Numerical study of the influences of geometry orientation on phase change material’s melting process

The acceleration of the melting process of phase change materials caused by buoyancy-driven natural convection has been widely acknowledged, especially for rectangular geometries. This acceleration phenomenon exists in the cases where phase change materials are heated at the bottom boundary or at both upper and bottom boundaries. This article reveals how the melting rate could be affected by changing the orientation of a rectangular phase change material container with a constant temperature boundary. The transient melting processes of lauric acid in a two-dimensional rectangular container with five orientations (θ = 0°, 22.5°, 45°, 67.5°, and 90°) were simulated using the computational fluid dynamics software. The computational fluid dynamics model was validated against available experimental data obtained from published literature. Results show that when the rectangular geometry is rotated from vertical direction (θ = 0°) to horizontal direction (θ = 90°), the total melting time is increased by about five times. For all investigated orientations, the heat transfer rate at the heated boundary is found to first increase at the initial stage (within about 100 min) and then decrease during the following melting process. Moreover, the total amount of thermal storage for the horizontally placed case is slightly lower than the other cases

A comparative study on microstructure and properties of traditional laser cladding and high-speed laser cladding of Ni45 alloy coatings

High-speed laser cladding technology can significantly improve the efficiency of coating preparation and effectively widen the application range of laser cladding. In this study, the Ni45 powders were deposited on steel substrate by traditional low speed laser cladding and high-speed laser cladding process, respectively. The cladding efficiency, surface forming, cross-sectional microstructure, microhardness, wear and corrosion resistance properties of the traditional and high-speed laser cladded Ni45 alloy coatings were compared. It can be seen that the thickness of the high-speed laser cladding coating was much thinner than that of the traditional laser cladding coating. Compared with traditional laser cladding, high-speed laser cladding could achieve a cladding speed of 76.86 m/min and a cladding efficiency of 156.79 cm2/min. The microstructure of the two kinds of coatings shows the same growth law, but the microstructure in high-speed laser cladding was smaller and denser, and the columnar crystal interval was narrower, only about 6 μm. It is found that the cooling rate of the traditional laser cladding coating was smaller than that of the high-speed laser cladding, and as the cladding speed increased, the cooling rate became higher and higher. The cross-section microhardness of the traditional laser cladding coating was relatively uniform of 337 HV0.2, while the microhardness of high-speed laser cladding surface increased to about 543 HV0.2. In addition, the wear and corrosion resistance of high-speed laser cladded coatings were better than that of traditional laser cladded coatings. As the cladding speed increased, the wear and corrosion resistance of the cladded coatings became better

Activation of Akt protects cancer cells from growth inhibition induced by PKM2 knockdown

BACKGROUND: PKM2 is an attractive target for cancer therapy, however, for many cancer cells, PKM2 knockdown only leads to a modest impairment of survival and proliferation. It is not known whether PKM2 knockdown rewires cell signaling pathways in these “PKM2 knockdown resistant” cells, and whether the rewired pathways are needed for their survival. FINDINGS: In present study, we investigated the effects of PKM2 knockdown on cellular signaling pathways in “PKM2 knockdown resistant” cancer cells. We found that knockdown of PKM2 leads to activation of Akt. Furthermore, we revealed that activation of Akt in PKM2 knockdown cells is a result of glycolysis disruption. Inhibiton of PI3K-Akt signaling pathway leads to significant growth inhibition and apoptosis in PKM2 knockdown cells. CONCLUSIONS: Overall, our results indicate that activation of Akt is necessary for the survival of PKM2 knockdown cells. Combing PKM2 knockdown with PI3K or Akt inhibitors may lead to a better chance to kill tumors. Our research may provide an unexpected opportunity for the development and implementation of drugs targeting cell metabolism and aberrant Akt signaling

Biological N fixation but not mineral N fertilization enhances the accumulation of N in peanut soil in maize/peanut intercropping system

Legume/cereal intercropping has the potential to maximize the use of resources to raise yields due to enhanced nitrogen (N) fixation by legume root nodules, while high N fertilization may inhibit the nodulation of legume. However, whether legume/cereal intercropping can promote the accumulation of soil N storage with N fertilization and its underlying mechanism are less clear. Here, we evaluated the long-term (5 years) effects of maize/peanut intercropping and mineral N fertilization on peanut soil total N content and soil N cycling functional genes. The experiment includes two planting patterns (peanut maize intercropping and peanut monocropping) with three N fertilization rates (0, 150, and 300 kg N ha−1). Intercropping increased soil total N content (STN) by average 18.2%, and the positive effect of intercropping on STN decreased with N application rate. Highest N application decreased the nodule fresh weight (NFW) by 64.3% and 46.0% in intercropping and monocropping system, respectively. However, intercropping has no effect on NFW. Intercropping increased the nifH gene abundance by average 26.5%. SEM analysis indicated that NFW and nifH gene abundance combined can explain 46% of the variance of STN. Our results indicate that biological N fixation but not mineral N fertilization enhances the accumulation of N in soil planted with peanut in maize/peanut intercropping system.info:eu-repo/semantics/publishedVersio

Association between the PDE4D gene and ischaemic stroke in the Chinese Han population

A B S T R A C T Recent findings suggests that PDE4D (gene encoding phosphodiesterase 4D) is a stroke-related gene in the Icelandic population, but it is still very controversial as to whether it is a susceptible gene for stroke in other populations. In the present study, we attempted to explore the role of the gene in the pathogenesis of stroke in the Chinese Han population of eastern China. A total of 649 ischaemic stroke patients and 761 unrelated control individuals with no history of stroke or transient ischaemic attack were examined in a case-control study. Four SNPs (single nucleotide polymorphisms) rs152312 (C/T), SNP56 (A/T), SNP83 (C/T) and SNP87 (C/T) with a minor allele frequency over 5 % were genotyped and the corresponding haplotypes were constructed. In an analysis of the combined cardiogenic and carotid stroke group, both the allele (P = 0.0060) and genotype (P = 0.0160) frequencies between cases and controls at SNP83 showed significant differences. However, no difference in haplotype frequencies was observed between cases and controls at rs152312 and SNP56. In the analysis of the small-artery-occlusive stroke group, no difference in allele or genotype frequencies was observed at any marker between cases and controls; the global haplotype frequency in rs152312 and SNP56 had a significant difference between cases and controls (P = 0.0162); the frequency of haplotype C-A was higher in cases than in controls (P = 0.0122). In conclusion, our present findings show that polymorphisms in the PDE4D gene are associated with an increased risk of ischaemic stroke in the Chinese Han population. The present study adds further support to the role of PDE4D in stroke

Exogenous hydrogen sulfide mitigates the fatty liver in obese mice through improving lipid metabolism and antioxidant potential

BACKGROUND: Nonalcoholic fatty liver disease (NAFLD) is the most common liver disease in the world. Hydrogen sulfide (H2S) plays an important role in physiology and pathophysiology of liver. However, whether exogenous H2S could mitigate the hepatic steatosis in mice remains unclear. The aim of this study is to evaluate the effects of H2S on fatty liver. METHODS: C57BL/6 mice were fed with either a high-fat diet (HFD) or a normal fat diet (NFD) for 16 weeks. After 12 weeks of feeding, the HFD-fed mice were injected one time per day with NaHS or saline for the followed 4 weeks. RESULTS: Compared to NFD, HFD could induce an accumulation of lipids in liver and a damage of hepatic structure. Compared to saline treatment, in the liver of HFD fed mice H2S treatment could significantly (1) recover the structure; (2) decrease the accumulation of lipids including triglyceride (TG) and total cholesterol (TC); (3) decrease the expression of fatty acid synthase (FAS) and increase the expression of carnitine palmitoyltransferase-1 (CPT-1); (4) reduce malondialdehyde (MDA) levels; (5) increase the activities of superoxide dismutase (SOD) and glutathione peroxidase (GPx). CONCLUSION: H2S could mitigate the fatty liver by improving lipid metabolism and antioxidant potential in HFD-induced obese mice