42,412 research outputs found
Determination of water content using mass spectrometry
Mass spectrometer is used to measure small quantities of water present in different materials. System has been applied in measuring water and gases desorbed from microcircuitry insulation, can also be used with foods, polymeric materials, and organic solvents
Dynamic delta method for trace gas analysis
Method has been developed in which measurements are made only over viscous flow range, eliminating fractionation before the molecular leak and problems due to surface elution
Inverting a Supernova: Neutrino Mixing, Temperatures and Binding Energy
We show that the temperatures of the emergent non-electron neutrinos and the
binding energy released by a galactic Type II supernova are determinable,
assuming the Large Mixing Angle (LMA) solution is correct, from observations at
the Sudbury Neutrino Observatory (SNO) and at Super-Kamiokande (SK). If the
neutrino mass hierarchy is inverted, either a lower or upper bound can be
placed on the neutrino mixing angle , and the hierarchy can be
deduced for adiabatic transitions. For the normal hierarchy, neither can
be constrained nor can the hierarchy be determined. Our
conclusions are qualitatively unchanged for the proposed Hyper-Kamiokande
detector.Comment: Following astro-ph/0208035, we adopt electron and non-electron
neutrino spectra with very small differences. Conclusions change
Phonon entropy of alloying and ordering of Cu-Au
Inelastic neutron scattering spectra were measured with a time-of-flight spectrometer on six disordered Cu-Au alloys at 300 K. The neutron-weighted phonon density of states was obtained from a conventional analysis of these spectra. Several methods were developed to account for this neutron weighting and obtain the phonon entropy of the disordered alloys. The phonon entropies of formation of disordered fcc Cu-Au alloys obtained in this way were generally mutually consistent, and were also consistent with predictions from a cluster approximation obtained from ab-initio calculations by Ozolin[underaccent cedilla [below] s-breve, Wolverton, and Zunger. We estimate a phonon entropy of disordering of 0.15±0.05kB/atom in Cu3Au at 300 K. A resonance mode associated with the motions of the heavy Au atoms in the Cu-rich alloys was observed at 9 meV. An analysis of the resonance mode provided a check on the partial phonon entropy of Au atoms
Correspondence between one- and two-equation models for solute\ud transport in two-region heterogeneous porous media
In this work, we study the transient behavior of upscaled models for solute transport in two-region porous media. We focus on the following three models: (1) a time non-local, two-equation model (2eq-nlt). This model does not rely on time constraints and, therefore, is particularly useful in the short-time regime, when the time scale of interest (t) is smaller than the characteristic time (T1) for the relaxation of the effective macroscale parameters (i.e., when t ≤ T1); (2) a time local, two-equation model (2eq). This model can be adopted when (t) is significantly larger than (T1) (i.e., when t » T1); and (3) a one-equation, time-asymptotic formulation (1eq∞). This model can be adopted when (t) is significantly larger than the time scale (T2) associated with exchange processes between the two regions (i.e., when t » T2). In order to obtain some physical insight into this transient behavior, we combine a theoretical approach based on the analysis of spatial moments with numerical and analytical results in simple cases. The main result of this paper is to show that there is weak long-time convergence of the solution of (2eq) toward the solution of (1eq∞) in terms of standardized moments but, interestingly, not in terms of centered moments. Physically, our interpretation of this result is that the spreading of the solute is dominating higher order non-zero perturbations in the asymptotic regime
Performance evaluation of a six-axis generalized force-reflecting teleoperator
Work in real-time distributed computation and control has culminated in a prototype force-reflecting telemanipulation system having a dissimilar master (cable-driven, force-reflecting hand controller) and a slave (PUMA 560 robot with custom controller), an extremely high sampling rate (1000 Hz), and a low loop computation delay (5 msec). In a series of experiments with this system and five trained test operators covering over 100 hours of teleoperation, performance was measured in a series of generic and application-driven tasks with and without force feedback, and with control shared between teleoperation and local sensor referenced control. Measurements defining task performance included 100-Hz recording of six-axis force/torque information from the slave manipulator wrist, task completion time, and visual observation of predefined task errors. The task consisted of high precision peg-in-hole insertion, electrical connectors, velcro attach-de-attach, and a twist-lock multi-pin connector. Each task was repeated three times under several operating conditions: normal bilateral telemanipulation, forward position control without force feedback, and shared control. In shared control, orientation was locally servo controlled to comply with applied torques, while translation was under operator control. All performance measures improved as capability was added along a spectrum of capabilities ranging from pure position control through force-reflecting teleoperation and shared control. Performance was optimal for the bare-handed operator
Marginal states of the resistive tearing mode with flow in cylindrical geometry
The linear stability of tearing modes in a cylindrical plasma subject to a sub-Alfvénic equilibrium shear flow along the equilibrium magnetic field is considered. The equations in the resistive boundary layer at the rational surface are solved numerically using a Fourier transform combined with a finite-element approach. The behaviour of the growth rate as a function of the flow and the various parameters (including a perpendicular fluid viscosity) is obtained. Marginal stability curves showing the dependence of the familiar matching parameter Δ' with flow and shear are also given
A Coronal Hole's Effects on CME Shock Morphology in the Inner Heliosphere
We use STEREO imagery to study the morphology of a shock driven by a fast
coronal mass ejection (CME) launched from the Sun on 2011 March 7. The source
region of the CME is located just to the east of a coronal hole. The CME ejecta
is deflected away from the hole, in contrast with the shock, which readily
expands into the fast outflow from the coronal hole. The result is a CME with
ejecta not well centered within the shock surrounding it. The shock shape
inferred from the imaging is compared with in situ data at 1 AU, where the
shock is observed near Earth by the Wind spacecraft, and at STEREO-A. Shock
normals computed from the in situ data are consistent with the shock morphology
inferred from imaging.Comment: to appear in The Astrophysical Journa
- …