Temperature dependence of a magnetically levitated electromagnetic vibration energy harvester

 This is the author accepted manuscript. The final version is available from Elsevier via the DOI in this record Data accessibility: All data supporting this study are openly available from the University of Southampton repository at http://dx.doi.org/10.5258/SOTON/381135.Electromagnetic vibration energy harvesters including magnetically levitated devices where opposing magnets are used to form the spring have been well documented. The strength of the magnets naturally has a large influence on the dynamic characteristics and output power of such harvesters. However, it can be affected by ambient temperatures which vary from applications to applications. This paper presents investigation into the performance of a magnetically levitated electromagnetic energy harvester under various ambient temperatures. Parameters investigated include magnetic flux density, resonant frequency, damping ratio, open circuit output voltage, velocity of the relative motion and the load resistance. Both simulation and experimental results show that these properties vary with ambient temperatures. The magnetic flux density reduces as the temperature increases which results in lower resonant frequency, lower relative velocity, lower open circuit output voltage and higher damping ratio. Varying resonant frequencies with temperature can lead to harvesters being de-tuned from the target vibration frequency. Decreasing magnetic field strength and increased damping ratios will also reduce output power even if the harvester's resonant frequency still matches the environmental vibration frequency. The power transferred to the electrical load will be reduced due to the variation in the optimal load resistance with temperature. This means the harvester is no longer matched to achieve the maximum harvested power. The specified maximum operating temperature of the magnets was found to lead to partial demagnetisation. When cycling from room to the maximum specified temperature, the magnetic field was initially found to fall but remained constant thereafter. Harvesters were found to operate beyond the specified maximum operating temperature of the magnet, but suffer from a reduced magnetic strength.Engineering and Physical Sciences Research Council (EPSRC

A meteorological overview of the Pacific Exploratory Mission (PEM) Tropics period

NASA's Pacific Exploratory Mission-Tropics (PEM-T) experiment investigated the atmospheric chemistry of a large portion of the tropical and subtropical Pacific Basin during August to October 1996. This paper summarizes meteorological conditions over the PEM-T domain. Mean flow patterns during PEM-T are described. Important circulation systems near the surface include subtropical anticyclones, the South Pacific Convergence Zone (SPCZ), the Intertropical Convergence Zone (ITCZ), and middle latitude transient cyclones. The SPCZ and ITCZ are areas of widespread ascent and deep convection; however, there is relatively little lightning in these oceanic regions. A large area of subsidence is associated with the subtropical anticyclone centered near Easter Island. PEM-T occurred during a period of near normal sea surface temperatures. When compared to an 11 year climatology (1986-1996), relatively minor circulation anomalies are observed during PEM-T. Some of these circulation anomalies are consistent with much stronger anomalies observed during previous La Nina events. In general, however, the 1996 PEM-T period appears to be climatologically representative. Meteorological conditions for specific flights from each major operations area are summarized. The vertical distribution of ozone along selected DC-8 flights is described using the DIAL remote sensing system. These ozone distributions are related to thermodynamic soundings obtained during aircraft maneuvers and to backward trajectories that arrived at locations along the flight tracks. Most locations in the deep tropics are found to have relatively small values of tropospheric ozone. Backward trajectories calculated from global gridded analyses show that much of this air originates from the east and has not passed over land within 10 days. The deep convection associated with the ITCZ and SPCZ also influences the atmospheric chemistry of these regions. Flights over portions of the subtropics and middle latitudes document layers of greatly enhanced tropospheric ozone, sometimes exceeding 80 ppbv. In situ carbon monoxide in these layers often exceeds 90 ppbv. These regions are located near, and especially south of Tahiti, Easter Island, and Fiji. The layers of enhanced ozone usually correspond to layers of dry air, associated with widespread subsiding air. The backward trajectories show that air parcels arriving in these regions originate from the west, passing over Australia and even extending back to southern Africa. These are regions of biomass burning. The in situ chemical measurements support the trajectory-derived origins of these ozone plumes. Thus the enhanced tropospheric ozone over the central Pacific Basin may be due to biomass burning many thousands of kilometers away. Middle-latitude portions of the PEM-T area are influenced by transient cyclones, and the DC-8 traversed tropopause folds during several flights. The flight area just west of Ecuador experiences outflow from South America. Thus the biomass burning that is prevalent over portions of Brazil influences this area. Copyright 1999 by the American Geophysical Union

Deletion within the Src homology domain 3 of Bruton's tyrosine kinase resulting in X-linked agammaglobulinemia (XLA).

The gene responsible for X-linked agammaglobulinemia (XLA) has been recently identified to code for a cytoplasmic tyrosine kinase (Bruton's agammaglobulinemia tyrosine kinase, BTK), required for normal B cell development. BTK, like many other cytoplasmic tyrosine kinases, contains Src homology domains (SH2 and SH3), and catalytic kinase domain. SH3 domains are important for the targeting of signaling molecules to specific subcellular locations. We have identified a family with XLA whose affected members have a point mutation (g-->a) at the 5' splice site of intron 8, resulting in the skipping of coding exon 8 and loss of 21 amino acids forming the COOH-terminal portion of the BTK SH3 domain. The study of three generations within this kinship, using restriction fragment length polymorphism and DNA analysis, allowed identification of the mutant X chromosome responsible for XLA and the carrier status in this family. BTK mRNA was present in normal amounts in Epstein-Barr virus-induced B lymphoblastoid cell lines established from affected family members. Although the SH3 deletion did not alter BTK protein stability and kinase activity of the truncated BTK protein was normal, the affected patients nevertheless have a severe B cell defect characteristic for XLA. The mutant protein was modeled using the normal BTK SH3 domain. The deletion results in loss of two COOH-terminal beta strands containing several residues critical for the formation of the putative SH3 ligand-binding pocket. We predict that, as a result, one or more crucial SH3 binding proteins fail to interact with BTK, interrupting the cytoplasmic signal transduction process required for B cell differentiation

Preparation of Ni–YSZ thin and thick films on metallic interconnects as cell supports. Applications as anode for SOFC

In this work, we propose the preparation of a duplex anodic layer composed of both a thin (100 nm) and a thick film (10 lm) with Ni–YSZ material. The support of this anode is a metallic substrate, which is the interconnect of the SOFC unit cell. The metallic support limits the temperature of thermal treatment at 800 C to keep a good interconnect mechanical behaviour and to reduce corrosion. We have chosen to elaborate anodic coatings by sol–gel route coupled with dip-coating process, which are low cost techniques and allow working with moderate temperatures. Thin films are obtained by dipping interconnect substrate into a sol, and thick films into an optimized slurry. After thermal treatment at only 800 C, anodic coatings are adherent and homogeneous. Thin films have compact microstructures that confer ceramic protective barrier on metal surface. Further coatings of 10 lm thick are porous and constitute the active anodic material

Optimality principles explaining divergent responses of alpine vegetation to environmental change

Recent increases in vegetation greenness over much of the world reflect increasing CO2 globally and warming in cold areas. However, the strength of the response to both CO2 and warming in those areas appears to be declining for unclear reasons, contributing to large uncertainties in predicting how vegetation will respond to future global changes. Here, we investigated the changes of satellite-observed peak season absorbed photosynthetically active radiation (Fmax) on the Tibetan Plateau between 1982 and 2016. Although climate trends are similar across the Plateau, we identified robust divergent responses (a greening of 0.31 ± 0.14% year−1 in drier regions and a browning of 0.12 ± 0.08% year−1 in wetter regions). Using an eco-evolutionary optimality (EEO) concept of plant acclimation/adaptation, we propose a parsimonious modelling framework that quantitatively explains these changes in terms of water and energy limitations. Our model captured the variations in Fmax with a correlation coefficient (r) of .76 and a root mean squared error of .12 and predicted the divergent trends of greening (0.32 ± 0.19% year−1) and browning (0.07 ± 0.06% year−1). We also predicted the observed reduced sensitivities of Fmax to precipitation and temperature. The model allows us to explain these changes: Enhanced growing season cumulative radiation has opposite effects on water use and energy uptake. Increased precipitation has an overwhelmingly positive effect in drier regions, whereas warming reduces Fmax in wetter regions by increasing the cost of building and maintaining leaf area. Rising CO2 stimulates vegetation growth by enhancing water-use efficiency, but its effect on photosynthesis saturates. The large decrease in the sensitivity of vegetation to climate reflects a shift from water to energy limitation. Our study demonstrates the potential of EEO approaches to reveal the mechanisms underlying recent trends in vegetation greenness and provides further insight into the response of alpine ecosystems to ongoing climate change

Strained graphene structures: from valleytronics to pressure sensing

Due to its strong bonds graphene can stretch up to 25% of its original size without breaking. Furthermore, mechanical deformations lead to the generation of pseudo-magnetic fields (PMF) that can exceed 300 T. The generated PMF has opposite direction for electrons originating from different valleys. We show that valley-polarized currents can be generated by local straining of multi-terminal graphene devices. The pseudo-magnetic field created by a Gaussian-like deformation allows electrons from only one valley to transmit and a current of electrons from a single valley is generated at the opposite side of the locally strained region. Furthermore, applying a pressure difference between the two sides of a graphene membrane causes it to bend/bulge resulting in a resistance change. We find that the resistance changes linearly with pressure for bubbles of small radius while the response becomes non-linear for bubbles that stretch almost to the edges of the sample. This is explained as due to the strong interference of propagating electronic modes inside the bubble. Our calculations show that high gauge factors can be obtained in this way which makes graphene a good candidate for pressure sensing.Comment: to appear in proceedings of the NATO Advanced Research Worksho

Elucidating the Limit of Li Insertion into the Spinel Li4Ti5O12

In this work, we show that the well-known lithium-ion anode material, Li4Ti5O12, exhibits exceptionally high initial capacity of 310 mAh g-1 when it is discharged to 0.01 V. It maintains a reversible capacity of 230 mAh g-1, far exceeding the "theoretical" capacity of 175 mAh g-1 when this anode is lithiated to the composition Li7Ti5O12. Neutron diffraction analyses identify that additional Li reversibly enters into the Li7Ti5O12 to form Li8Ti5O12. density functional theory (DFT) calculations reveal the average potentials of the Li4Ti5O12 to Li7Ti5O12 step and the Li7Ti5O12 to Li8Ti5O12 step are 1.57 and 0.19 V, respectively, which are in excellent agreement with experimental results. Transmission electron microscopy (TEM) studies confirm that the irreversible capacity of Li4Ti5O12 during its first cycle originates from the formation of a solid electrolyte interface (SEI) layer. This work clarifies the fundamental lithiation mechanism of the Li4Ti5O12, when lithiated to 0.01 V vs Li

CD133+ liver cancer stem cells resist interferon-gamma induced autophagy

published_or_final_versio

A Flexible 2.45-GHz Power Harvesting Wristband with Net System Output from -24.3 dBm of RF Power

This is the final version. Available from IEEE via the DOI in this recordThis paper presents a flexible 2.45-GHz wireless power harvesting wristband that generates a net dc output from a -24.3-dBm RF input. This is the lowest reported system sensitivity for systems comprising a rectenna and impedance-matching power management. A complete system has been implemented comprising: a fabric antenna, a rectifier on rigid substrate, a contactless electrical connection between rigid and flexible subsystems, and power electronics impedance matching. Various fabric and flexible materials are electrically characterized at 2.45 GHz using the two-line and the T-resonator methods. Selected materials are used to design an all-textile antenna, which demonstrates a radiation efficiency above 62% on a phantom irrespective of location, and a stable radiation pattern. The rectifier, designed on a rigid substrate, shows a best-in-class efficiency of 33.6% at -20 dBm. A reliable, efficient, and wideband contactless connection between the fabric antenna and the rectifier is created using broadside-coupled microstrip lines, with an insertion loss below 1 dB from 1.8 to over 10 GHz. A self-powered boost converter with a quiescent current of 150 nA matches the rectenna output with a matching efficiency above 95%. The maximum end-to-end efficiency is 28.7% at -7 dBm. The wristband harvester demonstrates net positive energy harvesting from -24.3 dBm, a 7.3-dB improvement on the state of the art.Engineering and Physical Sciences Research Council (EPSRC