99,945 research outputs found
Recommended from our members
Shock wave boundary layer interaction studied by high-speed schlieren
Shock wave boundary layer interactions at compression ramps have been examined by high-speed schlieren. A total of six ramps with angles ranging from 20 deg to 30 deg, the ramp angle effect on the SWBLI is thus studied. The present high-speed schlieren with a frame rate of 20 kHz generates a large ensemble of 9000 images, which secures the convergence of the statistics of the schlieren intensity. The rms of the schlieren intensity is of great interest, as it enables visualisation of the flow features that are not observable in the raw schlieren images, such as the corner separation/low momentum region, the spot of strong flow unsteadiness right after the shock wave and the location of the peak fluctuation over the ramp. Through the present systematic experimental investigation of SWBLI, the highspeed schlieren is demonstrated to be of great capability for SWBLI study
Recommended from our members
Two-phase flow and oxygen transport in the perforated gas diffusion layer of proton exchange membrane fuel cell
Liquid water transport in perforated gas diffusion layers (GDLs)is numerically investigated using a three-dimensional (3D)two-phase volume of fluid (VOF)model and a stochastic reconstruction model of GDL microstructures. Different perforation depths and diameters are investigated, in comparison with the GDL without perforation. It is found that perforation can considerably reduce the liquid water level inside a GDL. The perforation diameter (D = 100 μm)and the depth (H = 100 μm)show pronounced effect. In addition, two different perforation locations, i.e. the GDL center and the liquid water break-through point, are investigated. Results show that the latter perforation location works more efficiently. Moreover, the perforation perimeter wettability is studied, and it is found that a hydrophilic region around the perforation further reduces the water saturation. Finally, the oxygen transport in the partially-saturated GDL is studied using an oxygen diffusion model. Results indicate that perforation reduces the oxygen diffusion resistance in GDLs and improves the oxygen concentration at the GDL bottom up to 101% (D = 100 μm and H = 100 μm)
Recommended from our members
MHD-RLC discharge model and the efficiency characteristics of plasma synthetic jet actuator
Major factors affecting efficiency of plasma synthetic jet actuator (PSJA) are analyzed based on a new discharge model in the present paper. The model couples the magnetohydrodynamics (MHD) equations with the resistor–inductor–capacitor (RLC) equations, and is able to resolve the time-dependent voltage fall on the sheath region and arc region, which is critical in analyzing energy loss in the heating process. This model is integrated into the commercial CFD software by a two-equation method. Results show that in a typical capacitive discharge at microsecond scale, the maximum energy loss is the sheath energy loss, which accounts for nearly half of the discharge energy, while the radiation loss is less than 5%. The discharge time is an important parameter for the PSJA efficiency. A short discharge time less than 1 μs will effectively reduce the sheath energy loss, while a longer discharge time will decrease the thermodynamic efficiency
Effect of Dzyaloshinskii Moriya interaction on magnetic vortex
The effect of the Dzyaloshinskii Moriya interaction on the vortex in magnetic
microdisk was investigated by micro magnetic simulation based on the Landau
Lifshitz Gilbert equation. Our results show that the DM interaction modifies
the size of the vortex core, and also induces an out of plane magnetization
component at the edge and inside the disk. The DM interaction can destabilizes
one vortex handedness, generate a bias field to the vortex core and couple the
vortex polarity and chirality. This DM-interaction-induced coupling can
therefore provide a new way to control vortex polarity and chirality
On practical design for joint distributed source and network coding
This paper considers the problem of communicating correlated information from multiple source nodes over a network of noiseless channels to multiple destination nodes, where each destination node wants to recover all sources. The problem involves a joint consideration of distributed compression and network information relaying. Although the optimal rate region has been theoretically characterized, it was not clear how to design practical communication schemes with low complexity. This work provides a partial solution to this problem by proposing a low-complexity scheme for the special case with two sources whose correlation is characterized by a binary symmetric channel. Our scheme is based on a careful combination of linear syndrome-based Slepian-Wolf coding and random linear mixing (network coding). It is in general suboptimal; however, its low complexity and robustness to network dynamics make it suitable for practical implementation
Recommended from our members
Two-phase flow dynamics in the gas diffusion layer of proton exchange membrane fuel cells: Volume of fluid modeling and comparison with experiment
This paper proposes a three-dimensional (3D) volume of fluid (VOF) study to investigate two-phase flow in the gas diffusion layer (GDL) of proton exchange membrane (PEM) fuel cells and liquid water distribution. A stochastic model was adopted to reconstruct the 3D microstructures of Toray carbon papers and incorporate the experimentally-determined varying porosity. The VOF predictions were compared with the water profiles obtained by the X-ray tomographic microscopy (XTM) and the Leverett correlation. It was found local water profiles are similar in the sample’s sub-regions under the pressure difference p = 1000 Pa between the two GDL surfaces, but may vary significantly under p = 6000 Pa. The water-air interfaces inside the GDL structure were presented to show water distribution and breakthrough
- …