physical characteristics in the ambient environment. In this work, a detailed description of the instrument is provided along with characterization tests performed in the laboratory. Measured spectra of NO2 and polystyrene latex spheres (PSLs) agreed well with theoretical calculations. Good agreement was also found with simultaneous aerosol extinction measurements at 450, 530, and 630 nm using CAPS PMex instruments in a series of 22 tests including nonabsorbing compounds, dusts, soot, and black and brown carbon analogs. SpEx measurements are expected to help identify the presence of ambient brown carbon due to its 300 nm lower wavelength limit compared to measurements limited to longer UV and visible wavelengths. Extinction spectra obtained with SpEx contain more information than can be conveyed by a simple power law fit (typically represented by Ångström exponents). Planned future improvements aim to lower detection limits and ruggedize the instrument for mobile operation
Evolution of brown carbon in wildfire plumes
Particulate brown carbon (BrC) in the atmosphere absorbs light at subvisible wavelengths and has poorly constrained but potentially large climate forcing impacts. BrC from biomass burning has virtually unknown lifecycle and atmospheric stability. Here, BrC emitted from intense wildfires was measured in plumes transported over 2 days from two main fires, during the 2013 NASA SEAC4RS mission. Concurrent measurements of organic aerosol (OA) and black carbon (BC) mass concentration, BC coating thickness, absorption Ångström exponent, and OA oxidation state reveal that the initial BrC emitted from the fires was largely unstable. Using back trajectories to estimate the transport time indicates that BrC aerosol light absorption decayed in the plumes with a half-life of 9 to 15 h, measured over day and night. Although most BrC was lost within a day, possibly through chemical loss and/or evaporation, the remaining persistent fraction likely determines the background BrC levels most relevant for climate forcing
Observational evidence for the convective transport of dust over the central United States
Bulk aerosol composition and aerosol size distributions measured aboard the DC-8 aircraft during the Deep Convective Clouds and Chemistry Experiment mission in May/June 2012 were used to investigate the transport of mineral dust through nine storms encountered over Colorado and Oklahoma. Measurements made at low altitudes (\u3c5 km mean sea level (MSL)) in the storm inflow region were compared to those made in cirrus anvils (altitude \u3e 9 km MSL). Storm mean outflow Ca2+ mass concentrations and total coarse (1 µm \u3c diameter \u3c 5 µm) aerosol volume (Vc) were comparable to mean inflow values as demonstrated by average outflow/inflow ratios greater than 0.5. A positive relationship between Ca2+, Vc, ice water content, and large (diameter \u3e 50 µm) ice particle number concentrations was not evident; thus, the influence of ice shatter on these measurements was assumed small. Mean inflow aerosol number concentrations calculated over a diameter range (0.5 µm \u3c diameter \u3c 5.0 µm) relevant for proxy ice nuclei (NPIN) were ~15–300 times higher than ice particle concentrations for all storms. Ratios of predicted interstitial NPIN (calculated as the difference between inflow NPIN and ice particle concentrations) and inflow NPIN were consistent with those calculated for Ca2+ and Vc and indicated that on average less than 10% of the ingested NPIN were activated as ice nuclei during anvil formation. Deep convection may therefore represent an efficient transport mechanism for dust to the upper troposphere where these particles can function as ice nuclei cirrus forming in situ
Brown carbon aerosol in the North American continental troposphere: sources, abundance, and radiative forcing
Chemical components of organic aerosol (OA) selectively absorb light at short wavelengths. In this study, the prevalence, sources, and optical importance of this so called brown carbon (BrC) aerosol component are investigated throughout the North American continental tropospheric column during a summer of extensive biomass burning. Spectrophotometric absorption measurements on extracts of bulk aerosol samples collected from an aircraft over the central USA were analyzed to directly quantify BrC abundance. BrC was found to be prevalent throughout the 1 to 12 km altitude measurement range, with dramatic enhancements in biomass-burning plumes. BrC to black carbon (BC) ratios, under background tropospheric conditions, increased with altitude, consistent with a corresponding increase in the absorption Ångström exponent (AAE) determined from a three-wavelength particle soot absorption photometer (PSAP). The sum of inferred BC absorption and measured BrC absorption at 365 nm was within 3 % of the measured PSAP absorption for background conditions and 22 % for biomass burning. A radiative transfer model showed that BrC absorption reduced top-of atmosphere (TOA) aerosol forcing by ∼ 20 % in the background troposphere. Extensive radiative model simulations applying this study background tropospheric conditions provided a look-up chart for determining radiative forcing efficiencies of BrC as a function of a surface-measured BrC : BC ratio and single scattering albedo (SSA). The chart is a first attempt to provide a tool for better assessment of brown carbon’s forcing effect when one is limited to only surface data. These results indicate that BrC is an important contributor to direct aerosol radiative forcing
A new method to quantify mineral dust and other aerosol species from aircraft platforms using single particle mass spectrometry
Single-particle mass spectrometry (SPMS) instruments characterize the composition of individual aerosol particles in real time. Their fundamental ability to differentiate the externally mixed particle types that constitute the atmospheric aerosol population enables a unique perspective into sources and transformation. However, quantitative measurements by SPMS systems are inherently problematic. We introduce a new technique that combines collocated measurements of aerosol composition by SPMS and size-resolved absolute particle concentrations on aircraft platforms. Quantitative number, surface area, volume, and mass concentrations are derived for climate-relevant particle types such as mineral dust, sea salt, and biomass burning smoke. Additionally, relative ion signals are calibrated to derive mass concentrations of internally mixed sulfate and organic material that are distributed across multiple particle types.
The NOAA Particle Analysis by Laser Mass Spectrometry (PALMS) instrument measures size-resolved aerosol chemical composition from aircraft. We describe the identification and quantification of nine major atmospheric particle classes, including sulfate–organic–nitrate mixtures, biomass burning, elemental carbon, sea salt, mineral dust, meteoric material, alkali salts, heavy fuel oil combustion, and a remainder class. Classes can be sub-divided as necessary based on chemical heterogeneity, accumulated secondary material during aging, or other atmospheric processing. Concentrations are derived for sizes that encompass the accumulation and coarse size modes. A statistical error analysis indicates that particle class concentrations can be determined within a few minutes for abundances above ∼10 ng m−3. Rare particle types require longer sampling times.
We explore the instrumentation requirements and the limitations of the method for airborne measurements. Reducing the size resolution of the particle data increases time resolution with only a modest increase in uncertainty. The principal limiting factor to fast time response concentration measurements is statistically relevant sampling across the size range of interest, in particular, sizes D \u3c 0.2 µm for accumulation-mode studies and D \u3e 2 µm for coarse-mode analysis. Performance is compared to other airborne and ground-based composition measurements, and examples of atmospheric mineral dust concentrations are given. The wealth of information afforded by composition-resolved size distributions for all major aerosol types represents a new and powerful tool to characterize atmospheric aerosol properties in a quantitative fashion
Particulate Oxalate-To-Sulfate Ratio as an Aqueous Processing Marker: Similarity Across Field Campaigns and Limitations
Leveraging aerosol data from multiple airborne and surface-based field campaigns encompassing diverse environmental conditions, we calculate statistics of the oxalate-sulfate mass ratio (median: 0.0217; 95% confidence interval: 0.0154–0.0296; R = 0.76; N = 2,948). Ground-based measurements of the oxalate-sulfate ratio fall within our 95% confidence interval, suggesting the range is robust within the mixed layer for the submicrometer particle size range. We demonstrate that dust and biomass burning emissions can separately bias this ratio toward higher values by at least one order of magnitude. In the absence of these confounding factors, the 95% confidence interval of the ratio may be used to estimate the relative extent of aqueous processing by comparing inferred oxalate concentrations between air masses, with the assumption that sulfate primarily originates from aqueous processing