244 research outputs found
Optimization Analysis of Initial Sheet Metal Contour Line for High-Strength Boron Steel in Hot Stamping
Based on the principle of hot stamping, a simulation model of hot stamping was established. The blank contour line of U part was optimized by using a multiple iterative algorithm. By comparison with the simulation and experimental data, the multiple iterative optimization algorithm was verified. Moreover, the blank contour lines of a bumper and the B-pillar of Numisheet 2008 were optimized. The result showed that the multiple iterative method for optimizing initial blank contour line had high calculating speed and precision. The hot stamping parts’ contour lines match the ideal part contour lines quite well
Tightly Coupled Array Antennas for Ultra-Wideband Wireless Systems
Tightly coupled array (TCA) antenna has become a hot topic of research recently, due to its
potential of enabling one single antenna array to operate over an extremely wide frequency range. Such an
array antenna is promising for applications in numerous wideband/multi-band and multi-function wireless
systems such as wideband high-resolution radars, 5G mobile communications, satellite communications,
global navigation satellite systems, sensors, wireless power transmission, internet of things and so on. Many
papers on this topic have been published by researchers internationally. This paper provides a detailed
review of the recent development on TCA that utilizes the capacitive coupling. The basic principles and the
historical evolution of the TCAs are introduced firstly. Then, recent development in the analysis and design
of TCAs, such as equivalent circuit analysis, bandwidth limitation analysis, array elements, feed structures,
substrates/superstrates loading, etc., are explained and discussed. The performances of the state-of-the-art
TCAs are presented and a comparison amongst some TCAs reported recently is summarized and discussed.
To illustrate the practical designs of TCA, one case study is provided, and the detailed design procedures of
the TCA are explained so as to demonstrate the TCA design methodology. Simulated results including the
VSWR at different angles of scanning, patterns and antenna gain are shown and discussed. A conclusion
and future work are given in the end
Revisiting the B {\to} {\pi} {\rho}, {\pi} {\omega} Decays in the Perturbative QCD Approach Beyond the Leading Order
We calculate the branching ratios and CP asymmetries of the ,
decays in the perturbative QCD factorization approach up to the
next-to-leading-order contributions. We find that the next-to-leading-order
contributions can interfere with the leading-order part constructively or
destructively for different decay modes. Our numerical results have a much
better agreement with current available data than previous leading-order
calculations, e.g., the next-to-leading-order corrections enhance the
branching ratios by a factor 2.5, which is helpful
to narrow the gaps between theoretic predictions and experimental data. We also
update the direct CP-violation parameters, the mixing-induced CP-violation
parameters of these modes, which show a better agreement with experimental data
than many of the other approaches.Comment: 23 pages, 4 figures, 4 table
Study of J/psi decays to Lambda Lambdabar and Sigma0 Sigma0bar
The branching ratios and Angular distributions for J/psi decays to Lambda
Lambdabar and Sigma0 Sigma0bar are measured using BESII 58 million J/psi.Comment: 11 pages, 5 figure
Partial Wave Analysis of
BES data on are presented. The
contribution peaks strongly near threshold. It is fitted with a
broad resonance with mass MeV, width MeV. A broad resonance peaking at 2020 MeV is also required
with width MeV. There is further evidence for a component
peaking at 2.55 GeV. The non- contribution is close to phase
space; it peaks at 2.6 GeV and is very different from .Comment: 15 pages, 6 figures, 1 table, Submitted to PL
Search for the Rare Decays J/Psi --> Ds- e+ nu_e, J/Psi --> D- e+ nu_e, and J/Psi --> D0bar e+ e-
We report on a search for the decays J/Psi --> Ds- e+ nu_e + c.c., J/Psi -->
D- e+ nu_e + c.c., and J/Psi --> D0bar e+ e- + c.c. in a sample of 5.8 * 10^7
J/Psi events collected with the BESII detector at the BEPC. No excess of signal
above background is observed, and 90% confidence level upper limits on the
branching fractions are set: B(J/Psi --> Ds- e+ nu_e + c.c.)<4.8*10^-5, B(J/Psi
--> D- e+ nu_e + c.c.) D0bar e+ e- + c.c.)<1.1*10^-5Comment: 10 pages, 4 figure
Direct Measurements of the Branching Fractions for and and Determinations of the Form Factors and
The absolute branching fractions for the decays and
are determined using singly
tagged sample from the data collected around 3.773 GeV with the
BES-II detector at the BEPC. In the system recoiling against the singly tagged
meson, events for and events for decays are observed. Those yield
the absolute branching fractions to be and . The
vector form factors are determined to be
and . The ratio of the two form
factors is measured to be .Comment: 6 pages, 5 figure
Creation and annihilation of topological meron pairs in in-plane magnetized films
Merons which are topologically equivalent to one-half of skyrmions can exist only in pairs or groups in two-dimensional (2D) ferromagnetic (FM) systems. The recent discovery of meron lattice in chiral magnet Co8Zn9Mn3 raises the immediate challenging question that whether a single meron pair, which is the most fundamental topological structure in any 2D meron systems, can be created and stabilized in a continuous FM film? Utilizing winding number conservation, we develop a new method to create and stabilize a single pair of merons in a continuous Py film by local vortex imprinting from a Co disk. By observing the created meron pair directly within a magnetic field, we determine its topological structure unambiguously and explore the topological effect in its creation and annihilation processes. Our work opens a pathway towards developing and controlling topological structures in general magnetic systems without the restriction of perpendicular anisotropy and Dzyaloshinskii–Moriya interaction. © 2019, The Author(s).1
Measurements of J/psi Decays into 2(pi+pi-)eta and 3(pi+pi-)eta
Based on a sample of 5.8X 10^7 J/psi events taken with the BESII detector,
the branching fractions of J/psi--> 2(pi+pi-)eta and J/psi-->3(pi+pi-)eta are
measured for the first time to be (2.26+-0.08+-0.27)X10^{-3} and
(7.24+-0.96+-1.11)X10^{-4}, respectively.Comment: 11 pages, 6 figure
BESII Detector Simulation
A Monte Carlo program based on Geant3 has been developed for BESII detector
simulation. The organization of the program is outlined, and the digitization
procedure for simulating the response of various sub-detectors is described.
Comparisons with data show that the performance of the program is generally
satisfactory.Comment: 17 pages, 14 figures, uses elsart.cls, to be submitted to NIM
- …